▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Maths, Cookery, Programming and Art are open – explore →

Crosswind limits and the demonstrated crosswind – Private Pilot Theory aviation lesson

Lesson 189 of 228 in the Private Pilot Theory course (ages 16+)

UK version. UK spelling and units (hPa, metres, litres) and the UK CAA. · US version

Understand what the "maximum demonstrated crosswind component" in a flight manual means, why it is usually not a limitation, and how to compare a wind with it.

Time
45 minutes + 10 min homework
Course
Private Pilot Theory (ages 16+)
You need
Paper, a pencil and this page
Marked
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an approved training organisation, and nothing here counts towards a pilot licence or replaces a CAA-approved course and the CAA’s own exams. Rules and values on this page are given as of November 2026. Always check the current official source (the UK CAA) before relying on them.

How to use this lesson

This is adult-level theory (16+). Read it alongside the official handbooks; it is explanation for understanding, not training. Every answer is marked straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “Why might a manufacturer write "not a limitation" next to the demonstrated crosswind figure?”
  4. Later: the homework, then the practice test.

Watch out for

  • Treating the demonstrated figure as a guaranteed safe limit. It is what was demonstrated in tests – often marked "not a limitation".
  • Comparing the total wind speed with the figure. Compare the crosswind component, not the full wind.
  • Ignoring gusts. Work out the component for the gust speed too.

Hands-on: Make a simple crosswind chart: draw lines from a corner at 0°, 15°, 30°, 45°, 60°, 75° and 90°, and arcs for 10, 20 and 30 kt. Read off a few crosswinds and check them with sine.

What you will learn

  • I can explain what a demonstrated crosswind figure is.
  • I can explain why it is usually not stated as a limitation.
  • I can calculate a crosswind component and compare it with a figure.
  • I can explain why gusts make the comparison harder.
  • I can read a crosswind component chart in principle.

Key words

demonstrated crosswind
The strongest crosswind component experienced during certification tests while control was maintained.
crosswind component
Wind speed × sin(angle to the runway).
gust
A brief increase in wind speed above the mean.
crosswind component chart
A chart in the flight manual that gives headwind and crosswind components.
limitation
A value the aircraft must not exceed, listed in the manual's limitations section.

The big ideas

Flight manuals often quote a "maximum demonstrated crosswind component" or velocity – the strongest crosswind experienced during the aircraft's certification tests while adequate control was kept. Placards showing it often add the words "not a limitation". It tells you what has been shown to be controllable, not what is safe for every pilot.

The PHAK (chapter 11) lists crosswind and headwind component charts among the performance charts in a flight manual. Whether by chart or by sine and cosine, the crosswind component is wind speed × sin(angle between the wind and the runway).

Gusts make comparison harder, because the component rises and falls with the wind. A careful comparison uses the gust value as well as the mean wind. This lesson is maths and interpretation for understanding, not advice on when to fly.

Read-through: the teaching steps

  1. What "demonstrated" means

    The figure is the crosswind actually met in certification flight tests. It shows the aircraft could be controlled in that crosswind by a test pilot.

  2. Not a limitation

    Placards often say "not a limitation". It is information, not the edge of a hard limit – but stronger crosswinds have not been demonstrated.

  3. Working out the component

    Crosswind = W × sin θ. Runway 27, wind 320°/15 kt: θ = 50°, 15 × sin 50° = 15 × 0.766 = 11.5 kt.

  4. Gusts

    With a gusting wind, work out the component for the gust as well: wind 320°/15G25 → 25 × 0.766 = 19.2 kt in the gusts.

  5. Charts

    A crosswind component chart has wind angle lines and speed arcs; reading down and across gives the two components without a calculator.

Try it: wind on the runway

Set the wind and see how much of it blows along and across the runway.

Try the real thing: Met Office: METARs and TAFs (opens in a new tab).

The lesson, step by step

45 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minMarked by Classfern
Teaching and hands-on task14 minNot assessed, self-checked
Worked examples and guided practice9 minMarked by Classfern
Independent practice (three levels)13 minMarked by Classfern
Exit ticket and talk question5 minMarked by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all marked instantly.

More practice

More Flight Performance and Planning lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the CAA, any flying school, testing agency or exam board.