Climate control faults: symptoms and causes – Motor Vehicle Theory motor mechanics lesson
Lesson 107 of 131 in the Motor Vehicle Theory course (ages 16+)
UK version. UK spelling and words (tyre, petrol, bonnet) and UK rules such as the MOT. · US version
Learn to link the common heating and air-conditioning complaints – no cooling, weak cooling, smells, noises, water in the cabin and wrong temperatures – to their most likely causes, the way a technician reasons before testing.
- Time
- 45 minutes + 10 min homework
- Course
- Motor Vehicle Theory (ages 16+)
- You need
- Paper, a pencil and this page. No tools and no vehicle
- Marked
- Instantly, with explanations
Education and interest only. Classfern teaches motor mechanics as a school subject. It is not a training course or a qualification, and nothing here replaces an IMI or City & Guilds course, an apprenticeship or a qualified technician. Never work on a real vehicle without a qualified adult, the right protective equipment and safe equipment. High-voltage parts of electric and hybrid vehicles are for trained technicians only. Rules and values on this page are given as of November 2026. Always check the current official source (GOV.UK and the DVSA MOT inspection manual) before relying on them.
How to use this lesson
This lesson teaches diagnostic reasoning for heating and air-conditioning complaints. Refrigerant work is restricted by law to qualified technicians; the activity is a paper chart. Every answer is marked straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “A customer says "the air con doesn't work". What questions would you ask to turn that into a useful description of the fault?”
- Later: the homework, then the practice test.
Watch out for
- Thinking an air-conditioning system needs regular "top-ups" because refrigerant gets used up. Refrigerant circulates in a sealed loop. If it is low there is a leak, which must be found and repaired by a qualified technician.
- Thinking water in the footwell must be a leaking windscreen. A blocked evaporator drain is a common cause: the water removed from the air overflows into the cabin.
- Thinking every weak-cooling fault is inside the refrigerant circuit. A blocked cabin filter, a stuck blend flap or a failed condenser fan can all reduce cooling. A good technician checks the simple causes first.
Hands-on: Make a fault-finding chart. In the first column write six complaints: no cooling, weak cooling, musty smell, sweet smell with misting, water in the footwell, and air from the wrong vents. In the next columns write the likely causes, whether a driver could notice or check it from inside the car, and whether it needs a qualified technician. Paper only; no work on any vehicle.
What you will learn
- I can describe the sensors and actuators in an automatic climate control system.
- I can list likely causes for no cooling, weak cooling, bad smells, noises and water leaks in the cabin.
- I can use temperature readings to judge how well a system is performing.
- I can explain which checks a driver can make and which faults need a qualified technician.
Key words
- automatic climate control
- A system where a control unit reads temperature and sun sensors and adjusts the blower, flaps and air conditioning to hold a set temperature.
- sun load sensor
- A light sensor on top of the dashboard that tells the control unit how much sunshine is heating the cabin.
- evaporator drain
- A small tube that lets condensed water run out of the heater box to the road.
- cabin filter
- A filter in the incoming air that traps dust and pollen. When blocked it reduces airflow.
- vent temperature
- The temperature of the air coming out of the dashboard vents – a simple measure of how well the system is cooling.
The big ideas
Climate control complaints are among the most common reasons a car visits a workshop in summer. They range from simple – a blocked cabin filter or a blown blower fuse – to faults deep inside the sealed refrigerant circuit.
A technician begins the same way every time: confirm the complaint, gather the symptoms, and think about which parts of the system could cause them. Is the problem with the air (blower, filter, flaps), the heat (coolant, heater matrix), the cooling (refrigerant circuit, compressor, condenser fan) or the control (sensors, control unit, actuators)? Only then do they test.
This lesson teaches that reasoning. It is not a repair guide: anything inside the refrigerant circuit needs a technician with an appropriate F-gas qualification, as NetRegs explains, and electric compressors on electric and hybrid vehicles are high-voltage parts for trained technicians only.
Read-through: the teaching steps
Automatic climate control
An automatic system works like any ECU:
- Inputs – cabin temperature sensor, outside air temperature, sun load sensor, evaporator temperature sensor, coolant temperature, refrigerant pressure sensor, and the driver's settings.
- Processing – the control unit works out how much heating or cooling is needed.
- Outputs – blower speed, blend flap and distribution flap actuators, recirculation flap, compressor control and the condenser fan request.
The control unit stores fault codes for failed sensors and actuators, and many have a self-test that a technician can read with a scan tool.
No cooling at all
If the air from the vents is no cooler than outside, likely causes include:
- the compressor is not running – a low refrigerant charge (usually from a leak) makes the low-pressure protection stop it;
- an electrical fault – fuse, relay, compressor clutch or its control signal;
- a pressure sensor fault giving a false reading;
- the blend flap stuck on hot, mixing heat into the cooled air.
Refrigerant does not get "used up". If the charge is low there is a leak, which a qualified technician finds and repairs.
Weak cooling
If the system cools a little but not enough:
- the condenser is blocked with dirt, leaves or insects, or the condenser fan is not running – so the heat cannot escape;
- the refrigerant charge is slightly low;
- the cabin filter is blocked, cutting airflow;
- the expansion device is faulty;
- fresh air is coming in when recirculation is selected, on a very hot day.
Comparing the vent temperature with the outside temperature, under conditions the manufacturer sets, helps a technician judge performance.
Smells, noises and water
- Musty smell when the fan starts – mould on the wet evaporator; a blocked cabin filter makes it worse.
- Sweet smell and misting inside – coolant leaking from the heater matrix.
- Water in the passenger footwell – a blocked evaporator drain, so condensed water overflows into the cabin.
- Grinding or rumbling when the air conditioning is on – a worn compressor or clutch bearing.
- Whistling or rattling from the dashboard – debris in the blower or a broken flap.
A puddle of clear water under the car, from the drain, is normal.
Wrong temperature or wrong vents
- Temperature does not change when the control is moved – blend flap actuator failed, or a cable or linkage broken.
- Air comes from the wrong vents – distribution flap actuator fault.
- One side hot and one side cold on a dual-zone system – one blend flap actuator failed.
- System cools then gets warm after a long drive – the evaporator may be icing up if its temperature sensor fails.
Actuators on modern cars are small electric motors, so many of these faults leave a code in the control unit.
What a driver can do, and what they cannot
A driver can notice symptoms, describe them clearly (when it happens, how it smells or sounds) and check simple things the handbook describes, such as the fuse chart or whether recirculation is selected. A clear description saves the technician time.
Everything else goes to a qualified technician. NetRegs says anyone recovering refrigerant needs an appropriate qualification and abnormal leaks must be fixed before a system is refilled.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Marked by Classfern |
| Teaching and hands-on task | 14 min | Not assessed, self-checked |
| Worked examples and guided practice | 9 min | Marked by Classfern |
| Independent practice (three levels) | 13 min | Marked by Classfern |
| Exit ticket and talk question | 5 min | Marked by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all marked instantly.
More practice
More Heating and air conditioning lessons · Motor Vehicle Theory course · All motor mechanics practice tests · Motor Mechanics Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by the DVSA, the IMI, City & Guilds, any college, testing agency or exam board.