The Wright brothers' technology: wind tunnel data, propellers and their piston engine – Navigation and Technology aviation lesson
Lesson 28 of 90 in the Navigation and Technology course (ages 14+)
US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version
The Wright brothers did not just build an airplane – they built the science and the tools to design one. See how a homemade wind tunnel fixed a mistake in the textbooks, why they treated propellers as spinning wings, and how they built their own lightweight piston engine in six weeks.
- Time
- 45 minutes + 10 min homework
- Course
- Navigation and Technology (ages 14+)
- You need
- Paper, a pencil and this page
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test.
How to use this lesson
Sources: US Centennial of Flight Commission essays on the Wrights' 1901 wind tunnel and the 1903 piston engine and propellers; National Park Service, Wright Brothers National Memorial (first flight). Good links to KS3/GCSE and high-school science on fair tests and efficiency. Every answer is graded straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “The Wrights tested and measured instead of trusting the published tables. Can you think of a time when checking something for yourself proved the 'expert' answer wrong?”
- Later: the homework, then the practice test.
Watch out for
- Thinking the Wrights just bolted a piston engine onto a glider. The wings, propellers and piston engine all came from careful testing and design.
- Thinking a propeller works like a fan just pushing air back. Each blade is an airfoil making 'lift' forward – it is a spinning wing.
- Thinking the old lift tables were completely wrong. The Commission says the tables were largely correct; Smeaton's coefficient was the main error.
Hands-on: Make a simple wind tunnel test. Hold a strip of paper by one end just below your lips and blow over the top – it rises. Now try strips bent into different curves (flat, gently curved, strongly curved). Which lifts most for the same blow? Record your results in a table, as the Wrights did in their notebooks.
What you will learn
- I can explain why the Wrights built a wind tunnel and what it showed.
- I can explain the idea of a propeller as a rotating wing.
- I can describe the main features of the 1903 piston engine and why weight mattered.
- I can calculate efficiency and power figures from historical data.
Key words
- wind tunnel
- A tube in which air is blown past a model so that the forces on it can be measured.
- airfoil
- The curved cross-section shape of a wing or propeller blade, designed to make lift.
- propeller efficiency
- The percentage of the piston engine's power that a propeller turns into useful thrust.
- torque
- A turning force. A spinning propeller pushes the aircraft to twist the opposite way.
- power-to-weight ratio
- How much power a piston engine makes for each unit of its own weight.
The big ideas
By 1901 the Wright brothers were puzzled. Their gliders made less lift than the published tables predicted. The US Centennial of Flight Commission explains that they built a wind tunnel to find out why. From November 22, 1901, they tested 38 model airfoils, each at 45 different angles, recording results in notebooks. By mid-December they had their answer: the long-used figure called Smeaton's coefficient was wrong, and a better wing shape had its highest point about a quarter of the way back from the front edge. Their new data led to the successful 1902 glider and then the 1903 Flyer.
Next they needed power. No maker would build a piston engine light enough to their specification, so the Wrights and their mechanic, Charlie Taylor, built their own. It had four cylinders and an aluminum crankcase, weighed about 200 lb, and made about 16 hp when starting and 12.5 hp in flight. It took six weeks to machine and first ran on February 12, 1903.
The cleverest part may have been the propellers. Nobody had a proper theory, so the Wrights treated each blade as a wing moving along a spiral path and used their wind tunnel data to design it. The Commission gives their two hand-carved spruce propellers, each 8.5 ft long, an efficiency of about 66 %, compared with 40–52 % for earlier designs. A crossed chain made them spin in opposite directions so their twisting effects canceled. On December 17, 1903, the Flyer made four flights; the National Park Service records the longest as 852 ft in 59 seconds.
Read-through: the teaching steps
A problem with the textbooks
The Wrights' 1900 and 1901 gliders lifted less than expected. Rather than give up, they decided to measure the forces themselves – a true scientific approach: test, measure, compare, improve.
The wind tunnel
- A square wooden tube with a fan blowing air through it.
- Small balances inside measured the forces on model wings.
- 38 model airfoils, each tested at 45 angles.
Result: the old Smeaton's coefficient was wrong, and a better wing curve was found (compare the wing section drawing on the lesson page).
An airfoil: the chord line joins the leading and trailing edges; the angle of attack is between the chord line and the relative airflow. Propellers are spinning wings
A propeller blade has an airfoil shape. As it spins and moves forward, each part of the blade travels along a spiral and makes 'lift' pointing forward – that is thrust. The Wrights used their wind tunnel data to shape the blades, reaching about 66 % efficiency.
Stopping the twist
A spinning propeller tries to twist the aircraft the other way (torque). The Flyer had two pusher propellers driven by chains; one chain was crossed so the propellers turned in opposite directions, canceling the twist.
A homemade piston engine
- Four cylinders, water-cooled.
- Aluminum crankcase to save weight.
- About 200 lb; about 12.5 hp in flight.
- No throttle – it simply ran.
Light weight mattered: every pound of piston engine was a pound the wings had to lift.
Putting it together
Good wings (from wind tunnel data), efficient propellers (also from the data) and a light piston engine (built in-house) together made powered, controlled flight possible – with a control system for all three axes that the next lesson explores.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 14 min | Not assessed, self-checked |
| Worked examples and guided practice | 9 min | Graded by Classfern |
| Independent practice (three levels) | 13 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Aircraft technology lessons · Navigation and Technology course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
- U.S. Centennial of Flight Commission – essays on aviation history
- US National Park Service – Wright Brothers National Memorial
Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.