Mass and balance / weight and balance: the terms – Private Pilot Theory aviation lesson
Lesson 175 of 228 in the Private Pilot Theory course (ages 16+)
UK version. UK spelling and units (hPa, metres, litres) and the UK CAA. · US version
Learn the language of mass and balance – datum, arm, moment, centre of gravity, empty mass and useful load – before doing any calculations.
- Time
- 45 minutes + 10 min homework
- Course
- Private Pilot Theory (ages 16+)
- You need
- Paper, a pencil and this page
- Marked
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an approved training organisation, and nothing here counts towards a pilot licence or replaces a CAA-approved course and the CAA’s own exams. Rules and values on this page are given as of November 2026. Always check the current official source (the UK CAA) before relying on them.
How to use this lesson
This is adult-level theory (16+). Read it alongside the official handbooks; it is explanation for understanding, not training. Every answer is marked straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Why do you think manufacturers choose different datum positions for different aircraft?”
- Later: the homework, then the practice test.
Watch out for
- Forgetting that arms forward of the datum are negative. Aft is positive, forward is negative.
- Counting usable fuel in the empty mass. Empty mass includes only unusable fuel; usable fuel is part of the useful load.
- Treating CG as an average of the arms. CG is total moment ÷ total mass, so heavier items count more.
Hands-on: Balance a ruler on a pencil. Tape coins at different positions and find where it balances. Use one end of the ruler as the "datum", measure each coin's arm in cm, and check that total moment ÷ total coins gives the balance point.
What you will learn
- I can define datum, arm, station and moment.
- I can explain what the centre of gravity is and how it is expressed.
- I can distinguish standard empty mass, basic empty mass and useful load.
- I can explain maximum ramp mass and maximum zero fuel mass.
- I can calculate useful load and a moment.
Key words
- datum
- The manufacturer's reference point (station zero) from which arms are measured.
- arm
- Horizontal distance from the datum to an item's centre of gravity; positive aft, negative forward.
- moment
- Mass × arm (for example kg·m).
- useful load
- Maximum allowable mass minus basic empty mass.
- MAC
- Mean aerodynamic chord – CG can be given as a percentage of it.
The big ideas
In the UK the subject is called mass and balance; the FAA calls it weight and balance. The ideas are the same. The PHAK (chapter 10) defines the datum as the manufacturer's reference point, or station zero. The arm is the horizontal distance from the datum to an item's centre of gravity – positive if aft of the datum, negative if forward. A moment is the mass multiplied by its arm, and the centre of gravity (CG) is the total moment divided by the total mass. CG may be given as a distance from the datum or as a percentage of the mean aerodynamic chord (MAC).
The handbook also defines the aircraft's masses. Standard empty mass includes the airframe, piston engines, fixed equipment, unusable fuel and full oil; basic empty mass adds optional equipment. Useful load is the maximum allowable mass minus the basic empty mass – what is left for people, baggage and usable fuel. Maximum ramp mass is a little more than maximum take-off mass, allowing for taxi and run-up fuel, and maximum zero fuel mass is the limit with no usable fuel on board.
UK examples in this course use kilograms and metres; US examples use pounds and inches. This is theory for understanding, not planning for a real flight.
Read-through: the teaching steps
Datum and arm
The datum is the zero point the manufacturer chooses. Arms are measured from it: aft is positive, forward is negative. A station is a position given in distance from the datum.
Moment
Moment = mass × arm. 80 kg at 2.2 m gives 176 kg·m.
Centre of gravity
CG = total moment ÷ total mass. It may be given in metres (or centimetres) from the datum, or as % MAC.
Empty masses
Standard empty mass: airframe, piston engines, fixed equipment, fixed ballast, hydraulic fluid, unusable fuel and full oil. Basic empty mass: standard empty mass plus optional equipment.
Useful load
Useful load = maximum allowable mass − basic empty mass. It covers pilot, passengers, baggage and usable fuel.
Other limits
Maximum ramp mass is greater than maximum take-off mass by the taxi and run-up fuel. Maximum zero fuel mass excludes usable fuel. The handbook adds that fuel burn is normally the only mass change in flight.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Marked by Classfern |
| Teaching and hands-on task | 14 min | Not assessed, self-checked |
| Worked examples and guided practice | 9 min | Marked by Classfern |
| Independent practice (three levels) | 13 min | Marked by Classfern |
| Exit ticket and talk question | 5 min | Marked by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all marked instantly.
More practice
More Flight Performance and Planning lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by the CAA, any flying school, testing agency or exam board.