Tire pressure monitoring systems (TPMS) – Motor Vehicle Theory motor mechanics lesson
Lesson 87 of 131 in the Motor Vehicle Theory course (ages 16+)
US version. US spelling and words (tire, gasoline, hood) and US rules such as state inspections. · UK version
Find out how direct and indirect tire pressure monitoring systems detect a soft tire, what the warning lamp is telling the driver, and why pressures must still be checked by hand – with the gas law to show why.
- Time
- 45 minutes + 10 min homework
- Course
- Motor Vehicle Theory (ages 16+)
- You need
- Paper, a pencil and this page. No tools and no vehicle
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches motor mechanics as a school subject. It is not a training program or a certification, and nothing here replaces an accredited automotive program, ASE certification or a qualified technician. Never work on a real vehicle without a qualified adult, the right protective equipment and safe equipment. High-voltage parts of electric and hybrid vehicles are for trained technicians only. Rules and values on this page are given as of November 2026. Always check the current official source (NHTSA and your own state’s rules) before relying on them.
How to use this lesson
The calculations use the pressure law with temperatures in kelvin (°C + 273). Inflating tires and replacing TPMS sensors are jobs for trained fitters; this lesson explains how the systems work. Values are dated; check the official source before relying on them. Every answer is graded straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Indirect TPMS needs no sensors in the wheels, so it is cheaper, but it cannot spot all four tires going down together. Which system would you choose, and why?”
- Later: the homework, then the practice test.
Watch out for
- Thinking that if the TPMS lamp is off, the tires are at the right pressure. The system warns only when the loss is significant. A tire can be under-inflated without lighting the lamp, so regular cold checks are still needed.
- Checking or adjusting pressures straight after a long drive. Warm tires read high. Letting air out while warm leaves them under-inflated once they cool.
- Thinking an indirect system measures pressure. It measures wheel speed. It infers low pressure from a tire turning faster, so it cannot spot all four tires losing pressure equally.
Hands-on: Try the pressure law safely with a balloon: blow it up a little, tie it, and measure round its middle with a tape measure. Put it in a warm (not hot) place for 15 minutes, then in a fridge for 15 minutes, measuring each time. Explain the changes using the idea that warm air pushes harder. Do not inflate or deflate a real tire; that is for a trained fitter.
What you will learn
- I can explain why correct tire pressure matters for safety, wear and economy.
- I can describe how direct TPMS and indirect TPMS each detect low pressure.
- I can explain what the TPMS lamp means when it stays on, and when it shows a system fault.
- I can use the pressure law to show why pressures are checked cold.
- I can state when TPMS became required in the US and what NHTSA says it does and does not do.
Key words
- TPMS
- Tire pressure monitoring system: a system that warns the driver when a tire has lost pressure.
- direct TPMS
- A system with a pressure sensor and radio transmitter inside each wheel, usually built onto the valve.
- indirect TPMS
- A system with no pressure sensors. It uses the anti-lock brake wheel speed sensors to spot a tire that turns faster because it has lost pressure.
- rolling radius
- The distance from the center of the wheel to the road when the tire is carrying the car. A soft tire has a slightly smaller rolling radius.
- absolute pressure
- Pressure measured from a perfect vacuum. A tire gauge reads gauge pressure, which is absolute pressure minus the air pressure around us (about 101 kPa).
The big ideas
A tire can lose pressure slowly without the driver noticing. An under-inflated tire flexes more, heats up, wears its shoulders, uses more fuel and, in the worst case, can fail. A tire pressure monitoring system (TPMS) watches the tires and lights a warning lamp on the dashboard when one has lost pressure.
There are two kinds. A direct system has a small sensor inside each wheel that measures the pressure and sends it by radio to the car. An indirect system has no sensors in the wheels: it uses the anti-lock brake wheel speed sensors to spot a tire that is turning slightly faster than the others because it has gone soft.
TPMS is a warning, not a replacement for checking the tires. It warns only when the loss is significant, so drivers are still advised to check pressures regularly, with the tires cold. Inflating tires and working on TPMS sensors is for trained fitters and technicians.
Read-through: the teaching steps
Why pressure matters
The vehicle maker chooses the pressure for the car's load and speed. If a tire is under-inflated:
- the sidewalls flex more and the tire runs hotter;
- the shoulders wear faster;
- rolling resistance rises, so more fuel is used;
- braking and steering are affected.
Over-inflation is a problem too: a smaller contact patch, less grip and a worn center.
Direct TPMS
A direct system has a sensor in each wheel, usually built onto the inside of the valve. It contains a pressure sensor, often a temperature sensor, a small battery and a radio transmitter. It sends its readings to a receiver in the car every so often, and more often when the pressure changes.
Many cars can show the pressure of each tire on the dashboard. The sensor batteries are sealed in and last several years; when they run down the sensor is replaced, which is work for a tire fitter.
Indirect TPMS
An indirect system uses the wheel speed sensors already fitted for the anti-lock brakes. When a tire loses pressure, it squashes slightly, so its rolling radius shrinks and it turns a little faster than the others to cover the same distance.
The control unit compares the wheel speeds. If one wheel keeps turning faster than it should, the lamp lights. Indirect systems must be reset (calibrated) after the pressures are set, and they cannot spot all four tires losing pressure at the same rate, because the speeds would still match.
Checking pressure cold
Air in a tire warms up as the tire flexes when driven. Warm air pushes harder. For a fixed amount of air in a fixed volume, absolute pressure is proportional to absolute temperature (in kelvin):
p₁ ÷ T₁ = p₂ ÷ T₂
So a tire checked warm reads higher than it really is when cold, and might be wrongly let down. This is why pressures are checked when the tires are cold.
Reading the lamp
The TPMS lamp normally lights briefly when the ignition is switched on, as a bulb check, and then goes out. A steady light means a tire is significantly underinflated, and the driver should stop safely and check.
NHTSA says that if the light flashes for 60 to 90 seconds and then stays on, the system itself is malfunctioning and the driver should contact a dealer.
TPMS rules in the US
NHTSA says TPMS is required on all passenger cars, light trucks and vans from model year 2008. It warns only when a tire is significantly underinflated, so it does not replace the monthly check.
NHTSA says to check all tires, including the spare, at least once a month, when they are cold – meaning the car has not been driven for at least three hours – using the pressure on the Tire and Loading Information Label or in the owner's manual.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 14 min | Not assessed, self-checked |
| Worked examples and guided practice | 9 min | Graded by Classfern |
| Independent practice (three levels) | 13 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Wheels and tires lessons · Motor Vehicle Theory course · All motor mechanics practice tests · Motor Mechanics Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by ASE, NHTSA, any state agency, any college, testing agency or exam board.