▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Maths, Cookery, Programming and Art are open – explore →

Airspace design: airways, SIDs and STARs – Navigation and Technology aviation lesson

Lesson 26 of 90 in the Navigation and Technology course (ages 14+)

UK version. UK spelling and units (hPa, metres, litres) and the UK CAA. · US version

The sky above a busy airport is not a free-for-all. It is designed like a road network, with motorway-style airways, set 'slip roads' out of the airport (SIDs) and set routes in (STARs). Find out how these routes keep traffic flowing safely and what airspace modernisation is trying to change.

Time
40 minutes + 10 min homework
Course
Navigation and Technology (ages 14+)
You need
Paper, a pencil and this page
Marked
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an approved training organisation, and nothing here counts towards a pilot licence or replaces a CAA-approved course and the CAA’s own exams.

How to use this lesson

Sources: FAA AIM chapter 5 (instrument departures and standard terminal arrivals); UK CAA Skyway Code (airspace classes). The '3 NM per 1,000 ft' figure is a rough rule of thumb used for the sum only. Every answer is marked straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “New flight paths can save fuel but may send aircraft over homes that were quiet before. Who should decide where flight paths go, and how?”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking aircraft can fly anywhere they like near a busy airport. Around busy airports, controlled airspace and published routes keep traffic organised.
  • Mixing up SIDs and STARs. SID = departure (going out); STAR = arrival (coming in).
  • Thinking all airspace is controlled. Class G is uncontrolled; pilots there rely mainly on see and avoid.

Hands-on: Draw a map of an imaginary airport with one runway. Add a hill to the north and a town to the east. Design one departure route (SID) and one arrival route (STAR) that avoid the hill, keep away from each other and avoid flying low over the town. Explain your choices to someone else.

What you will learn

  • I can explain what controlled airspace, airways, SIDs and STARs are.
  • I can explain why standard departure and arrival routes reduce workload and radio calls.
  • I can describe how the UK divides its airspace into classes.
  • I can work out descent and climb sums used in route design.

Key words

airway
A corridor of controlled airspace joining busy areas, like a motorway in the sky.
SID
Standard Instrument Departure – a published route from the runway to the airway network.
STAR
Standard Terminal Arrival Route – a published route from the airway network towards the approach to the runway.
controlled airspace
Airspace where air traffic control gives clearances and keeps certain aircraft apart.
airspace class
A letter (A to G) showing what rules and services apply in a piece of airspace.

The big ideas

Around busy airports the airspace is carefully designed. Airways – corridors of controlled airspace – link one busy area to another, much like motorways. Leaving an airport, aircraft follow a Standard Instrument Departure (SID): a published route from the runway up to the airway network. Arriving, they follow a Standard Terminal Arrival Route (STAR) from the airways down towards the approach to the runway. The FAA's Aeronautical Information Manual (AIM) explains that SIDs are designed mainly to make the system work better and to reduce pilot and controller workload, cutting radio calls and delays, while also giving clearance from obstacles. STARs streamline clearances and join the en route network to the approach.

Airspace is also sorted into classes. The CAA's Skyway Code explains that the UK uses classes A, C, D, E and G. Class A is for IFR flights only; class C needs a clearance for both IFR and VFR; class D, which covers most airport control zones, needs a clearance; class E does not need a clearance for VFR flights; and class G is uncontrolled. Many UK airways are class A.

Much of this design is decades old, built around ground beacons. Today, satellite-based routes (performance-based navigation) allow SIDs and STARs to be placed more precisely, and the UK is redesigning its airspace in a long-running modernisation programme. The aims include fewer delays, less fuel burnt and, where possible, less noise for people living below.

Read-through: the teaching steps

  1. Roads in the sky

    Airways link busy regions, like main roads between cities. Inside them, air traffic control gives clearances and keeps aircraft apart. Routes are defined by beacons (as in the VOR drawing on the lesson page) or by satellite waypoints.

    090 radial360
    A VOR radial is a magnetic bearing FROM the beacon. The 090 radial runs east from the beacon.
  2. SIDs: the slip roads out

    A SID is a published route from a runway to the airway network.

    • It keeps departing aircraft clear of obstacles.
    • It keeps them clear of arrivals and other airports' traffic.
    • Because it is published, the controller can say just its name instead of a long list of instructions.
  3. STARs: the slip roads in

    A STAR brings aircraft from the airways towards the approach. Many include heights and speeds at certain points, so arriving aircraft are lined up in an orderly stream, a bit like cars merging in turn.

  4. Fewer words on the radio

    Imagine a busy airport with an aircraft leaving every two minutes. If each needed ten separate radio instructions, the frequency would be jammed. A named SID or STAR packs all those instructions into one short phrase – that is why the AIM says they reduce workload and communications.

  5. Airspace classes

    The Skyway Code lists the UK classes:

    • A – IFR only
    • C – IFR and VFR, clearance needed
    • D – clearance needed (most airport control zones)
    • E – no clearance needed for VFR
    • G – uncontrolled

    The letter tells pilots which rules and services apply.

  6. Redesigning the sky

    Old routes zig-zagged between beacons. Satellite navigation lets designers draw smoother, more precise routes, including continuous climbs and descents that save fuel. But concentrating routes can also concentrate noise over the same homes, so redesign involves public consultation and difficult trade-offs.

The lesson, step by step

40 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minMarked by Classfern
Teaching and hands-on task12 minNot assessed, self-checked
Worked examples and guided practice8 minMarked by Classfern
Independent practice (three levels)11 minMarked by Classfern
Exit ticket and talk question5 minMarked by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all marked instantly.

More practice

More Air traffic & surveillance lessons · Navigation and Technology course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the CAA, any flying school, testing agency or exam board.