Turbochargers: more air, more power – Garage Basics motor mechanics lesson
Lesson 11 of 70 in the Garage Basics course (ages 11–16)
US version. US spelling and words (tire, gasoline, hood) and US rules such as state inspections. · UK version
Find out how a turbocharger uses energy from the exhaust to squeeze more air into the engine, why that gives more power, and what an intercooler and a wastegate do.
- Time
- 45 minutes + 10 min homework
- Course
- Garage Basics (ages 11–16)
- You need
- Paper, a pencil and this page. No tools and no vehicle
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches motor mechanics as a school subject. It is not a training program or a certification, and nothing here replaces an accredited automotive program, ASE certification or a qualified technician. Never work on a real vehicle without a qualified adult, the right protective equipment and safe equipment. High-voltage parts of electric and hybrid vehicles are for trained technicians only.
For parents: how to use this lesson
Use the hairdryer on a cool setting only, held by an adult. The bicycle pump activity needs only a ball or a bicycle tire being pumped normally. Every answer is graded straight away with a worked explanation.
- Read what your child will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Turbochargers use energy from the exhaust that would otherwise be wasted. Can you think of other machines that reuse wasted energy?”
- Later: the homework, then the practice test.
Watch out for
- Thinking the turbo is driven by the engine's belt. A turbocharger is driven by exhaust gas. A supercharger is the type driven mechanically by the engine.
- Thinking a turbo gives power for free. It uses energy in the exhaust that would otherwise be wasted, but it also makes the exhaust flow a little harder and adds heat and complexity.
- Thinking the boost figure is the total pressure. Boost is the pressure above normal air pressure. Add normal air pressure to get the total.
Hands-on: Make a paper windmill and hold it in front of a hairdryer on the cool setting (with an adult): the moving air spins it, like exhaust spinning a turbine. Then feel the side of a bicycle pump after pumping up a ball several times – squeezing air makes it warm, which is why turbo engines use an intercooler.
What your child will learn
- I can explain how a turbocharger is driven and what it does.
- I can explain why more air allows an engine to burn more fuel and make more power.
- I can explain the jobs of the intercooler and the wastegate.
- I can calculate a pressure ratio and the extra mass of air it gives.
Key words
- turbocharger
- A device with a turbine driven by exhaust gas, joined by a shaft to a compressor that pushes extra air into the engine.
- turbine
- A wheel with curved blades that is spun round by a flowing gas.
- compressor
- A spinning wheel that squeezes air and pushes it into the engine.
- boost
- The extra pressure of the air going into the engine above normal air pressure.
- intercooler
- A radiator for the intake air. It cools the squeezed air so it is denser.
- wastegate
- A valve that lets some exhaust bypass the turbine, to stop the boost getting too high.
The big ideas
An engine can only burn as much fuel as it has oxygen for. An ordinary engine relies on normal air pressure to push air into the cylinders on the intake stroke. A turbocharger squeezes extra air in. With more air, the engine can burn more fuel on each cycle and make more power – without making the engine bigger.
A turbocharger has two wheels on one shaft. The hot, fast-flowing exhaust gas spins the turbine wheel, using energy that would otherwise be wasted out of the tailpipe. The shaft spins the compressor wheel on the other side, which draws in fresh air and pushes it into the engine at higher pressure. Turbochargers typically spin at well over 100,000 rpm.
Squeezing air heats it, and hot air is less dense, so many engines pass the air through an intercooler first. A wastegate controls the boost so it never gets too high. Turbochargers let car makers use smaller engines that still give good power, which helps fuel economy. They run extremely hot and fast, and are worked on only by trained technicians.
Read-through: the teaching steps
More air, more fuel, more power
The power an engine makes depends on how much fuel it burns each second, and that depends on how much air it can get. Doubling the mass of air in each cylinder, with the right amount of fuel, roughly doubles the energy released. The turbocharger adds air to the intake stroke shown in the drawing on the lesson page.
The four-stroke cycle: intake, compression, power, exhaust. The crankshaft turns twice for the four strokes. Two wheels, one shaft
- Turbine side – exhaust gas from the engine flows through and spins the turbine wheel, then goes on to the catalytic converter.
- Compressor side – the compressor wheel, on the same shaft, draws in filtered air and squeezes it.
The two gas flows never mix; only the shaft connects them.
Boost and pressure ratio
Normal air pressure at sea level is about 1 atmosphere. If the turbo raises the intake air by 0.5 atmosphere (the boost), the total pressure is 1.5 atmospheres.
Pressure ratio = total intake pressure ÷ normal air pressure = 1.5 ÷ 1 = 1.5.
At the same temperature, 1.5 times the pressure packs about 1.5 times the mass of air into each cylinder.
The intercooler
Squeezing air makes it hot (just as a bicycle pump gets warm). Hot air is less dense, so it carries less oxygen per liter. The intercooler is a radiator that cools the compressed air on its way to the engine, so more air fits into each cylinder and the risk of knock in a gasoline engine is reduced.
The wastegate
At high engine speed there is lots of exhaust, so the turbo could spin too fast and push in too much air. The wastegate is a valve that lets some exhaust go round the turbine instead of through it, keeping the boost at the level the engine is designed for. The engine computer often controls it.
Turbo lag and downsizing
At low engine speed there is little exhaust, so it takes a moment for the turbo to spin up when the driver asks for power. This delay is called turbo lag. Engineers reduce it with small, light turbos. Many modern cars use a small engine with a turbo instead of a bigger engine without one, saving fuel when cruising.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 14 min | Not assessed, self-checked |
| Worked examples and guided practice | 9 min | Graded by Classfern |
| Independent practice (three levels) | 13 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Engines and fuel lessons · Garage Basics course · All motor mechanics practice tests · Motor Mechanics Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by ASE, NHTSA, any state agency, any college, testing agency or exam board.