The diesel engine: compression ignition – Motor Vehicle Theory motor mechanics lesson
Lesson 30 of 131 in the Motor Vehicle Theory course (ages 16+)
UK version. UK spelling and words (tyre, petrol, bonnet) and UK rules such as the MOT. · US version
Find out how a diesel engine lights its fuel with nothing but hot, squeezed air, why it needs a high compression ratio, and how that changes the way it is controlled and cleaned up.
- Time
- 45 minutes + 10 min homework
- Course
- Motor Vehicle Theory (ages 16+)
- You need
- Paper, a pencil and this page. No tools and no vehicle
- Marked
- Instantly, with explanations
Education and interest only. Classfern teaches motor mechanics as a school subject. It is not a training course or a qualification, and nothing here replaces an IMI or City & Guilds course, an apprenticeship or a qualified technician. Never work on a real vehicle without a qualified adult, the right protective equipment and safe equipment. High-voltage parts of electric and hybrid vehicles are for trained technicians only. Rules and values on this page are given as of November 2026. Always check the current official source (GOV.UK and the DVSA MOT inspection manual) before relying on them.
How to use this lesson
This lesson explains how a diesel engine works. Diesel fuel systems run at very high pressure and are for trained technicians only. The inspection values quoted are dated November 2026; check the official source before relying on them. Every answer is marked straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “A diesel is usually more efficient than a petrol engine, so why do you think many towns are trying to reduce the number of older diesel vehicles on their streets?”
- Later: the homework, then the practice test.
Watch out for
- Thinking a diesel has spark plugs. A diesel has no spark plugs. Glow plugs only warm the chamber for starting; the fuel is lit by the heat of compression.
- Thinking a diesel compresses a mixture of air and fuel. Only air is compressed. Fuel is injected near the top of the compression stroke. If fuel were present earlier it would light too soon.
- Thinking a higher compression ratio means the cylinder is bigger. The ratio compares two volumes in the same cylinder. A small engine can have a higher ratio than a large one.
Hands-on: With an adult's permission, pump up a bicycle tyre with a hand pump and feel how the pump barrel near the valve gets warm. That warmth is the same effect that lights a diesel's fuel. Then make a table comparing petrol and diesel engines under the headings: how the fuel is lit, what is compressed, how power is controlled, main exhaust problems. If you look at a real diesel car, do it only with a qualified adult, with the car parked, switched off and cold, and only look – for example at the label on the fuel filler flap.
What you will learn
- I can explain how compression ignition differs from spark ignition.
- I can calculate a compression ratio from swept and clearance volumes.
- I can explain why a diesel controls its power by the amount of fuel rather than with a throttle.
- I can describe what glow plugs do and why a cold diesel is harder to start.
- I can name the main exhaust aftertreatment parts on a modern diesel and what each one removes.
Key words
- compression ignition
- Lighting the fuel with the heat made by squeezing air, with no spark. Diesel engines work this way.
- compression ratio
- The total cylinder volume with the piston at the bottom divided by the volume left with the piston at the top.
- glow plug
- An electrically heated rod in or near each combustion chamber that helps a cold diesel start.
- ignition delay
- The short time between fuel starting to spray into the hot air and the fuel catching light.
- cetane number
- A measure of how readily a diesel fuel ignites when it is sprayed into hot air. A higher number means a shorter ignition delay.
The big ideas
In a petrol engine a spark plug lights a mixture of air and fuel. A diesel engine has no spark plugs. The US Department of Energy describes it as compression-ignited: the fuel is injected into the combustion chamber and lit by the high temperature the air reaches when the piston compresses it.
To get the air hot enough, a diesel squeezes it much harder than a petrol engine does, so it has a higher compression ratio. It compresses only air, and the fuel is sprayed in near the top of the compression stroke. Because the fuel does not go in until it is needed, there is no risk of the mixture lighting too early, and the engine can be built for high compression and high efficiency.
The same features bring problems: diesel combustion makes soot and oxides of nitrogen, so modern diesels carry exhaust aftertreatment. This lesson explains the theory. It is not a repair guide: fuel systems and diesel injection work at very high pressure and are for trained technicians only.
Read-through: the teaching steps
Four strokes, no spark
A diesel uses the same four strokes as a petrol engine: induction, compression, power and exhaust. The drawing on the lesson page shows them.
- Induction: only air is drawn in.
- Compression: the piston squeezes the air, and it gets very hot.
- Power: fuel is sprayed in near the top of the stroke, lights in the hot air, and the burning gas pushes the piston down.
- Exhaust: the burnt gas is pushed out.
The key difference is the moment the fuel arrives. In a diesel it arrives at the end of compression, not during induction.
The four-stroke cycle: intake, compression, power, exhaust. The crankshaft turns twice for the four strokes. Why compression makes heat
When a gas is squeezed quickly, the work done on it raises its temperature. A bicycle pump gets warm for the same reason.
In an ideal engine with no heat lost, the temperature after compression is T₂ = T₁ × r^(γ − 1), where r is the compression ratio, γ is about 1.4 for air, and temperatures are in kelvin. Real engines lose some heat to the walls, but the air is still far hotter than the point where diesel fuel lights.
Compression ratio
Compression ratio r = (swept volume + clearance volume) ÷ clearance volume.
The swept volume is the space the piston moves through. The clearance volume is the space left above the piston at top dead centre. Typical petrol car engines have ratios of roughly 9:1 to 13:1; typical diesel car engines roughly 15:1 to 20:1. The exact figure for any engine is in the manufacturer's data.
Controlling power without a throttle
A petrol engine controls its power mainly with a throttle that limits how much air gets in, because petrol and air must stay close to the correct ratio for the spark to light the mixture and for the catalyst to work.
A diesel can burn a weak overall mixture, because the fuel lights wherever it meets hot air. So it usually controls power by changing how much fuel is injected each stroke: more fuel, more power. Less throttling means less pumping work, which is one reason diesels are efficient at light load. Many modern diesels keep a throttle valve for other jobs, not as the main power control.
Ignition delay, knock and cold starts
Fuel does not light the instant it enters the cylinder. During the ignition delay it mixes and warms. If too much fuel builds up during the delay, it burns all at once with a hard rattle called diesel knock. Fuel with a higher cetane number has a shorter delay.
When the engine is cold, the cylinder walls take heat from the compressed air, so it may not get hot enough. Glow plugs heat the chamber before and just after starting. A glow plug warning light on the dashboard tells the driver when to start.
Cleaning up the exhaust
Diesel combustion is very hot and has spare oxygen, so it makes oxides of nitrogen (NOx). Where fuel droplets burn without enough air, it makes soot (particulate matter). The US Department of Energy lists the usual aftertreatment parts:
- a diesel oxidation catalyst;
- a diesel particulate filter, which captures particulate matter;
- selective catalytic reduction (SCR), which turns NOx into nitrogen and water using diesel exhaust fluid, a solution of urea in water kept in its own tank.
Later lessons look at these in detail.
Diesel smoke and the MOT
Smoke shows that something is wrong with combustion or with the aftertreatment. In the MOT (inspection manual section 8, as of November 2026) diesel cars are given a smoke opacity test. The limit depends on when the car was first used: 0.7 m⁻¹ for cars first used on or after 1 January 2014, 1.5 m⁻¹ for 1 July 2008 to 31 December 2013, and 2.5 m⁻¹ (non-turbo) or 3.0 m⁻¹ (turbo) before 1 July 2008. Any visible smoke from a diesel fitted with a particulate filter is a major defect.
The test is done by a trained MOT tester with special equipment. Never sit near a running engine's exhaust.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Marked by Classfern |
| Teaching and hands-on task | 14 min | Not assessed, self-checked |
| Worked examples and guided practice | 9 min | Marked by Classfern |
| Independent practice (three levels) | 13 min | Marked by Classfern |
| Exit ticket and talk question | 5 min | Marked by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all marked instantly.
More practice
More Engines lessons · Motor Vehicle Theory course · All motor mechanics practice tests · Motor Mechanics Department
Sources and curriculum
Facts in this lesson were checked against:
- US Department of Energy, Alternative Fuels Data Center – How do diesel vehicles work?
- DVSA MOT inspection manual: cars and passenger vehicles – 8. Nuisance
Our lessons and questions are our own. They are not written or endorsed by the DVSA, the IMI, City & Guilds, any college, testing agency or exam board.