Tread depth and when to replace a tire – Garage Basics motor mechanics lesson
Lesson 44 of 70 in the Garage Basics course (ages 11–16)
US version. US spelling and words (tire, gasoline, hood) and US rules such as state inspections. · UK version
Find out why tire tread matters, when NHTSA says a tire should be replaced, how the penny test works, and how to convert 32nds of an inch.
- Time
- 40 minutes + 10 min homework
- Course
- Garage Basics (ages 11–16)
- You need
- Paper, a pencil and this page. No tools and no vehicle
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches motor mechanics as a school subject. It is not a training program or a certification, and nothing here replaces an accredited automotive program, ASE certification or a qualified technician. Never work on a real vehicle without a qualified adult, the right protective equipment and safe equipment. High-voltage parts of electric and hybrid vehicles are for trained technicians only.
For parents: how to use this lesson
Please do the penny test yourself while your child watches. Keep the car parked and switched off. The 2/32 inch figure comes from NHTSA; legal limits are set by each state. Every answer is graded straight away with a worked explanation.
- Read what your child will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Why do you think worn tires are much more dangerous on a wet road than on a dry one?”
- Later: the homework, then the practice test.
Watch out for
- Thinking a tire is fine until it is completely bald. NHTSA says to replace tires at 2/32 inch of tread, long before they are bald.
- Checking tread in only one place. Tires can wear unevenly, so check several grooves around the tire.
- Thinking tread limits are the same in every state. Legal limits and inspection rules are set by each state.
Hands-on: Cut a piece of thick card into a "tire" and draw a tread pattern. Then, with an adult, look at the tires of a parked, switched-off car: find the small tread wear bars in the grooves. Watch the adult do the penny test in three places around one tire, keeping fingers clear if the tire could be hot.
What your child will learn
- I can explain how tread grooves help a tire grip on a wet road.
- I can state the tread depth at which NHTSA says to replace a tire.
- I can explain how the penny test works.
- I can convert between 32nds of an inch and millimeters, and work out usable tread.
Key words
- tread
- The patterned outer surface of a tire that touches the road.
- groove
- A channel in the tread that carries water away from under the tire.
- aquaplaning
- When a layer of water builds up under the tire so it rides on the water and loses grip. In the US it is usually called hydroplaning.
- tread depth gauge
- A small measuring tool with a probe that measures how deep the grooves are.
- tread wear bar
- Small raised bars across the bottom of the main grooves. When the tread wears down level with them, the tire is at or near its limit.
The big ideas
Tread is the patterned rubber on the outside of a tire. On a dry road, a smooth tire grips well. On a wet road the grooves matter: they act like channels, squeezing water out from under the tire so the rubber can touch the road. As tread wears, the grooves get shallower and can carry less water. At speed, water can build up under the tire so it rides on a film of water: hydroplaning. Steering and braking then almost stop working.
NHTSA says tires should be replaced when the tread is worn down to 2/32 of an inch. A quick check is the penny test: put a penny into a groove with Lincoln's head upside down. If you can see the top of his head, the tread is worn and the tire should be replaced. Legal tread limits and inspection rules are set by each state, so they differ from state to state.
Many tires also have tread wear bars: small bars in the grooves that show when the tread is near the limit. NHTSA also notes that some manufacturers recommend replacing tires that are 6–10 years old regardless of tread. Tire fitting is done by trained technicians.
Read-through: the teaching steps
What tread does
On a wet road, the grooves carry water out from under the tire so the rubber can press on the road. Deep grooves can carry a lot of water; shallow grooves carry little. That is why worn tires grip much less in the wet and make stopping distances longer.
Tread depth is measured in the grooves. NHTSA says a tire should be replaced when the tread is worn down to 2/32 of an inch. Aquaplaning
If more water arrives than the grooves can carry away, a wedge of water lifts the tire off the road. This is called hydroplaning. The car can no longer be steered or braked properly. Higher speed, deeper water and less tread all make it more likely.
When NHTSA says to replace a tire
NHTSA says to replace tires when the tread is worn to 2/32 of an inch. In millimeters that is 2 ÷ 32 × 25.4 = about 1.6 mm. State laws set the legal limits, which vary between states.
The penny test
Insert a penny into a main groove with Lincoln's head upside down and facing you. If you can see the top of his head, the tread is at or below 2/32 inch and the tire should be replaced. Checking in several places matters, because tires do not always wear evenly.
Measuring tread
A tread depth gauge has a probe that slides into the groove and shows the depth, often in 32nds of an inch. Tread wear bars, small bars molded across the bottom of the main grooves, show when the tread is worn to 2/32 inch.
Usable tread
A new car tire typically has around 10/32 inch of tread. Only the tread above 2/32 is usable: 10/32 − 2/32 = 8/32 inch. If a tire wears 1/32 inch for every so many miles, you can estimate how long it will last.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 12 min | Not assessed, self-checked |
| Worked examples and guided practice | 8 min | Graded by Classfern |
| Independent practice (three levels) | 11 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Wheels and tires lessons · Garage Basics course · All motor mechanics practice tests · Motor Mechanics Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by ASE, NHTSA, any state agency, any college, testing agency or exam board.