▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Math, Cookery, Programming and Art are open – explore →

Pressure altitude and density altitude: the idea – Private Pilot Theory aviation lesson

Lesson 76 of 228 in the Private Pilot Theory course (ages 16+)

US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version

Two 'altitudes' that are not heights at all: pressure altitude tells you where you are in the standard atmosphere, and density altitude tells you how the airplane will perform.

Time
40 minutes + 10 min homework
Course
Private Pilot Theory (ages 16+)
You need
Paper, a pencil and this page
Graded
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test. Rules and values on this page are given as of November 2026. Always check the current official source (the FAA) before relying on them.

How to use this lesson

This is adult-level theory (16+). The rule-of-thumb figures are for practicing the idea; real planning always uses the aircraft's own performance data. Every answer is graded straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “A summer afternoon at a hill-top airfield and a winter morning at the coast: which would you expect to give the longer take-off run in theory, and why?”
  4. Later: the homework, then the practice test.

Watch out for

  • Forgetting to subtract the ISA temperature and using the actual temperature on its own. Work out ISA at that pressure altitude first; only the difference from ISA counts.
  • Thinking density altitude is a height you can read off a chart or fly at. It is a way of describing how thin the air is – a performance number, not a position.
  • Thinking humid air is heavier. Water vapor is lighter than dry air, so humid air is slightly less dense.

Hands-on: Make a two-column table headed 'raises density altitude' and 'lowers density altitude'. Sort these cards into it: hot day, cold day, high-level airfield, sea-level airfield, humid day, dry day, low pressure, high pressure.

What you will learn

  • I can define pressure altitude and say how it is found (altimeter set to 29.92 inHg).
  • I can define density altitude as pressure altitude corrected for non-standard temperature.
  • I can explain why heat, height, low pressure and humidity all raise density altitude.
  • I can describe, in theory, how a high density altitude affects performance.
  • I can estimate density altitude with a given rule of thumb.

Key words

pressure altitude
Height above the standard datum plane (29.92 inHg); read with 29.92 set in the altimeter.
density altitude
Pressure altitude corrected for non-standard temperature: the height in the standard atmosphere that has the same air density.
air density
The mass of air in a given volume. Lower density means less lift, less thrust and less power.
ISA deviation
How much warmer or colder the real air is than the standard atmosphere at that height.

The big ideas

The FAA Pilot's Handbook defines pressure altitude as height above the standard datum plane – the level where the pressure equals 29.92 inHg. Set the altimeter to 29.92 and it reads pressure altitude. Pressure altitude is the starting point for performance charts and flight levels.

Density altitude is pressure altitude corrected for non-standard temperature. Aircraft wings, propellers and piston engines respond to the density of the air, not its pressure alone. Warm air is less dense than cold air at the same pressure, and the handbook adds that humid air is less dense than dry air because water vapor is lighter. So on a hot, high, humid day the airplane behaves as if it were at a much greater height.

The handbook explains that thinner air reduces piston engine power, propeller thrust and the lift from the wings. In theory that means a longer takeoff run and a poorer climb. This lesson explains the idea; real performance is always taken from the aircraft's own documents.

Read-through: the teaching steps

  1. Pressure altitude

    Pressure altitude answers: 'At what height in the standard atmosphere would today's pressure be found?' Set 29.92 and the altimeter shows it. It can also be worked out from the altimeter setting: pressure altitude ≈ elevation + (29.92 − setting) × 1,000 ft.

  2. Density altitude

    Density altitude = pressure altitude corrected for non-standard temperature. If the air is warmer than standard, density altitude is higher than pressure altitude; if colder, lower.

    0 ft15 °C5,000 ft5 °C10,000 ft−5 °CSea level pressure 29.92 inHgAir column
    The International Standard Atmosphere (ISA) – a reference, not the real weather on any day.
  3. Three things lower density

    • Height: pressure falls, so density falls.
    • Heat: at the same pressure, warmer air is less dense.
    • Humidity: water vapor is lighter than dry air, so moist air is a little less dense – the handbook calls this a contributing factor.

    Memory aid: 'hot, high and humid' means a high density altitude.

  4. What the handbook says happens

    Thinner air reduces piston engine power, propeller thrust and wing lift. In theory the airplane needs a longer takeoff run, climbs more slowly, and lifts off at a higher true airspeed for the same indicated airspeed.

  5. An estimate with a rule of thumb

    The AOPA Air Safety Institute gives a rule of thumb for estimating density altitude "in a pinch":

    Density altitude ≈ pressure altitude + 120 × (actual temperature − ISA temperature)

    with ISA temperature = 15 − 2 × (pressure altitude in thousands of feet). It is only an estimate. The questions here always state the figure to use; real flight planning uses the aircraft's charts.

The lesson, step by step

40 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minGraded by Classfern
Teaching and hands-on task12 minNot assessed, self-checked
Worked examples and guided practice8 minGraded by Classfern
Independent practice (three levels)11 minGraded by Classfern
Exit ticket and talk question5 minGraded by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all graded instantly.

More practice

More Meteorology lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.