▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Maths, Cookery, Programming and Art are open – explore →

Piston engines in light aircraft – Ground School Basics aviation lesson

Lesson 18 of 90 in the Ground School Basics course (ages 11–16)

UK version. UK spelling and units (hPa, metres, litres) and the UK CAA. · US version

Most small aeroplanes use a piston engine much like a car's. Learn the four-stroke cycle, why aircraft have two of everything in the ignition, and what carburettor icing and detonation are.

Time
50 minutes + 10 min homework
Course
Ground School Basics (ages 11–16)
You need
Paper, a pencil and this page
Marked
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an approved training organisation, and nothing here counts towards a pilot licence or replaces a CAA-approved course and the CAA’s own exams.

For parents: how to use this lesson

Theory for understanding only. Carburettor icing figures are general guidance from the US handbook; real decisions follow each aircraft's own documents. Every answer is marked straight away with a worked explanation.

  1. Read what your child will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “Why do you think aircraft piston engines are designed with 'two of everything' in the ignition, when most car piston engines are not?”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking carburettor ice only forms below freezing. The air in the carburettor is cooled sharply, so ice can form on mild, damp days well above freezing outside.
  • Thinking the piston engine stops if the battery fails. Magnetos make their own electricity, so the ignition does not depend on the battery.
  • Mixing up detonation and pre-ignition. Detonation is an explosive burn after the spark; pre-ignition is the mixture lighting before the spark from a hot spot.

Hands-on: Make a model piston: a cardboard tube as the cylinder and a smaller roll of card as the piston. Move it through the four strokes and say each name aloud: suck, squeeze, bang, blow.

What your child will learn

  • I can describe the four strokes: intake, compression, power, exhaust.
  • I can explain why aircraft piston engines have dual magneto ignition.
  • I can explain the jobs of the oil.
  • I can explain why the fuel mixture must be adjusted as altitude changes.
  • I can describe carburettor icing, detonation and pre-ignition.

Key words

four-stroke cycle
The repeating sequence in each cylinder: intake, compression, power and exhaust.
magneto
A device driven by the piston engine that makes its own electricity for the spark plugs, independent of the aircraft's battery.
mixture
The ratio of fuel to air going into the cylinders.
carburettor icing
Ice forming inside the carburettor because fuel evaporating and the pressure drop in the venturi cool the air sharply.
detonation
Uncontrolled, explosive burning of the fuel–air charge, instead of a smooth burn, which can damage the piston engine.

The big ideas

Most light aeroplanes are powered by a piston engine that turns a propeller. Like a car's, it works on a four-stroke cycle. On the intake stroke the piston moves down and draws in a mixture of fuel and air. On the compression stroke it moves up and squeezes the mixture. A spark then ignites it and the hot gases push the piston down on the power stroke. Finally, on the exhaust stroke the piston rises and pushes the burnt gases out.

Aircraft piston engines are built for reliability. The sparks come from magnetos, which make their own electricity, so the piston engine keeps running even if the aircraft's battery and electrical system fail. There are two magnetos and two spark plugs in every cylinder – dual ignition – for safety and a better burn. Oil lubricates the moving parts, carries heat away, helps seal the piston rings and carries dirt to the filter.

The air gets thinner with height, so the fuel-to-air mixture would become too rich; it must be leaned as the aeroplane climbs. In a carburettor, evaporating fuel and the drop in pressure in its narrow venturi can cool the air sharply, so ice can form even on a mild, damp day. Getting the burn wrong can cause detonation (an explosive burn at high power and temperature) or pre-ignition (the charge lighting early from a hot spot). The octane rating of fuel tells you how well it resists detonation.

Read-through: the teaching steps

  1. Suck, squeeze, bang, blow

    • Intake – piston down, fuel–air mixture drawn in
    • Compression – piston up, mixture squeezed
    • Power – spark ignites the mixture, hot gas pushes the piston down
    • Exhaust – piston up, burnt gas pushed out

    The pistons turn a crankshaft, which turns the propeller.

  2. Two magnetos, two plugs

    Magnetos make their own electricity, independent of the battery. With two magnetos and two spark plugs per cylinder, one can fail and the piston engine still runs. Two sparks also burn the mixture more completely.

  3. What the oil does

    • Lubricates and reduces friction
    • Removes heat
    • Helps seal the piston rings against the cylinder walls
    • Carries dirt away to the filter
  4. Mixture and altitude

    Thinner air at height means less air for the same fuel, so the mixture becomes too rich. It is leaned (less fuel) as the aeroplane climbs. A mixture that is too lean, especially at high power, can lead to detonation.

  5. Carburettor icing

    Fuel evaporating and the pressure drop in the venturi can cool the air in a carburettor by over 30 °C. Icing is most likely below about 21 °C with humidity above 80%, but it can happen up to about 38 °C with humidity as low as 50%. Carburettor heat melts the ice but can reduce power by up to 15%.

  6. Detonation and pre-ignition

    Detonation is an explosive, uncontrolled burn, most likely at high power with very hot cylinders. Pre-ignition is the mixture lighting before the spark, from a hot spot such as a glowing carbon deposit. Higher-octane fuel resists detonation better.

The lesson, step by step

50 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minMarked by Classfern
Teaching and hands-on task15 minNot assessed, self-checked
Worked examples and guided practice10 minMarked by Classfern
Independent practice (three levels)16 minMarked by Classfern
Exit ticket and talk question5 minMarked by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all marked instantly.

More practice

More Power: propellers and jets lessons · Ground School Basics course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the CAA, any flying school, testing agency or exam board.