Electric bicycles: motors, batteries and limits – Vehicles and Technology motor mechanics lesson
Lesson 28 of 50 in the Vehicles and Technology course (ages 14+)
US version. US spelling and words (tire, gasoline, hood) and US rules such as state inspections. · UK version
Find out how electric bicycles assist the rider, how battery capacity sets range, and how the CPSC defines a low-speed electric bicycle.
- Time
- 45 minutes + 10 min homework
- Course
- Vehicles and Technology (ages 14+)
- You need
- Paper, a pencil and this page. No tools and no vehicle
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches motor mechanics as a school subject. It is not a training program or a certification, and nothing here replaces an accredited automotive program, ASE certification or a qualified technician. Never work on a real vehicle without a qualified adult, the right protective equipment and safe equipment. High-voltage parts of electric and hybrid vehicles are for trained technicians only. Rules and values on this page are given as of November 2026. Always check the current official source (NHTSA and your own state’s rules) before relying on them.
How to use this lesson
All rule values here come from the CPSC as of November 2026; state and local rules vary, so check your state's official site. Please make sure e-bike batteries are charged only with their own charger. Every answer is graded straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Should e-bikes be allowed to go faster than they are now? What would be the benefits and the risks?”
- Later: the homework, then the practice test.
Watch out for
- Thinking an e-bike does all the work. Most e-bikes assist only while the rider pedals, and assistance stops at the legal speed.
- Thinking a bigger voltage alone means a bigger range. Range depends on stored energy, volts × amp-hours, and on how the bike is ridden.
- Thinking one US rule covers where every e-bike can be ridden. The CPSC defines the product; states and local governments decide where and how it may be ridden.
Hands-on: Find the label on an e-bike battery or in a store listing (with an adult) and write down the volts and amp-hours. Work out the watt-hours and estimate a range at 12 Wh per mile. Then make a poster of the CPSC definition: under 750 W, under 20 mph on motor alone. Look only – do not touch the battery, its charger or its connections.
What you will learn
- I can explain how pedal assist works using sensors and a controller.
- I can compare hub motors and mid-drive motors.
- I can calculate battery energy in watt-hours and estimate range.
- I can state the CPSC definition of a low-speed electric bicycle and explain that riding rules are set by states.
- I can explain why e-bike batteries must be charged and stored with care.
Key words
- pedal assist
- A system in which the motor helps only while the rider pedals.
- hub motor
- An electric motor built into the front or rear wheel hub.
- mid-drive
- A motor at the cranks that drives through the bicycle's chain and gears.
- watt-hour (Wh)
- A unit of stored energy: one watt for one hour. Battery Wh = volts × amp-hours.
- controller
- The electronics that decide how much power the motor gets.
- low-speed electric bicycle
- The CPSC term for an e-bike with working pedals, a motor under 750 W and a motor-only top speed under 20 mph.
The big ideas
An electric bicycle is a bicycle with a battery, an electric motor and a controller. Most help the rider only while they pedal: sensors tell the controller how fast or how hard the rider is pedaling, and the controller adds motor power to match. Riding feels like having a strong tailwind.
In the US, the CPSC bicycle requirements describe a low-speed electric bicycle (as of November 2026) as one with fully operable pedals, a motor of less than 750 W (1 hp), and a top speed on motor power alone of less than 20 mph with a 170-pound rider. Rules on where e-bikes may be ridden, rider ages and helmets are set by states and local governments.
The battery is usually a lithium-ion pack. It stores a lot of energy in a small space, so it must be charged with the right charger and kept away from damage. Work on e-bike batteries and electrics is for a qualified bicycle mechanic.
Read-through: the teaching steps
The parts
- Battery: usually lithium-ion, often 36 V, on the frame or rack
- Motor: in a wheel hub or at the cranks
- Controller: the electronics that set motor power
- Sensors: measure pedaling speed (cadence) or pedaling force (torque)
- Display: shows assist level, speed and battery charge
The electric vehicle drawing on the lesson page shows the same battery–controller–motor idea on a larger scale.
The main parts of a battery electric car. High-voltage parts (usually with orange cables) are for trained technicians only. Hub motor or mid-drive?
A hub motor sits in the front or rear wheel and drives it directly: simple and cheap, but it adds weight to the wheel and cannot use the bike's gears. A mid-drive motor sits at the cranks and drives through the chain, so it benefits from the gears on hills and keeps the weight low and central, though it wears the chain and sprockets faster.
Cadence and torque sensors
A cadence sensor notices that the pedals are turning and switches on assistance. A torque sensor measures how hard the rider pushes and adds power in proportion, which feels more natural. The controller cuts the assistance at the legal speed limit.
Battery energy and range
Battery energy (Wh) = voltage (V) × capacity (Ah)
A 36 V, 14 Ah battery stores 36 × 14 = 504 Wh. If riding uses about 12 Wh per mile with assistance, the range is about 504 ÷ 12 = 42 miles. Real range depends on hills, wind, rider weight, tire pressure and the assist level.
US definition and state rules
As of November 2026, the CPSC describes a low-speed electric bicycle as having:
- Fully operable pedals
- A motor of less than 750 W (1 hp)
- A top speed on motor power alone of less than 20 mph with a 170-pound rider
Where e-bikes may be ridden, and rules on age and helmets, are set by states and local governments, so riders check their own state's law.
Battery safety
Lithium-ion batteries store a lot of energy. A damaged, crushed or wet battery, or one charged with the wrong charger, can overheat and catch fire. Batteries are charged with the charger made for them, never left damaged, and never opened. Battery and wiring work is for a qualified bicycle mechanic.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 14 min | Not assessed, self-checked |
| Worked examples and guided practice | 9 min | Graded by Classfern |
| Independent practice (three levels) | 13 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Bicycles lessons · Vehicles and Technology course · All motor mechanics practice tests · Motor Mechanics Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by ASE, NHTSA, any state agency, any college, testing agency or exam board.