The alternator: charging while you drive – Garage Basics motor mechanics lesson
Lesson 38 of 70 in the Garage Basics course (ages 11–16)
US version. US spelling and words (tire, gasoline, hood) and US rules such as state inspections. · UK version
Find out how the alternator uses a spinning magnet to make electricity, how it keeps the battery charged, and what the charge warning light means.
- Time
- 40 minutes + 10 min homework
- Course
- Garage Basics (ages 11–16)
- You need
- Paper, a pencil and this page. No tools and no vehicle
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches motor mechanics as a school subject. It is not a training program or a certification, and nothing here replaces an accredited automotive program, ASE certification or a qualified technician. Never work on a real vehicle without a qualified adult, the right protective equipment and safe equipment. High-voltage parts of electric and hybrid vehicles are for trained technicians only.
For parents: how to use this lesson
The bicycle activity should be supervised. A real car alternator is driven by a fast-moving belt and should never be touched when the engine is running. Every answer is graded straight away with a worked explanation.
- Read what your child will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Why do you think a car's headlights might dim slightly at tickover on some older cars, but brighten when the engine revs?”
- Later: the homework, then the practice test.
Watch out for
- Thinking the alternator makes energy from nothing. It converts movement energy from the engine into electrical energy, so the engine uses a little extra fuel.
- Thinking the alternator gives out DC straight away. The stator makes AC; the rectifier diodes turn it into DC.
- Thinking a car with the charge light on will keep running normally. It runs on the battery until the battery is flat. It needs checking soon.
Hands-on: With an adult, look at a bicycle dynamo light set (a hub or bottle dynamo) on a bicycle held steady upside down. Turn the wheel slowly, then faster, and watch the lamp get brighter. Keep fingers away from the spokes. If you have a coil of wire, a magnet and a small meter at school, push the magnet in and out of the coil and watch the needle move.
What your child will learn
- I can explain that moving a magnet near a coil of wire induces a voltage.
- I can describe the main parts of an alternator.
- I can explain why the alternator's output is changed from AC to DC and kept at about 14 V.
- I can calculate alternator speed from pulley sizes and its power output.
- I can explain what the charge warning light tells the driver.
Key words
- alternator
- A machine driven by the engine that turns movement energy into electrical energy to charge the battery and run the car's electrics.
- electromagnetic induction
- Making a voltage in a wire by moving a magnet near it, or moving the wire near a magnet.
- rectifier
- A set of diodes that changes alternating current (AC) into direct current (DC).
- voltage regulator
- A circuit that controls the alternator so the system voltage stays at about 14 V.
- drive belt
- A rubber belt that carries turning from the crankshaft pulley to the alternator and other parts.
The big ideas
A battery on its own would soon go flat. Once the engine is running, the alternator takes over. Driven by a belt from the crankshaft, it turns some of the engine's movement energy into electrical energy. It supplies the lights, fans and electronics, and recharges the battery after starting.
The alternator works by electromagnetic induction, discovered by Michael Faraday in 1831. When a magnet moves near a coil of wire, a voltage is induced in the coil. Inside the alternator, a spinning electromagnet (the rotor) turns inside fixed coils (the stator). Because the magnet's poles keep passing the coils, the current flows one way and then the other: alternating current (AC). A rectifier made of diodes changes this to direct current (DC) for the car's 12-volt system, and a voltage regulator keeps the voltage at about 14 V whatever the engine speed.
If the charge warning light comes on while driving, the battery may not be charging. The car will run on its battery for a while, but it will soon go flat, so it needs checking by a technician.
Read-through: the teaching steps
Induction
Move a magnet in and out of a coil of wire connected to a meter, and the needle flicks: a voltage is induced. Move it faster, or use a stronger magnet or more turns of wire, and the voltage is bigger. Stop moving and the voltage stops.
A simple lighting circuit. On a car the metal body is the return path (ground). Inside the alternator
- The rotor: a coil on the spinning shaft that becomes an electromagnet when a small current flows through it.
- The stator: three sets of fixed coils around the rotor where the voltage is induced.
- The rectifier: diodes that turn AC into DC.
- The regulator: controls the rotor current to hold the output at about 14 V.
AC to DC
As the rotor spins, its north and south poles pass each stator coil in turn, so the induced current keeps reversing: AC. The battery and electronics need current that flows one way only, DC. Diodes let current through in one direction only, so the rectifier turns the AC into DC.
Belt and pulleys
The crankshaft pulley is bigger than the alternator pulley, so the alternator spins faster than the engine:
alternator speed = engine speed × (crank pulley diameter ÷ alternator pulley diameter)
That way it can charge even when the engine is ticking over.
Power output
Alternator power = voltage × current. A typical car alternator might supply around 100 A at about 14 V, which is 1,400 W. The energy comes from the engine, which uses a little more fuel when the electrical load is high.
The warning light
The charge warning light comes on with the ignition and should go out once the engine starts. If it lights while driving, the alternator may not be charging (perhaps a broken drive belt or an alternator fault) and the car is running on the battery alone. A technician should check it. In hybrid cars, the motor working as a dynamo also charges the traction battery when braking.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 12 min | Not assessed, self-checked |
| Worked examples and guided practice | 8 min | Graded by Classfern |
| Independent practice (three levels) | 11 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Electricity in the car lessons · Garage Basics course · All motor mechanics practice tests · Motor Mechanics Department
Sources and curriculum
Facts in this lesson were checked against:
- US Department of Energy, Alternative Fuels Data Center – How do gasoline cars work?
- US Department of Energy, Alternative Fuels Data Center – How do hybrid electric cars work?
Our lessons and questions are our own. They are not written or endorsed by ASE, NHTSA, any state agency, any college, testing agency or exam board.