Checking engine oil: the dipstick – Garage Basics motor mechanics lesson
Lesson 50 of 70 in the Garage Basics course (ages 11–16)
US version. US spelling and words (tire, gasoline, hood) and US rules such as state inspections. · UK version
Find out what engine oil does, how the dipstick shows the oil level, why the car must be level and the engine cool, and what the color and level of the oil can tell a mechanic.
- Time
- 35 minutes + 10 min homework
- Course
- Garage Basics (ages 11–16)
- You need
- Paper, a pencil and this page. No tools and no vehicle
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches motor mechanics as a school subject. It is not a training program or a certification, and nothing here replaces an accredited automotive program, ASE certification or a qualified technician. Never work on a real vehicle without a qualified adult, the right protective equipment and safe equipment. High-voltage parts of electric and hybrid vehicles are for trained technicians only.
For parents: how to use this lesson
Please do any real oil check yourself, with the car parked on level ground, switched off and cool, following the owner's manual. Keep used oil off the skin – HSE warns that frequent contact can cause dermatitis. Every answer is graded straight away with a worked explanation.
- Read what your child will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Many new cars now show the oil level on a screen and have no dipstick. What are the good and bad points of that?”
- Later: the homework, then the practice test.
Watch out for
- Checking the oil on a slope. On a slope the oil gathers at one end of the oil pan, so the reading is wrong. Always use level ground.
- Thinking more oil is always better. Above the maximum mark, oil can be whipped into foam and pushed past seals. The level should be between the marks.
- Thinking black oil always means something is wrong. Oil darkens as it collects soot, especially in diesels. Milky oil, or oil that drops quickly, is the warning sign.
Hands-on: Make a model dipstick: stand a tall jar on a table and pour in water to a few centimeters. Mark a strip of card with "min" and "max" lines 2 cm apart near its bottom end. Dip it, read the level, then tilt the jar and dip again to see why level ground matters. Watch a qualified adult check a real car's oil only with the car parked, switched off and cool, and do not touch the oil.
What your child will learn
- I can list four jobs that engine oil does.
- I can explain how a dipstick shows the oil level between its minimum and maximum marks.
- I can explain why the car must be on level ground with the engine switched off and settled.
- I can explain why both too little and too much oil are a problem.
Key words
- dipstick
- A long, thin metal or plastic rod that reaches down into the oil in the oil pan. Marks near its tip show the minimum and maximum oil levels.
- oil pan
- The pan at the bottom of the engine where the oil collects when the engine is not running.
- lubricate
- To put a slippery layer between moving parts so they slide easily and do not wear each other away.
- viscosity
- How thick or runny a liquid is. Oil grades such as 5W-30 describe viscosity.
The big ideas
Inside a running engine, metal parts slide and spin against each other thousands of times a minute. Without oil they would heat up, wear and seize in minutes. Engine oil keeps a thin film between the parts, carries heat away, picks up dirt and helps the piston rings seal.
The oil is kept in the oil pan at the bottom of the engine. A pump pushes it round the engine while it runs, and it drains back when the engine stops. The dipstick lets someone see how much oil is in the oil pan. Engine oil is one of the regular checks a driver should make, and the owner's manual says how often and how.
This lesson explains how the check works. Young people should only watch a qualified adult check the oil: the engine must be switched off and cool, and used oil should not touch the skin.
Read-through: the teaching steps
Four jobs of engine oil
- Lubricate – a thin film stops metal rubbing on metal.
- Cool – oil carries heat away from hot parts such as the pistons and bearings.
- Clean – it picks up tiny bits of metal and soot and carries them to the oil filter.
- Seal – it helps the piston rings seal against the cylinder walls.
See the engine in the drawing on the lesson page.
The four-stroke cycle: intake, compression, power, exhaust. The crankshaft turns twice for the four strokes. How a dipstick works
The dipstick slides down a tube into the oil pan. When it is pulled out, the oil leaves a wet mark on it. Near the tip are two marks – minimum and maximum – or a shaded band between them.
The level should be between the two marks. On many cars, the gap between the marks is roughly one liter of oil, but the owner's manual gives the exact figure. Some modern cars have an electronic oil level sensor and show the level on the dashboard instead.
Why level and settled matters
The oil must be measured with the car on level ground. On a slope, the oil gathers at one end of the oil pan and the reading is wrong.
The engine should be switched off and left for the time the owner's manual says, so the oil has drained back into the oil pan. A reading taken straight after stopping can look too low, because some oil is still up in the engine.
Reading the dipstick
A mechanic usually pulls the dipstick out, wipes it clean, pushes it fully back in, then pulls it out again to read the level. The first pull can show splashes higher up the stick.
The oil's look gives clues too:
- golden brown and clear – fairly fresh oil;
- dark and black – used oil, normal as it collects soot, especially in diesels;
- milky or creamy – may mean coolant is getting into the oil, which needs a mechanic at once.
Too little or too much
Too little oil means parts are not protected, run hot and wear quickly. If the oil pressure warning light comes on while driving, the driver should stop safely and switch off.
Too much oil is also a problem. The spinning crankshaft can whip it into foam, which does not lubricate properly, and the pressure can push oil past seals. That is why oil is never filled above the maximum mark.
Staying safe
An engine that has just been running is hot, and so is its oil. The cooling fan can start on its own even with the engine switched off on some cars. HSE warns that frequent, prolonged skin contact with used engine oil can cause dermatitis and other skin problems, which is why mechanics wear gloves.
So young people watch, and a qualified adult does the check with the car parked, switched off and cool.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 11 min | Not assessed, self-checked |
| Worked examples and guided practice | 7 min | Graded by Classfern |
| Independent practice (three levels) | 8 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Looking after a car lessons · Garage Basics course · All motor mechanics practice tests · Motor Mechanics Department
About this lesson
Our lessons and questions are our own. They are not written or endorsed by ASE, NHTSA, any state agency, any college, testing agency or exam board.