Voltage, current and resistance in a car – Garage Basics motor mechanics lesson
Lesson 34 of 70 in the Garage Basics course (ages 11–16)
US version. US spelling and words (tire, gasoline, hood) and US rules such as state inspections. · UK version
Find out what voltage, current and resistance mean, how a car's 12-volt system uses its metal body to complete circuits, and calculate electrical power.
- Time
- 40 minutes + 10 min homework
- Course
- Garage Basics (ages 11–16)
- You need
- Paper, a pencil and this page. No tools and no vehicle
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches motor mechanics as a school subject. It is not a training program or a certification, and nothing here replaces an accredited automotive program, ASE certification or a qualified technician. Never work on a real vehicle without a qualified adult, the right protective equipment and safe equipment. High-voltage parts of electric and hybrid vehicles are for trained technicians only.
For parents: how to use this lesson
Use only small AA batteries for the activity. Car batteries can give dangerous currents, and the high-voltage system of electric and hybrid cars is for trained technicians only. Every answer is graded straight away with a worked explanation.
- Read what your child will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Why do you think car makers use orange for high-voltage cables?”
- Later: the homework, then the practice test.
Watch out for
- Thinking current is used up as it goes round the circuit. The same current flows all the way round a simple loop. It is energy that is transferred to the parts, not current.
- Mixing up voltage and current. Voltage is the push (volts); current is the flow (amps).
- Thinking a 12-volt battery cannot be dangerous at all. It is safe to touch the terminals with dry hands, but a short circuit can make huge currents, heat and sparks. Battery work is for adults and technicians only.
Hands-on: Make a circuit from a 1.5 V AA battery in a holder, a small flashlight bulb in a holder and two wires with crocodile clips, with an adult. Light the bulb, then add a long thin piece of pencil lead (graphite) into the loop and see the bulb dim as the resistance goes up. Never use mains electricity or a car battery for this.
What your child will learn
- I can explain voltage, current and resistance in my own words.
- I can give the units of voltage, current, resistance and power.
- I can explain how a car uses its metal body as the ground return.
- I can calculate power using power = voltage × current.
- I can explain why the high-voltage system of an electric car is for trained technicians only.
Key words
- voltage
- The electrical push that drives current round a circuit, measured in volts (V).
- current
- The flow of electric charge round a circuit, measured in amperes or amps (A).
- resistance
- How much a part opposes the flow of current, measured in ohms (Ω).
- ground
- The return path for current to the battery, through the car's metal body. In the UK it is called earth.
- power
- How fast electrical energy is transferred, measured in watts (W): power = voltage × current.
The big ideas
A car is full of electrical circuits: lights, wipers, the radio, sensors, the starter motor and the engine's control unit. Most cars run these from a 12-volt battery, kept charged by the alternator. To understand any of them, you need three ideas: voltage, current and resistance.
Voltage is the push. Current is the flow. Resistance is how hard the flow is opposed. A useful picture is water in pipes: voltage is like the water pressure, current like the amount of water flowing each second, and resistance like a narrow section of pipe. More push gives more flow; more resistance gives less.
A circuit must be a complete loop. In a car, a wire carries current from the battery to each part, and the current comes back through the metal body, which is connected to the battery's negative terminal. This is called the ground return, and it halves the amount of wire needed. Electric and hybrid cars also have a high-voltage system, up to 650 V DC according to the UK safety regulator HSE, with cables usually colored orange. It can kill, and is for trained technicians only: look, never touch.
Read-through: the teaching steps
Voltage: the push
Voltage is measured in volts (V). A car battery gives about 12 V, and a little over 12.5 V when fully charged and resting. With the engine running, the alternator raises it to about 14 V so the battery charges.
A simple lighting circuit. On a car the metal body is the return path (ground). Current: the flow
Current is measured in amps (A). Small parts take tiny currents (a sensor might take a few milliamps, mA; 1,000 mA = 1 A). Headlights take a few amps. The starter motor can take well over 100 A for a few seconds.
Resistance: the opposition
Resistance is measured in ohms (Ω). Thin, long wires have more resistance than thick, short ones. A bulb filament has resistance and gets so hot it glows. Thick cables are used for big currents so they do not overheat.
The ground return
Each part has a feed wire from the positive (+) side of the battery. The current returns through the car's metal body, which is joined to the negative (−) terminal by a thick ground strap. A loose or corroded ground connection is a common cause of electrical faults.
Power = voltage × current
Electrical power in watts:
power (W) = voltage (V) × current (A)
so current = power ÷ voltage. A 60 W headlight bulb on 12 V takes 60 ÷ 12 = 5 A.
High voltage: look, never touch
The traction battery of an electric or hybrid car works at hundreds of volts. HSE says contact with live parts above 110 V DC can be fatal even when dry, and that voltage can remain after the car is switched off. Orange cables mark the high-voltage system. Only technicians with vehicle-specific training work on it.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 12 min | Not assessed, self-checked |
| Worked examples and guided practice | 8 min | Graded by Classfern |
| Independent practice (three levels) | 11 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Electricity in the car lessons · Garage Basics course · All motor mechanics practice tests · Motor Mechanics Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by ASE, NHTSA, any state agency, any college, testing agency or exam board.