▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Math, Cookery, Programming and Art are open – explore →

Altimeter settings en route: UK regional pressure settings vs US nearest-station rule – Private Pilot Theory aviation lesson

Lesson 217 of 228 in the Private Pilot Theory course (ages 16+)

US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version

Compare how UK and US pilots keep the altimeter set during a cross-country: the UK Regional Pressure Setting and QNH, and the US rule of using a station within 100 NM.

Time
45 minutes + 10 min homework
Course
Private Pilot Theory (ages 16+)
You need
Paper, a pencil and this page
Graded
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test. Rules and values on this page are given as of November 2026. Always check the current official source (the FAA) before relying on them.

How to use this lesson

This is adult-level theory (16+). Read it alongside the official handbooks; it is explanation for understanding, not training. Every answer is graded straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “Why do you think the UK uses a regional lowest-forecast setting rather than requiring the nearest station?”
  4. Later: the homework, then the practice test.

Watch out for

  • Never updating the setting. Pressure changes en route.
  • Thinking the RPS error is dangerous. It normally under-reads – a safe-side error.
  • Getting the error direction wrong. Higher setting than actual → over-reads.

Hands-on: Use a weather website to find the pressure at two towns 50–100 miles apart. Work out how far an altimeter would be wrong if it were set to one and flown to the other.

What you will learn

  • I can explain why the altimeter setting must be updated en route.
  • I can describe the UK Regional Pressure Setting.
  • I can state the US 91.121 rule (as of November 2026).
  • I can calculate the error from an out-of-date setting.
  • I can explain why the RPS error is on the safe side.

Key words

RPS
Regional Pressure Setting – the lowest forecast pressure in a UK altimeter setting region.
QNH
The setting that gives altitude above mean sea level at a particular place.
altimeter setting
US: the local QNH-type setting from a reporting station.
under-read
The altimeter shows less than the true altitude.
high to low, look out below
A setting not updated when pressure falls makes the altimeter over-read.

The big ideas

Pressure changes along a route, so an altimeter setting that was right at departure can be wrong later. The PHAK (chapter 8) says an altimeter setting is accurate only near its reporting station and should be updated en route.

In the US, 14 CFR 91.121 says that below 18,000 ft MSL the altimeter is set to the current reported setting of a station along the route and within 100 NM of the aircraft; at or above 18,000 ft MSL, 29.92 inHg. In the UK, by contrast, the CAA Skyway Code describes a Regional Pressure Setting – the lowest forecast pressure in a region – which normally makes the altimeter under-read, a safe-side error. Both as of November 2026.

Using the PHAK rule of 1,000 ft per inch, an altimeter set 0.15 inch too low under-reads by about 150 ft. This is theory for understanding only.

Read-through: the teaching steps

  1. Why update?

    Pressure varies along the route; a setting is accurate only near its station (PHAK).

    0 ft15 °C5,000 ft5 °C10,000 ft−5 °CSea level pressure 29.92 inHgAir column
    The International Standard Atmosphere (ISA) – a reference, not the real weather on any day.
  2. US: the 100 NM rule

    Below 18,000 ft MSL: current setting of a station along the route within 100 NM (91.121). At or above 18,000 ft: 29.92.

  3. Size of the error

    1,000 ft per inch (PHAK). Set 0.15 inch too low → under-reads ~150 ft.

  4. Direction of the error

    Setting lower than actual → under-reads (aircraft higher than shown). Setting higher than actual → over-reads ("high to low, look out below").

  5. Comparison with the UK

    UK: a Regional Pressure Setting (lowest forecast in a region), which usually leaves a safe-side error.

Try it: the altimeter

Move the controls and watch the instruments, then try reading them.

Try the real thing: FAA Pilot’s Handbook of Aeronautical Knowledge, chapter 8: flight instruments (free PDF) (opens in a new tab).

The lesson, step by step

45 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minGraded by Classfern
Teaching and hands-on task14 minNot assessed, self-checked
Worked examples and guided practice9 minGraded by Classfern
Independent practice (three levels)13 minGraded by Classfern
Exit ticket and talk question5 minGraded by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all graded instantly.

More practice

More Navigation lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.