Electrical system: alternator, battery, buses and circuit breakers – Private Pilot Theory aviation lesson
Lesson 159 of 228 in the Private Pilot Theory course (ages 16+)
UK version. UK spelling and units (hPa, metres, litres) and the UK CAA. · US version
See how the alternator, battery, bus bar and circuit breakers fit together, what the ammeter tells the pilot, and why the ignition does not depend on any of it.
- Time
- 45 minutes + 10 min homework
- Course
- Private Pilot Theory (ages 16+)
- You need
- Paper, a pencil and this page
- Marked
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an approved training organisation, and nothing here counts towards a pilot licence or replaces a CAA-approved course and the CAA’s own exams. Rules and values on this page are given as of November 2026. Always check the current official source (the UK CAA) before relying on them.
How to use this lesson
This is adult-level theory (16+). Read it alongside the official handbooks; it is explanation for understanding, not training. Every answer is marked straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Why do you think aircraft designers kept the ignition completely separate from the main electrical system?”
- Later: the homework, then the practice test.
Watch out for
- Thinking the master switch controls the ignition. The handbook says the master powers all circuits except the ignition; the magnetos are independent.
- Reading a plus ammeter as a fault. A plus reading normally shows the battery charging; only a full-scale plus indicates a regulator fault.
- Dividing voltage by power. Current = power ÷ voltage.
Hands-on: Look at the label on a phone charger or bulb packet: find the watts and volts, then work out the current with I = P ÷ V. Draw a simple diagram of a battery, a "bus bar" strip and three bulbs, each with its own fuse.
What you will learn
- I can name the main parts of a light-aircraft electrical system.
- I can explain what the master switch does and does not power.
- I can read an ammeter and a loadmeter.
- I can explain the job of fuses and circuit breakers.
- I can calculate the current drawn by electrical loads.
Key words
- alternator
- A device driven by the piston engine that supplies electrical power and charges the battery.
- bus bar
- A common connection that distributes power to the electrical circuits.
- circuit breaker
- A switch that opens automatically on overload and can be reset by hand.
- ammeter
- Shows current flowing into or out of the battery.
- loadmeter
- Shows the load on the alternator as a percentage of its capacity.
The big ideas
Most light aircraft use a 14-volt or 28-volt direct-current system, says the PHAK (chapter 7). An alternator driven by the piston engine supplies power and keeps the battery charged; the handbook notes that alternators supply enough current even at low rpm. A 12-volt battery, for example, is kept charged by a system running at about 14 volts.
Power is distributed through a bus bar to the individual circuits. Each circuit is protected by a fuse or circuit breaker; circuit breakers can be reset by hand. The master switch turns on all the electrical circuits except the ignition, because the magnetos are independent. A separate alternator switch can take the alternator off line.
An ammeter shows whether the battery is charging (plus) or discharging (minus); a loadmeter shows the load on the alternator as a percentage. The UK Skyway Code notes that after an electrical failure the battery may last only about 20 minutes. This is theory for understanding only.
Read-through: the teaching steps
14 or 28 volts
Most light aircraft use a 14-volt or 28-volt DC system. A 12-volt battery is fed by a system at about 14 volts so that it charges.
Alternator and battery
The alternator, driven by the piston engine, supplies the electrical loads and recharges the battery. The battery starts the piston engine and is the reserve if the alternator fails.
Bus bar and protection
The bus bar shares power out to the circuits – radios, lights, instruments. Each has a fuse or circuit breaker that opens if too much current flows. Circuit breakers can be reset by hand.
Master and alternator switches
The master switch powers all circuits except the ignition. The alternator switch lets the pilot remove the alternator from the system.
Reading the ammeter and loadmeter
Ammeter (from the handbook):
- plus – battery charging
- full-scale minus – alternator malfunction
- full-scale plus – regulator malfunction
Loadmeter: total load as a percentage of the alternator's capacity.
Working out current
Electrical power P = voltage V × current I, so I = P ÷ V. A 70-watt landing light on a 14-volt system draws 70 ÷ 14 = 5 amps.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Marked by Classfern |
| Teaching and hands-on task | 14 min | Not assessed, self-checked |
| Worked examples and guided practice | 9 min | Marked by Classfern |
| Independent practice (three levels) | 13 min | Marked by Classfern |
| Exit ticket and talk question | 5 min | Marked by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all marked instantly.
More practice
More Aircraft General Knowledge lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by the CAA, any flying school, testing agency or exam board.