▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Maths, Cookery, Programming and Art are open – explore →

Tyre pressure monitoring systems (TPMS) – Motor Vehicle Theory motor mechanics lesson

Lesson 87 of 131 in the Motor Vehicle Theory course (ages 16+)

UK version. UK spelling and words (tyre, petrol, bonnet) and UK rules such as the MOT. · US version

Find out how direct and indirect tyre pressure monitoring systems detect a soft tyre, what the warning lamp is telling the driver, and why pressures must still be checked by hand – with the gas law to show why.

Time
45 minutes + 10 min homework
Course
Motor Vehicle Theory (ages 16+)
You need
Paper, a pencil and this page. No tools and no vehicle
Marked
Instantly, with explanations

Education and interest only. Classfern teaches motor mechanics as a school subject. It is not a training course or a qualification, and nothing here replaces an IMI or City & Guilds course, an apprenticeship or a qualified technician. Never work on a real vehicle without a qualified adult, the right protective equipment and safe equipment. High-voltage parts of electric and hybrid vehicles are for trained technicians only. Rules and values on this page are given as of November 2026. Always check the current official source (GOV.UK and the DVSA MOT inspection manual) before relying on them.

How to use this lesson

The calculations use the pressure law with temperatures in kelvin (°C + 273). Inflating tyres and replacing TPMS sensors are jobs for trained fitters; this lesson explains how the systems work. Values are dated; check the official source before relying on them. Every answer is marked straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “Indirect TPMS needs no sensors in the wheels, so it is cheaper, but it cannot spot all four tyres going down together. Which system would you choose, and why?”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking that if the TPMS lamp is off, the tyres are at the right pressure. The system warns only when the loss is significant. A tyre can be under-inflated without lighting the lamp, so regular cold checks are still needed.
  • Checking or adjusting pressures straight after a long drive. Warm tyres read high. Letting air out while warm leaves them under-inflated once they cool.
  • Thinking an indirect system measures pressure. It measures wheel speed. It infers low pressure from a tyre turning faster, so it cannot spot all four tyres losing pressure equally.

Hands-on: Try the pressure law safely with a balloon: blow it up a little, tie it, and measure round its middle with a tape measure. Put it in a warm (not hot) place for 15 minutes, then in a fridge for 15 minutes, measuring each time. Explain the changes using the idea that warm air pushes harder. Do not inflate or deflate a real tyre; that is for a trained fitter.

What you will learn

  • I can explain why correct tyre pressure matters for safety, wear and economy.
  • I can describe how direct TPMS and indirect TPMS each detect low pressure.
  • I can explain what the TPMS lamp means when it stays on, and when it shows a system fault.
  • I can use the pressure law to show why pressures are checked cold.
  • I can state the MOT rule for TPMS.

Key words

TPMS
Tyre pressure monitoring system: a system that warns the driver when a tyre has lost pressure.
direct TPMS
A system with a pressure sensor and radio transmitter inside each wheel, usually built onto the valve.
indirect TPMS
A system with no pressure sensors. It uses the anti-lock brake wheel speed sensors to spot a tyre that turns faster because it has lost pressure.
rolling radius
The distance from the centre of the wheel to the road when the tyre is carrying the car. A soft tyre has a slightly smaller rolling radius.
absolute pressure
Pressure measured from a perfect vacuum. A tyre gauge reads gauge pressure, which is absolute pressure minus the air pressure around us (about 101 kPa).

The big ideas

A tyre can lose pressure slowly without the driver noticing. An under-inflated tyre flexes more, heats up, wears its shoulders, uses more fuel and, in the worst case, can fail. A tyre pressure monitoring system (TPMS) watches the tyres and lights a warning lamp on the dashboard when one has lost pressure.

There are two kinds. A direct system has a small sensor inside each wheel that measures the pressure and sends it by radio to the car. An indirect system has no sensors in the wheels: it uses the anti-lock brake wheel speed sensors to spot a tyre that is turning slightly faster than the others because it has gone soft.

TPMS is a warning, not a replacement for checking the tyres. It warns only when the loss is significant, so drivers are still advised to check pressures regularly, with the tyres cold. Inflating tyres and working on TPMS sensors is for trained fitters and technicians.

Read-through: the teaching steps

  1. Why pressure matters

    The vehicle maker chooses the pressure for the car's load and speed. If a tyre is under-inflated:

    • the sidewalls flex more and the tyre runs hotter;
    • the shoulders wear faster;
    • rolling resistance rises, so more fuel is used;
    • braking and steering are affected.

    Over-inflation is a problem too: a smaller contact patch, less grip and a worn centre.

  2. Direct TPMS

    A direct system has a sensor in each wheel, usually built onto the inside of the valve. It contains a pressure sensor, often a temperature sensor, a small battery and a radio transmitter. It sends its readings to a receiver in the car every so often, and more often when the pressure changes.

    Many cars can show the pressure of each tyre on the dashboard. The sensor batteries are sealed in and last several years; when they run down the sensor is replaced, which is work for a tyre fitter.

  3. Indirect TPMS

    An indirect system uses the wheel speed sensors already fitted for the anti-lock brakes. When a tyre loses pressure, it squashes slightly, so its rolling radius shrinks and it turns a little faster than the others to cover the same distance.

    The control unit compares the wheel speeds. If one wheel keeps turning faster than it should, the lamp lights. Indirect systems must be reset (calibrated) after the pressures are set, and they cannot spot all four tyres losing pressure at the same rate, because the speeds would still match.

  4. Checking pressure cold

    Air in a tyre warms up as the tyre flexes when driven. Warm air pushes harder. For a fixed amount of air in a fixed volume, absolute pressure is proportional to absolute temperature (in kelvin):

    p₁ ÷ T₁ = p₂ ÷ T₂

    So a tyre checked warm reads higher than it really is when cold, and might be wrongly let down. This is why pressures are checked when the tyres are cold.

  5. Reading the lamp

    The TPMS lamp normally lights briefly when the ignition is switched on, as a bulb check, and then goes out. If it stays on, a tyre has lost pressure, and the driver should stop safely and check.

    If the system itself has a fault – a dead sensor battery, for example – the lamp shows it. The driver should then have the system checked, because it can no longer warn of low pressure.

  6. TPMS and the MOT

    The MOT TPMS check applies to passenger cars (category M1) first used on or after 1 January 2012. A system that is malfunctioning or obviously not working is a major defect. A lamp that stays on because a tyre is low, with the system working, is not by itself a fault in the system. Separately, a tyre that is obviously under-inflated is a minor defect.

    The Highway Code advises checking tyre pressures weekly, before a journey, when the tyres are cold.

The lesson, step by step

45 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minMarked by Classfern
Teaching and hands-on task14 minNot assessed, self-checked
Worked examples and guided practice9 minMarked by Classfern
Independent practice (three levels)13 minMarked by Classfern
Exit ticket and talk question5 minMarked by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all marked instantly.

More practice

More Wheels and tyres lessons · Motor Vehicle Theory course · All motor mechanics practice tests · Motor Mechanics Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the DVSA, the IMI, City & Guilds, any college, testing agency or exam board.