Exhaust gases: what comes out and why – Motor Vehicle Theory motor mechanics lesson
Lesson 47 of 131 in the Motor Vehicle Theory course (ages 16+)
UK version. UK spelling and words (tyre, petrol, bonnet) and UK rules such as the MOT. · US version
Find out what an engine's exhaust is made of, which parts are harmless and which are pollutants, how each pollutant forms, and how the amounts are measured.
- Time
- 45 minutes + 10 min homework
- Course
- Motor Vehicle Theory (ages 16+)
- You need
- Paper, a pencil and this page. No tools and no vehicle
- Marked
- Instantly, with explanations
Education and interest only. Classfern teaches motor mechanics as a school subject. It is not a training course or a qualification, and nothing here replaces an IMI or City & Guilds course, an apprenticeship or a qualified technician. Never work on a real vehicle without a qualified adult, the right protective equipment and safe equipment. High-voltage parts of electric and hybrid vehicles are for trained technicians only. Rules and values on this page are given as of November 2026. Always check the current official source (GOV.UK and the DVSA MOT inspection manual) before relying on them.
How to use this lesson
This lesson explains what is in engine exhaust. Exhaust contains carbon monoxide, which is poisonous and cannot be seen or smelled: an engine must never be run in an enclosed space, and exhaust testing is for trained staff. Inspection values quoted are dated November 2026. Every answer is marked straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Electric cars have no exhaust. Does that mean they cause no pollution at all? What would you need to know to decide?”
- Later: the homework, then the practice test.
Watch out for
- Thinking that the water dripping from an exhaust is a sign of a leak. Water is a normal product of burning hydrocarbons. It condenses in a cold exhaust and drips out.
- Thinking carbon dioxide and carbon monoxide are the same pollutant. Carbon dioxide comes from complete combustion and is a greenhouse gas. Carbon monoxide comes from incomplete combustion and is poisonous.
- Thinking a leaner mixture always means cleaner exhaust. Lean mixtures cut CO and HC but raise NOx, and very lean mixtures misfire and raise HC again.
Hands-on: Molecule models: make octane, oxygen, carbon dioxide and water molecules from modelling clay balls (black for carbon, white for hydrogen, red for oxygen) and cocktail sticks, and check that the equation 2C₈H₁₈ + 25O₂ → 16CO₂ + 18H₂O has the same number of each atom on both sides. Then make a poster of the four pollutants: how each forms, and one harm each causes. Never stand near a running engine's exhaust or run an engine in a garage: carbon monoxide can kill without warning.
What you will learn
- I can name the main products of complete combustion and the main pollutants in exhaust gas.
- I can explain how carbon monoxide, hydrocarbons, oxides of nitrogen and particulates form.
- I can link mixture strength and combustion temperature to the pollutants produced.
- I can convert between parts per million and percentage.
- I can use a balanced equation to calculate the mass of carbon dioxide made from a mass of fuel.
Key words
- carbon monoxide (CO)
- A poisonous, colourless, odourless gas formed when carbon in the fuel burns without enough oxygen.
- hydrocarbons (HC)
- Unburnt or partly burnt fuel in the exhaust.
- oxides of nitrogen (NOx)
- Gases formed when nitrogen and oxygen from the air combine at very high combustion temperatures.
- particulate matter (PM)
- Tiny solid particles, mainly soot, formed where fuel burns without enough oxygen. Mostly a diesel problem.
- ppm
- Parts per million: a way of giving very small concentrations. 10,000 ppm = 1%.
The big ideas
Petrol and diesel are hydrocarbons: compounds of hydrogen and carbon. If they burned perfectly in exactly the right amount of air, the exhaust would contain only carbon dioxide, water vapour and the nitrogen from the air that took no part. Carbon dioxide is not poisonous in the way the pollutants below are, but it is the main greenhouse gas from road transport, and the only way to make less of it is to burn less fuel.
Real combustion is never perfect. Where there is too little oxygen, some carbon only reaches carbon monoxide and some fuel stays unburnt. Where the flame is very hot, nitrogen and oxygen from the air combine to make oxides of nitrogen. Where fuel droplets burn without enough air, soot forms. The US Department of Energy explains that petrol cars use a three-way catalyst, and diesels use an oxidation catalyst, a particulate filter and selective catalytic reduction, to deal with these pollutants.
This lesson explains the chemistry. Exhaust gas is dangerous: carbon monoxide can kill without warning, so an engine must never be run in an enclosed space, and exhaust testing is done by trained staff with proper extraction.
Read-through: the teaching steps
Complete combustion
When a hydrocarbon burns completely, every carbon atom becomes carbon dioxide and every hydrogen atom becomes water. For octane, a typical petrol molecule:
2C₈H₁₈ + 25O₂ → 16CO₂ + 18H₂O
Air is about four-fifths nitrogen, which mostly passes straight through. So the exhaust of a well-running petrol engine is mostly nitrogen, with carbon dioxide and water vapour – which is why exhaust drips water and steams on a cold day.
Carbon monoxide and hydrocarbons
If there is not enough oxygen – a rich mixture, or poor mixing – some carbon stops at carbon monoxide (CO) instead of carbon dioxide, and some fuel leaves unburnt or part-burnt as hydrocarbons (HC).
Hydrocarbons also come from fuel trapped in tiny gaps near the piston crown and from cold cylinder walls where the flame goes out, which is why emissions are highest just after a cold start.
Carbon monoxide is especially dangerous: it stops blood carrying oxygen, and you cannot see or smell it.
Oxides of nitrogen
Nitrogen does not burn easily, but at the very high temperatures of combustion some nitrogen and oxygen from the air combine to form nitric oxide (NO) and nitrogen dioxide (NO₂), together called NOx.
NOx rises when combustion is hotter and when there is spare oxygen – so lean mixtures, high compression and high load all raise it. NOx harms lungs and helps form smog. It is a particular challenge for diesels, which always run with spare oxygen.
Particulates
In a diesel, fuel is sprayed into hot air and burns at the edge of each droplet. Inside a dense spray there can be too little oxygen, so carbon forms tiny solid particles: soot. Direct-injection petrol engines can make some too.
The smallest particles can travel deep into the lungs. That is why modern diesels, and many direct-injection petrol cars, have particulate filters. Visible black smoke means a lot of soot – something is wrong.
The trade-offs
The pollutants pull in different directions:
- Rich mixture: more CO and HC, less NOx.
- Lean mixture and hot combustion: less CO and HC, more NOx.
- Lower combustion temperature (for example with exhaust gas recirculation): less NOx, but sometimes more soot.
No single setting gives zero of everything, which is why exhaust aftertreatment is needed – and why a petrol engine is held near lambda 1 so its three-way catalyst can clean up CO, HC and NOx together.
Measuring exhaust in the MOT
Gas analysers give CO as a percentage and HC in parts per million. In the MOT basic emissions test for petrol cars with a catalyst (inspection manual section 8, November 2026), CO must be no more than 0.2% at fast idle and 0.3% at normal idle, HC no more than 200 ppm at fast idle, and lambda between 0.97 and 1.03. Diesel cars get a smoke opacity test instead.
Tests are carried out by trained MOT testers with extraction equipment.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Marked by Classfern |
| Teaching and hands-on task | 14 min | Not assessed, self-checked |
| Worked examples and guided practice | 9 min | Marked by Classfern |
| Independent practice (three levels) | 13 min | Marked by Classfern |
| Exit ticket and talk question | 5 min | Marked by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all marked instantly.
More practice
More Fuel, ignition and emissions lessons · Motor Vehicle Theory course · All motor mechanics practice tests · Motor Mechanics Department
Sources and curriculum
Facts in this lesson were checked against:
- US Department of Energy, Alternative Fuels Data Center – How do gasoline cars work?
- US Department of Energy, Alternative Fuels Data Center – How do diesel vehicles work?
- DVSA MOT inspection manual: cars and passenger vehicles – 8. Nuisance
Our lessons and questions are our own. They are not written or endorsed by the DVSA, the IMI, City & Guilds, any college, testing agency or exam board.