The airspeed indicator: IAS, CAS, TAS and the color arcs – Private Pilot Theory aviation lesson
Lesson 163 of 228 in the Private Pilot Theory course (ages 16+)
US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version
Learn what each color arc and line on the airspeed indicator means, the difference between indicated, calibrated and true airspeed, and how to estimate TAS.
- Time
- 45 minutes + 10 min homework
- Course
- Private Pilot Theory (ages 16+)
- You need
- Paper, a pencil and this page
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test. Rules and values on this page are given as of November 2026. Always check the current official source (the FAA) before relying on them.
How to use this lesson
This is adult-level theory (16+). Read it alongside the official handbooks; it is explanation for understanding, not training. Every answer is graded straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Why might it be safer for the airspeed indicator to show indicated airspeed rather than true airspeed?”
- Later: the homework, then the practice test.
Watch out for
- Thinking the top of the green arc is the never-exceed speed. The top of the green arc is VNO; VNE is the red line.
- Thinking VA is marked on the ASI. VA, VX and VY are not marked; they are in the manual or on placards.
- Thinking TAS is lower than IAS at altitude. In thinner air TAS is higher than IAS – about 2 % per 1,000 ft.
Hands-on: Draw an airspeed indicator dial on paper. Using the numbers from worked example 2, color the white, green and yellow arcs and the red line. Label each end with its V-speed.
What you will learn
- I can name the color markings on the ASI and their limits.
- I can define IAS, CAS, TAS and groundspeed.
- I can estimate TAS using the 2 % per 1,000 ft rule of thumb.
- I can name speeds that are not marked on the ASI.
- I can explain why TAS is higher than IAS at altitude.
Key words
- IAS
- Indicated airspeed – the direct reading of the ASI.
- CAS
- Calibrated airspeed – IAS corrected for installation and instrument error.
- TAS
- True airspeed – CAS corrected for altitude and non-standard temperature.
- VNE
- Never-exceed speed – the red line.
- VNO
- Maximum structural cruising speed – the top of the green arc.
The big ideas
The PHAK (chapter 8) describes the markings on a light airplane's airspeed indicator. The white arc is the flap operating range, from VS0 (stall speed in the landing configuration) to VFE (maximum flap-extended speed). The green arc is the normal operating range, from VS1 to VNO, the maximum structural cruising speed. The yellow arc is the caution range, to be flown only in smooth air. The red line is VNE, the never-exceed speed.
The handbook also defines the types of airspeed. Indicated airspeed (IAS) is the direct reading. Calibrated airspeed (CAS) corrects IAS for installation and instrument error. True airspeed (TAS) corrects CAS for altitude and nonstandard temperature; a rule of thumb is to add 2 % to CAS per 1,000 ft. Groundspeed is TAS adjusted for wind.
Some important speeds are not shown on the dial – for example design maneuvering speed (VA), VX and VY – and are found on placards or in the flight manual. This is theory for understanding only.
Read-through: the teaching steps
The white arc
Flap operating range. Bottom: VS0, the stall speed in the landing configuration. Top: VFE, the maximum flap-extended speed.
The “six-pack”: the six basic flight instruments in their usual layout. The green arc
Normal operating range. Bottom: VS1, stall speed in a specified configuration (typically clean). Top: VNO, maximum structural cruising speed.
Yellow arc and red line
- Yellow arc: caution range – smooth air only, with caution.
- Red line: VNE, the never-exceed speed.
Speeds not on the dial
VA (design maneuvering speed), VX, VY and others are given on placards or in the flight manual, not as arcs.
IAS → CAS → TAS → groundspeed
- IAS: what the needle shows.
- CAS: IAS corrected for installation and instrument error.
- TAS: CAS corrected for altitude and temperature.
- Groundspeed: TAS corrected for wind.
Estimating TAS
Rule of thumb from the handbook: add 2 % of CAS for every 1,000 ft.
TAS ≈ CAS × (1 + 0.02 × altitude in thousands of feet)
Example: CAS 100 kt at 5,000 ft → 100 × 1.10 = 110 kt.
Try it: the airspeed indicator
Move the controls and watch the instruments, then try reading them.
Try the real thing: FAA Pilot’s Handbook of Aeronautical Knowledge, chapter 8: flight instruments (free PDF) (opens in a new tab).
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 14 min | Not assessed, self-checked |
| Worked examples and guided practice | 9 min | Graded by Classfern |
| Independent practice (three levels) | 13 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Aircraft General Knowledge lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.