▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Math, Cookery, Programming and Art are open – explore →

Mass and balance / weight and balance: the terms – Private Pilot Theory aviation lesson

Lesson 175 of 228 in the Private Pilot Theory course (ages 16+)

US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version

Learn the language of weight and balance – datum, arm, moment, center of gravity, empty weight and useful load – before doing any calculations.

Time
45 minutes + 10 min homework
Course
Private Pilot Theory (ages 16+)
You need
Paper, a pencil and this page
Graded
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test. Rules and values on this page are given as of November 2026. Always check the current official source (the FAA) before relying on them.

How to use this lesson

This is adult-level theory (16+). Read it alongside the official handbooks; it is explanation for understanding, not training. Every answer is graded straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “Why do you think manufacturers choose different datum positions for different aircraft?”
  4. Later: the homework, then the practice test.

Watch out for

  • Forgetting that arms forward of the datum are negative. Aft is positive, forward is negative.
  • Counting usable fuel in the empty weight. Empty mass includes only unusable fuel; usable fuel is part of the useful load.
  • Treating CG as an average of the arms. CG is total moment ÷ total mass, so heavier items count more.

Hands-on: Balance a ruler on a pencil. Tape coins at different positions and find where it balances. Use one end of the ruler as the "datum", measure each coin's arm in cm, and check that total moment ÷ total coins gives the balance point.

What you will learn

  • I can define datum, arm, station and moment.
  • I can explain what the center of gravity is and how it is expressed.
  • I can distinguish standard empty weight, basic empty weight and useful load.
  • I can explain maximum ramp weight and maximum zero fuel weight.
  • I can calculate useful load and a moment.

Key words

datum
The manufacturer's reference point (station zero) from which arms are measured.
arm
Horizontal distance from the datum to an item's center of gravity; positive aft, negative forward.
moment
Weight × arm (in-lb).
useful load
Maximum allowable gross weight minus basic empty weight.
MAC
Mean aerodynamic chord – CG can be given as a percentage of it.

The big ideas

The FAA calls the subject weight and balance; in the UK it is called mass and balance. The PHAK (chapter 10) defines the datum as the manufacturer's reference point, or station zero. The arm is the horizontal distance from the datum to an item's center of gravity – positive if aft of the datum, negative if forward. A moment is the weight multiplied by its arm (in-lb), and the center of gravity (CG) is the total moment divided by the total weight. CG may be given in inches from the datum or as a percentage of the mean aerodynamic chord (MAC). A moment index is the moment divided by 100, 1,000 or 10,000 to keep numbers small.

The handbook also defines the weights. Standard empty weight includes the airframe, piston or turbine engines, fixed equipment, unusable fuel and full oil; basic empty weight adds optional equipment. Useful load is the maximum allowable gross weight minus basic empty weight. Maximum ramp weight exceeds maximum takeoff weight by taxi and run-up fuel, and maximum zero fuel weight excludes usable fuel.

US examples in this course use pounds and inches. This is theory for understanding, not planning for a real flight.

Read-through: the teaching steps

  1. Datum and arm

    The datum is the zero point the manufacturer chooses. Arms are measured from it: aft is positive, forward is negative. A station is a position given in distance from the datum.

  2. Moment

    Moment = weight × arm. 170 lb at 37 in gives 6,290 in-lb. A moment index divides this by 100, 1,000 or 10,000.

  3. Center of gravity

    CG = total moment ÷ total weight. It may be given in inches from the datum, or as % MAC.

  4. Empty weights

    Standard empty weight: airframe, piston or turbine engines, fixed equipment, fixed ballast, hydraulic fluid, unusable fuel and full oil. Basic empty weight: standard empty weight plus optional equipment.

  5. Useful load

    Useful load = maximum allowable gross weight − basic empty weight. It covers pilot, passengers, baggage and usable fuel.

  6. Other limits

    Maximum ramp weight exceeds maximum takeoff weight by taxi and run-up fuel. Maximum zero fuel weight excludes usable fuel. Fuel burn is normally the only weight change in flight.

The lesson, step by step

45 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minGraded by Classfern
Teaching and hands-on task14 minNot assessed, self-checked
Worked examples and guided practice9 minGraded by Classfern
Independent practice (three levels)13 minGraded by Classfern
Exit ticket and talk question5 minGraded by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all graded instantly.

More practice

More Flight Performance and Planning lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.