▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Maths, Cookery, Programming and Art are open – explore →

Fire and explosion: fuel, vapours and hot work – Motor Vehicle Theory motor mechanics lesson

Lesson 5 of 131 in the Motor Vehicle Theory course (ages 16+)

UK version. UK spelling and words (tyre, petrol, bonnet) and UK rules such as the MOT. · US version

Understand why petrol vapour, hot work and fuel tanks cause some of the worst workshop injuries, using the fire triangle and HSE's guidance on fire and explosion.

Time
40 minutes + 10 min homework
Course
Motor Vehicle Theory (ages 16+)
You need
Paper, a pencil and this page. No tools and no vehicle
Marked
Instantly, with explanations

Education and interest only. Classfern teaches motor mechanics as a school subject. It is not a training course or a qualification, and nothing here replaces an IMI or City & Guilds course, an apprenticeship or a qualified technician. Never work on a real vehicle without a qualified adult, the right protective equipment and safe equipment. High-voltage parts of electric and hybrid vehicles are for trained technicians only. Rules and values on this page are given as of November 2026. Always check the current official source (GOV.UK and the DVSA MOT inspection manual) before relying on them.

How to use this lesson

This lesson explains fire science and HSE guidance for understanding only. Learners never handle fuel or do hot work; the activity uses card and paper. Every answer is marked straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “HSE says petrol fires are always serious. Why do you think people still take shortcuts with fuel?”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking the liquid petrol is what burns. It is the vapour that ignites. Liquid petrol gives off vapour all the time.
  • Thinking an empty fuel tank is safe to heat. Vapour and residue remain. HSE describes explosions of tanks that had not been cleaned and gas-freed.
  • Thinking vapour stays near the can. Petrol vapour is heavier than air and can flow along the floor into pits and drains, far from the source.

Hands-on: Draw the fire triangle on card. On each side write two workshop controls from this lesson that remove it. Then draw a plan of a small workshop and mark three places where petrol vapour could collect and three possible ignition sources that must be kept away.

What you will learn

  • I can explain the fire triangle and how controls remove one side of it.
  • I can explain why petrol vapour is so dangerous and where it collects.
  • I can define hot work and list sources of ignition in a workshop.
  • I can explain why fuel tanks can explode during hot work even when 'empty'.
  • I can describe the safer approaches HSE recommends.

Key words

fire triangle
The three things a fire needs: fuel, oxygen and heat.
flammable vapour
A gas given off by a liquid such as petrol that can catch fire when mixed with air.
hot work
Any process that makes flames, sparks or heat, such as welding, grinding or cutting.
fuel retriever
Purpose-made equipment for draining fuel from tanks and lines in a closed system.
gas-freeing
Removing flammable vapour from a tank or container before work.

The big ideas

Petrol is one of the most dangerous substances in a workshop. It gives off vapour even when cold, the vapour is heavier than air, and a tiny spark is enough to ignite it. HSE says petrol fires are always serious and often result in fatal or major injuries, and that most of them involve mishandling petrol when draining fuel tanks and lines.

Hot work – anything that makes flames, sparks or heat – adds another danger. HSE describes explosions of diesel tanks that were thought to be empty but had not been cleaned and gas-freed.

This lesson explains the science and the reasons behind HSE's precautions. It is not a guide to any fuel system work or welding, which are done only by trained technicians. Learners never handle fuel.

Read-through: the teaching steps

  1. The fire triangle

    A fire needs three things at once:

    • fuel – something to burn, such as petrol vapour;
    • oxygen – from the air;
    • heat – an ignition source such as a spark or flame.

    Every fire precaution works by removing one side: keep the fuel contained, keep ignition sources away, or (in special cases) exclude oxygen by inerting.

  2. Why petrol vapour is so dangerous

    Petrol evaporates readily even at low temperatures, so there is almost always flammable vapour above it. The vapour is denser than air: it flows along floors and gathers in low places such as pits and drains, where it can meet an ignition source some distance away. HSE says it is the vapour that ignites and engulfs anybody nearby.

  3. Draining fuel – why it is specialist work

    HSE says most workshop fires involve draining petrol from tanks and lines. Its guidance is to always use a fuel retriever, to never drain petrol over or close to a pit or drain, and to not mix recovered fuel into waste oil storage. These precautions explain why fuel system work is for trained technicians only.

  4. Sources of ignition

    HSE defines hot work as any process that generates flames, sparks or heat. Other ignition sources include a broken inspection lamp, a space heater, electrical faults and smoking. HSE says do not smoke, weld or carry out other hot work while handling petrol or flammable paints and thinners, and never use waste petrol or thinners to light fires.

  5. 'Empty' tanks

    A fuel tank that looks empty still holds vapour and residue. Heating it can turn that into an explosion. HSE says diesel tank failures share one cause: the tanks were not properly cleaned and gas-freed before hot work.

    HSE's safer options: assess first; use cold cutting or cold repair; or replace rather than repair. If hot work is unavoidable, reduce risk by emptying, cleaning, gas-freeing or inerting.

  6. Storage and housekeeping

    HSE says flammable liquids should be stored in a safe place. Good practice is to keep only small quantities in the work area, in closed containers designed for the purpose, away from ignition sources, and to clear up spills and soaked rags promptly. A clean workshop has less fuel for a fire.

The lesson, step by step

40 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minMarked by Classfern
Teaching and hands-on task12 minNot assessed, self-checked
Worked examples and guided practice8 minMarked by Classfern
Independent practice (three levels)11 minMarked by Classfern
Exit ticket and talk question5 minMarked by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all marked instantly.

More practice

More Workshop safety lessons · Motor Vehicle Theory course · All motor mechanics practice tests · Motor Mechanics Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the DVSA, the IMI, City & Guilds, any college, testing agency or exam board.