▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Math, Cookery, Programming and Art are open – explore →

The air-conditioning cycle – Motor Vehicle Theory motor mechanics lesson

Lesson 105 of 131 in the Motor Vehicle Theory course (ages 16+)

US version. US spelling and words (tire, gasoline, hood) and US rules such as state inspections. · UK version

Find out how a vehicle air-conditioning system moves heat out of the cabin by making a refrigerant boil and condense, and what each of the five main parts does.

Time
45 minutes + 10 min homework
Course
Motor Vehicle Theory (ages 16+)
You need
Paper, a pencil and this page. No tools and no vehicle
Graded
Instantly, with explanations

Education and interest only. Classfern teaches motor mechanics as a school subject. It is not a training program or a certification, and nothing here replaces an accredited automotive program, ASE certification or a qualified technician. Never work on a real vehicle without a qualified adult, the right protective equipment and safe equipment. High-voltage parts of electric and hybrid vehicles are for trained technicians only. Rules and values on this page are given as of November 2026. Always check the current official source (NHTSA and your own state’s rules) before relying on them.

How to use this lesson

This lesson explains the refrigeration cycle using GCSE/A level ideas about pressure, boiling and energy. Refrigerant work is restricted by law to qualified, certified technicians; the activity uses only water and paper. Every answer is graded straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “An air-conditioning system can also run backward as a heat pump to heat an electric car. What would have to change in the circuit for heat to flow into the cabin instead of out?”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking air conditioning creates cold. It moves heat from the cabin air to the outside air. Cold is just less heat.
  • Thinking the condenser is part of the cooling inside the car. The condenser is at the front of the vehicle and gets hot: it is where the heat leaves the system.
  • Thinking a puddle of water under the car after using air conditioning is a leak. Clear water dripping from the evaporator drain is normal: it is moisture removed from the cabin air.

Hands-on: Feel evaporation at work: wet the back of one hand with water (or a drop of hand gel) and blow gently across both hands. The wet hand feels colder because evaporation takes heat from your skin. Then draw the air-conditioning circuit with the five main parts, color the high side red and the low side blue, and label where heat goes in and where it comes out. No work on any vehicle.

What you will learn

  • I can name the main parts of an air-conditioning system and put them in order round the circuit.
  • I can explain how evaporation absorbs heat and condensation releases it.
  • I can describe the high-pressure and low-pressure sides of the system.
  • I can calculate the coefficient of performance and explain why refrigerant work is only for certified technicians.

Key words

refrigerant
The working fluid that circulates in the system, boiling in the evaporator and condensing in the condenser.
compressor
The pump that squeezes refrigerant vapor to high pressure and temperature. It divides the high side from the low side.
condenser
A radiator at the front of the vehicle where hot, high-pressure refrigerant gives out heat and turns to liquid.
expansion device
An expansion valve or orifice tube that lets high-pressure liquid into the low-pressure side, so it can boil.
evaporator
A small radiator in the heater box where the refrigerant boils, absorbing heat from the cabin air.

The big ideas

Air conditioning does not make "cold". It moves heat: it takes heat out of the air going into the cabin and dumps it outside the vehicle. It does this with a refrigerant that is made to boil at a low temperature inside the car and condense at a high temperature outside.

The idea is the same as sweat cooling your skin. When a liquid evaporates, it absorbs heat from whatever it touches. When the vapor condenses back into liquid, it gives that heat out again. By changing the refrigerant's pressure, the system controls where it boils and where it condenses.

The refrigerant is kept in a sealed circuit under pressure. Under Section 609 of the Clean Air Act, EPA requires technicians who service vehicle air conditioning to be trained and certified. This lesson explains how the cycle works; nothing in it is a guide to working on a system.

Read-through: the teaching steps

  1. Pressure and boiling point

    The temperature at which a liquid boils depends on pressure. Water boils at 100 °C at sea level but at a lower temperature on a high mountain, and at a higher temperature in a pressure cooker.

    An air-conditioning refrigerant boils at a very low temperature at low pressure – well below freezing. At high pressure its boiling (and condensing) point is well above the outside air temperature. So:

    • at low pressure in the evaporator it boils, taking in heat from warm cabin air;
    • at high pressure in the condenser it condenses, giving out heat to the outside air.
  2. Round the circuit

    Follow the refrigerant round the loop:

    • Compressor – draws in low-pressure vapor and squeezes it to a hot, high-pressure vapor.
    • Condenser – at the front of the car, in front of the engine radiator. Air flowing through it cools the vapor until it condenses into a high-pressure liquid.
    • Receiver-drier (or, on orifice-tube systems, an accumulator on the low side) – stores refrigerant and removes moisture with a desiccant.
    • Expansion device – a thermostatic expansion valve or a fixed orifice tube. The liquid passes through a small opening into the low-pressure side, and its pressure and temperature fall sharply.
    • Evaporator – in the heater box. The cold, low-pressure refrigerant boils, absorbing heat from the air blown across it, then returns to the compressor as vapor.
  3. High side and low side

    The compressor and the expansion device divide the system in two:

    • High side – compressor outlet, condenser, receiver-drier, up to the expansion device. Hot, high pressure.
    • Low side – after the expansion device, evaporator, back to the compressor inlet. Cold, low pressure.

    The pipes on the low side feel cold and may sweat; those on the high side can be hot enough to burn. The system is always under pressure, even when switched off.

  4. Drying the air too

    As warm cabin air passes over the cold evaporator, moisture in it condenses on the fins, just as water forms on a cold glass. The water drains out under the car – the small puddle under a parked car on a hot day is normal.

    This is why air conditioning clears misted windows so quickly: it dries the air as well as cooling it. Many cars run it automatically on the screen setting. The cooled, dried air can then be reheated by the heater to the chosen temperature.

  5. Controlling the compressor

    The compressor is driven by the engine's auxiliary belt, or on electric and many hybrid vehicles by its own electric motor.

    • Belt-driven compressors may use an electromagnetic clutch, switched on and off by the control unit, or vary their displacement to match the cooling needed.
    • Pressure sensors or switches protect the system: they stop the compressor if pressure is too low (for example after a leak) or too high (for example if the condenser fan fails).
    • An evaporator temperature sensor stops the evaporator icing up.

    Electric compressors run from the high-voltage battery: HSE says high-voltage systems are for trained technicians only.

  6. Why only certified technicians work on it

    The refrigerant is under pressure and very cold when it escapes – it can cause frostbite and eye injury. Refrigerants are also harmful to the climate if released.

    In the US, EPA's Section 609 rules require technicians who service motor vehicle air conditioners to complete EPA-approved training and pass an EPA-approved test; intentionally venting most refrigerants is banned, and approved recovery equipment must be used. Learners never connect anything to a system.

The lesson, step by step

45 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minGraded by Classfern
Teaching and hands-on task14 minNot assessed, self-checked
Worked examples and guided practice9 minGraded by Classfern
Independent practice (three levels)13 minGraded by Classfern
Exit ticket and talk question5 minGraded by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all graded instantly.

More practice

More Heating and air conditioning lessons · Motor Vehicle Theory course · All motor mechanics practice tests · Motor Mechanics Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by ASE, NHTSA, any state agency, any college, testing agency or exam board.