▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Maths, Cookery, Programming and Art are open – explore →

Voltage, current and resistance in a car – Garage Basics motor mechanics lesson

Lesson 34 of 70 in the Garage Basics course (ages 11–16)

UK version. UK spelling and words (tyre, petrol, bonnet) and UK rules such as the MOT. · US version

Find out what voltage, current and resistance mean, how a car's 12-volt system uses its metal body to complete circuits, and calculate electrical power.

Time
40 minutes + 10 min homework
Course
Garage Basics (ages 11–16)
You need
Paper, a pencil and this page. No tools and no vehicle
Marked
Instantly, with explanations

Education and interest only. Classfern teaches motor mechanics as a school subject. It is not a training course or a qualification, and nothing here replaces an IMI or City & Guilds course, an apprenticeship or a qualified technician. Never work on a real vehicle without a qualified adult, the right protective equipment and safe equipment. High-voltage parts of electric and hybrid vehicles are for trained technicians only.

For parents: how to use this lesson

Use only small AA batteries for the activity. Car batteries can give dangerous currents, and the high-voltage system of electric and hybrid cars is for trained technicians only. Every answer is marked straight away with a worked explanation.

  1. Read what your child will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “Why do you think car makers use orange for high-voltage cables?”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking current is used up as it goes round the circuit. The same current flows all the way round a simple loop. It is energy that is transferred to the parts, not current.
  • Mixing up voltage and current. Voltage is the push (volts); current is the flow (amps).
  • Thinking a 12-volt battery cannot be dangerous at all. It is safe to touch the terminals with dry hands, but a short circuit can make huge currents, heat and sparks. Battery work is for adults and technicians only.

Hands-on: Make a circuit from a 1.5 V AA battery in a holder, a small torch bulb in a holder and two wires with crocodile clips, with an adult. Light the bulb, then add a long thin piece of pencil lead (graphite) into the loop and see the bulb dim as the resistance goes up. Never use mains electricity or a car battery for this.

What your child will learn

  • I can explain voltage, current and resistance in my own words.
  • I can give the units of voltage, current, resistance and power.
  • I can explain how a car uses its metal body as the earth return.
  • I can calculate power using power = voltage × current.
  • I can explain why the high-voltage system of an electric car is for trained technicians only.

Key words

voltage
The electrical push that drives current round a circuit, measured in volts (V).
current
The flow of electric charge round a circuit, measured in amperes or amps (A).
resistance
How much a part opposes the flow of current, measured in ohms (Ω).
earth
The return path for current to the battery, through the car's metal body. In the US it is called ground.
power
How fast electrical energy is transferred, measured in watts (W): power = voltage × current.

The big ideas

A car is full of electrical circuits: lights, wipers, the radio, sensors, the starter motor and the engine's control unit. Most cars run these from a 12-volt battery, kept charged by the alternator. To understand any of them, you need three ideas: voltage, current and resistance.

Voltage is the push. Current is the flow. Resistance is how hard the flow is opposed. A useful picture is water in pipes: voltage is like the water pressure, current like the amount of water flowing each second, and resistance like a narrow section of pipe. More push gives more flow; more resistance gives less.

A circuit must be a complete loop. In a car, a wire carries current from the battery to each part, and the current comes back through the metal body, which is connected to the battery's negative terminal. This is called the earth return, and it halves the amount of wire needed. Electric and hybrid cars also have a high-voltage system, up to 650 V DC according to HSE, with cables usually coloured orange. It can kill, and is for trained technicians only: look, never touch.

Read-through: the teaching steps

  1. Voltage: the push

    Voltage is measured in volts (V). A car battery gives about 12 V, and a little over 12.5 V when fully charged and resting. With the engine running, the alternator raises it to about 14 V so the battery charges.

    +12 VBatteryFuseSwitchLampReturn through the body (earth)
    A simple lighting circuit. On a car the metal body is the return path (earth).
  2. Current: the flow

    Current is measured in amps (A). Small parts take tiny currents (a sensor might take a few milliamps, mA; 1,000 mA = 1 A). Headlights take a few amps. The starter motor can take well over 100 A for a few seconds.

  3. Resistance: the opposition

    Resistance is measured in ohms (Ω). Thin, long wires have more resistance than thick, short ones. A bulb filament has resistance and gets so hot it glows. Thick cables are used for big currents so they do not overheat.

  4. The earth return

    Each part has a feed wire from the positive (+) side of the battery. The current returns through the car's metal body, which is joined to the negative (−) terminal by a thick earth strap. A loose or corroded earth connection is a common cause of electrical faults.

  5. Power = voltage × current

    Electrical power in watts:

    power (W) = voltage (V) × current (A)

    so current = power ÷ voltage. A 60 W headlight bulb on 12 V takes 60 ÷ 12 = 5 A.

  6. High voltage: look, never touch

    The traction battery of an electric or hybrid car works at hundreds of volts. HSE says contact with live parts above 110 V DC can be fatal even when dry, and that voltage can remain after the car is switched off. Orange cables mark the high-voltage system. Only technicians with vehicle-specific training work on it.

The lesson, step by step

40 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minMarked by Classfern
Teaching and hands-on task12 minNot assessed, self-checked
Worked examples and guided practice8 minMarked by Classfern
Independent practice (three levels)11 minMarked by Classfern
Exit ticket and talk question5 minMarked by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all marked instantly.

More practice

More Electricity in the car lessons · Garage Basics course · All motor mechanics practice tests · Motor Mechanics Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the DVSA, the IMI, City & Guilds, any college, testing agency or exam board.