Control surfaces and their linkages – Private Pilot Theory aviation lesson
Lesson 149 of 228 in the Private Pilot Theory course (ages 16+)
US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version
Learn which control surface moves the airplane about each axis, how cables, push rods and bellcranks connect them to the cockpit, and how trim tabs and flaps work.
- Time
- 45 minutes + 10 min homework
- Course
- Private Pilot Theory (ages 16+)
- You need
- Paper, a pencil and this page
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test. Rules and values on this page are given as of November 2026. Always check the current official source (the FAA) before relying on them.
How to use this lesson
This is adult-level theory (16+). Read it alongside the official handbooks; it is explanation for understanding, not training. Every answer is graded straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Why might designers of large aircraft choose fly-by-wire instead of cables and pulleys?”
- Later: the homework, then the practice test.
Watch out for
- Thinking the trim tab moves the same way as the surface. A trim tab moves opposite to its surface; only the antiservo tab moves the same way.
- Mixing up the axes. Ailerons roll about the longitudinal axis; elevator pitches about the lateral axis; rudder yaws about the vertical axis.
- Thinking differential ailerons remove adverse yaw completely. The handbook says they reduce it but do not eliminate it.
Hands-on: Make a bellcrank: pin an L-shaped piece of card to a cork board at the corner. Tie a thread to each arm. Pull one thread and watch the other arm move at right angles. Then fold a paper airplane with a small tab on each elevator and test which way the tab must bend to make the nose rise.
What you will learn
- I can match ailerons, elevator and rudder to roll, pitch and yaw.
- I can describe the mechanical linkages between cockpit controls and surfaces.
- I can explain adverse yaw and two designs that reduce it.
- I can explain why a trim tab moves opposite to its control surface.
- I can describe the effect of the main flap types.
Key words
- primary flight controls
- Ailerons (roll), elevator or stabilator (pitch) and rudder (yaw).
- bellcrank
- A pivoted lever that changes the direction of a cable or push rod movement.
- adverse yaw
- Yaw towards the raised wing caused by the extra drag of the lowered aileron.
- trim tab
- A small adjustable surface that holds a control surface in place and removes control pressure.
- fly-by-wire
- A system where electrical signals and computers replace the mechanical link to the surfaces.
The big ideas
The PHAK (chapter 6) describes three primary flight controls. The ailerons, on the outer trailing edges of the wings, move in opposite directions to roll the airplane about its longitudinal axis. The elevator (or a one-piece stabilator) pitches it about the lateral axis. The rudder, worked by the pedals, yaws it about the vertical axis.
In small airplanes the cockpit controls are joined to the surfaces mechanically – by cables, pulleys, bellcranks and push-pull tubes. Larger aircraft may add hydraulic boosting, and fly-by-wire aircraft replace the physical link with electrical signals and computers that send simulated "feel" back to the pilot.
Secondary controls change the wing or trim the airplane: flaps raise lift (and drag), and trim tabs remove the need to hold steady pressure on the controls. This lesson is theory for understanding only, not flight instruction.
Read-through: the teaching steps
Three surfaces, three axes
- Ailerons → roll about the longitudinal axis
- Elevator or stabilator → pitch about the lateral axis
- Rudder → yaw about the vertical axis
Ailerons roll the aircraft, the elevator pitches it and the rudder yaws it. The mechanical link
The handbook describes rods, cables, pulleys and sometimes chains in small aircraft. The ailerons connect to the control wheel or stick through cables, bellcranks, pulleys and/or push-pull tubes. A bellcrank is a pivoted lever that turns a pull in one direction into a movement in another.
Boosted and fly-by-wire controls
Hydromechanical systems add a hydraulic circuit to help move big surfaces. In fly-by-wire, electric motors, digital computers or optical data links replace the physical connection. Both feed control "feel" back to the pilot by simulated means.
Adverse yaw
The lowered aileron makes more lift and more drag, so the airplane yaws towards that wing – opposite to the bank. The handbook says rudder counteracts it. Designs that reduce (but do not remove) it:
- differential ailerons – the up aileron moves further than the down one
- Frise ailerons – the raised aileron's nose pokes into the airflow and adds drag
Trim tabs
A trim tab moves opposite to its control surface. The handbook's example: nose-up trim moves the elevator tab down, the airflow pushes the tab up, and that holds the elevator up. An antiservo tab on a stabilator moves the same way as the trailing edge, making the control less sensitive.
Flaps and other devices
- Plain flap – more camber and lift, much more drag, nose-down pitch
- Split flap – slightly more lift than plain, more drag
- Slotted flap – significantly more lift
- Fowler flap – slides back, increasing wing area and camber
Spoilers reduce lift and increase drag.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 14 min | Not assessed, self-checked |
| Worked examples and guided practice | 9 min | Graded by Classfern |
| Independent practice (three levels) | 13 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Aircraft General Knowledge lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.