Climb performance: Vx, Vy and service ceiling – Private Pilot Theory aviation lesson
Lesson 184 of 228 in the Private Pilot Theory course (ages 16+)
US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version
Learn the difference between best angle (Vx) and best rate (Vy) of climb, how they change with altitude, and what absolute and service ceilings mean.
- Time
- 45 minutes + 10 min homework
- Course
- Private Pilot Theory (ages 16+)
- You need
- Paper, a pencil and this page
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test. Rules and values on this page are given as of November 2026. Always check the current official source (the FAA) before relying on them.
How to use this lesson
This is adult-level theory (16+). Read it alongside the official handbooks; it is explanation for understanding, not training. Every answer is graded straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “When might a pilot choose Vx rather than Vy, and what is the trade-off?”
- Later: the homework, then the practice test.
Watch out for
- Mixing up Vx and Vy. X for "eXtra steep" angle; Y for "most in the least time" – Vx is angle, Vy is rate.
- Thinking the service ceiling is where the aircraft cannot climb at all. That is the absolute ceiling; the service ceiling is 100 ft/min.
- Forgetting to subtract the starting altitude. Use the height to gain, not the final altitude.
Hands-on: Walk up a steep short path and a gentle long path to the same height, timing each. Which gets you highest in the shortest distance (Vx) and which in the shortest time (Vy)?
What you will learn
- I can define Vx and Vy.
- I can say which is used to clear an obstacle and why.
- I can describe how Vx and Vy change with altitude.
- I can define absolute and service ceiling.
- I can calculate climb time and climb gradient.
Key words
- Vx
- Best angle of climb speed – the most height in a given horizontal distance.
- Vy
- Best rate of climb speed – the most height in a given time.
- absolute ceiling
- The altitude where excess power is zero and the aircraft can no longer climb.
- service ceiling
- The altitude where the aircraft can no longer climb faster than 100 ft/min.
- climb gradient
- Height gained per unit of horizontal distance.
The big ideas
The PHAK (chapter 11) defines two climb speeds. Vx is the speed at which the aircraft gains the most altitude in a given horizontal distance – the best angle of climb, useful for clearing an obstacle. Vy is the speed at which it gains the most altitude per unit of time – the best rate of climb. Vx normally increases slightly with altitude and Vy normally decreases slightly.
As the aircraft climbs, the excess power available for climbing gets smaller. The absolute ceiling is the altitude where excess power is zero and the climb rate is zero. The service ceiling is the altitude where the aircraft can no longer climb faster than 100 ft per minute.
Climb arithmetic is simple: time = height to gain ÷ rate of climb, and a gradient compares height gained with distance traveled. This is theory for understanding only.
Read-through: the teaching steps
Vx – best angle
Most height for a given horizontal distance. It gives the steepest climb – the one that matters when an obstacle lies ahead.
Vy – best rate
Most height for a given time. It gets the aircraft to a cruising altitude soonest.
How they change with altitude
PHAK: Vx normally increases slightly with altitude; Vy normally decreases slightly. They meet at the absolute ceiling.
Ceilings
- Absolute ceiling: excess power zero, climb rate zero.
- Service ceiling: climb rate down to 100 ft/min.
Climb time
Time (min) = height to gain ÷ rate of climb.
4,500 ft at 700 ft/min = 6.43 min (about 6 min 26 s).
Gradient
Height per distance. Feet per nautical mile = rate of climb (ft/min) ÷ groundspeed in NM per minute.
600 ft/min at 90 kt (1.5 NM/min) = 400 ft per NM.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 14 min | Not assessed, self-checked |
| Worked examples and guided practice | 9 min | Graded by Classfern |
| Independent practice (three levels) | 13 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Flight Performance and Planning lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.