Crosswind limits and the demonstrated crosswind – Private Pilot Theory aviation lesson
Lesson 189 of 228 in the Private Pilot Theory course (ages 16+)
US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version
Understand what the "maximum demonstrated crosswind component" in a flight manual means, why it is usually not a limitation, and how to compare a wind with it.
- Time
- 45 minutes + 10 min homework
- Course
- Private Pilot Theory (ages 16+)
- You need
- Paper, a pencil and this page
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test. Rules and values on this page are given as of November 2026. Always check the current official source (the FAA) before relying on them.
How to use this lesson
This is adult-level theory (16+). Read it alongside the official handbooks; it is explanation for understanding, not training. Every answer is graded straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Why might a manufacturer write "not a limitation" next to the demonstrated crosswind figure?”
- Later: the homework, then the practice test.
Watch out for
- Treating the demonstrated figure as a guaranteed safe limit. It is what was demonstrated in tests – often marked "not a limitation".
- Comparing the total wind speed with the figure. Compare the crosswind component, not the full wind.
- Ignoring gusts. Work out the component for the gust speed too.
Hands-on: Make a simple crosswind chart: draw lines from a corner at 0°, 15°, 30°, 45°, 60°, 75° and 90°, and arcs for 10, 20 and 30 kt. Read off a few crosswinds and check them with sine.
What you will learn
- I can explain what a demonstrated crosswind figure is.
- I can explain why it is usually not stated as a limitation.
- I can calculate a crosswind component and compare it with a figure.
- I can explain why gusts make the comparison harder.
- I can read a crosswind component chart in principle.
Key words
- demonstrated crosswind
- The strongest crosswind component experienced during certification tests while control was maintained.
- crosswind component
- Wind speed × sin(angle to the runway).
- gust
- A brief increase in wind speed above the mean.
- crosswind component chart
- A chart in the flight manual that gives headwind and crosswind components.
- limitation
- A value the aircraft must not exceed, listed in the manual's limitations section.
The big ideas
Flight manuals often quote a "maximum demonstrated crosswind component" or velocity – the strongest crosswind experienced during the aircraft's certification tests while adequate control was kept. Placards showing it often add the words "not a limitation". It tells you what has been shown to be controllable, not what is safe for every pilot.
The PHAK (chapter 11) lists crosswind and headwind component charts among the performance charts in a flight manual. Whether by chart or by sine and cosine, the crosswind component is wind speed × sin(angle between the wind and the runway).
Gusts make comparison harder, because the component rises and falls with the wind. A careful comparison uses the gust value as well as the mean wind. This lesson is math and interpretation for understanding, not advice on when to fly.
Read-through: the teaching steps
What "demonstrated" means
The figure is the crosswind actually met in certification flight tests. It shows the aircraft could be controlled in that crosswind by a test pilot.
Not a limitation
Placards often say "not a limitation". It is information, not the edge of a hard limit – but stronger crosswinds have not been demonstrated.
Working out the component
Crosswind = W × sin θ. Runway 27, wind 320°/15 kt: θ = 50°, 15 × sin 50° = 15 × 0.766 = 11.5 kt.
Gusts
With a gusting wind, work out the component for the gust as well: wind 320°/15G25 → 25 × 0.766 = 19.2 kt in the gusts.
Charts
A crosswind component chart has wind angle lines and speed arcs; reading down and across gives the two components without a calculator.
Try it: wind on the runway
Set the wind and see how much of it blows along and across the runway.
Try the real thing: Aviation Weather Center (aviationweather.gov): real METARs and TAFs (opens in a new tab).
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 14 min | Not assessed, self-checked |
| Worked examples and guided practice | 9 min | Graded by Classfern |
| Independent practice (three levels) | 13 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Flight Performance and Planning lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.