Airspace classes A–G as used in the US – Private Pilot Theory aviation lesson
Lesson 12 of 228 in the Private Pilot Theory course (ages 16+)
US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version
US airspace uses Classes A, B, C, D, E and G, each with its own shape and entry rules. Learn the 'wedding cake' of Class B, the typical size of Class C and D, where Class E begins, and what a VFR pilot needs to enter each.
- Time
- 40 minutes + 10 min homework
- Course
- Private Pilot Theory (ages 16+)
- You need
- Paper, a pencil and this page
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test. Rules and values on this page are given as of November 2026. Always check the current official source (the FAA) before relying on them.
How to use this lesson
This is adult-level theory (16+). It is not for planning real flights – real airspace must be checked on current charts. Every answer is graded straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Why does the busiest airspace (Class B) need a clearance, while Class C and D only need radio contact?”
- Later: the homework, then the practice test.
Watch out for
- Thinking two-way radio contact is enough to enter Class B. Class B needs an actual clearance. Radio contact is the rule for C and D.
- Forgetting that Class C and D heights are above airport elevation. Add the airport elevation to get the top in feet MSL.
- Assuming Class E always starts at 14,500 ft. Class E often begins at 700 ft or 1,200 ft AGL – check the chart vignettes.
Hands-on: Stack three paper plates of different sizes upside down to make a 'wedding cake' Class B. Label each layer with a floor and ceiling, then add a 30 NM circle on paper underneath for the Mode C veil.
What you will learn
- I can list the US airspace classes and say which are controlled.
- I can state the entry requirement for Class B, C and D.
- I can describe the typical dimensions of Class C and Class D.
- I can explain where Class A begins and where Class E floors start.
Key words
- Class B
- Airspace around the busiest airports, shaped like an upside-down wedding cake; an ATC clearance is needed to enter.
- Class C
- Airspace around busy airports with a tower and radar; two-way radio contact must be established before entry.
- Class D
- Airspace around smaller towered airports; two-way radio contact must be established before entry.
- Class E
- Controlled airspace that is not A, B, C or D; no specific entry requirement for VFR.
- Mode C veil
- The area within 30 NM of the primary Class B airports where an altitude-reporting transponder is required, surface to 10,000 ft MSL.
The big ideas
ICAO defines seven airspace classes, and each country chooses which to use. The FAA's Aeronautical Information Manual (AIM, chapter 3, as of November 2026) describes US Classes A, B, C, D, E and G.
Class A runs from 18,000 ft MSL up to and including FL600 and is IFR only. Class B surrounds the busiest airports, generally from the surface to 10,000 ft MSL, in layers like an upside-down wedding cake; an ATC clearance is required to enter, whatever the weather, and a transponder with altitude reporting and ADS-B Out is needed. Within 30 NM of the primary Class B airports (the Mode C veil), an altitude-reporting transponder is required from the surface to 10,000 ft MSL (14 CFR 91.215). Class C is generally from the surface to 4,000 ft above the airport elevation, typically a 5 NM core and a 10 NM shelf starting no lower than 1,200 ft; two-way radio communication must be established before entering. Class D is generally from the surface to 2,500 ft above the airport elevation around towered airports, and two-way radio communication must be established before entry.
Class E is controlled airspace that is not A–D: over the 48 contiguous states it covers 14,500 ft MSL up to (not including) 18,000 ft MSL, and transition areas begin at 700 ft AGL (magenta vignette on charts) or 1,200 ft AGL (blue vignette). Class G is the uncontrolled airspace beneath. Education only – current charts are the authority.
Read-through: the teaching steps
The US classes
The AIM describes Classes A, B, C, D, E and G. A–E are controlled; G is uncontrolled. Compared with the UK, the US uses Class B (the UK does not).
Class A
From 18,000 ft MSL up to and including FL600. IFR only, unless otherwise authorized. Above FL600 the airspace is Class E.
Class B: the wedding cake
Around the busiest airports, generally surface to 10,000 ft MSL, in a surface area plus two or more layers.
- Entry: an ATC clearance, regardless of weather
- Equipment: two-way radio; transponder with altitude reporting; ADS-B Out
- Mode C veil: altitude-reporting transponder within 30 NM, surface to 10,000 ft MSL
Class C and Class D
- Class C: generally surface to 4,000 ft above airport elevation; typical 5 NM core and 10 NM shelf from no lower than 1,200 ft. Two-way radio contact established before entry; transponder with altitude reporting and ADS-B Out.
- Class D: generally surface to 2,500 ft above airport elevation, tailored to each towered airport. Two-way radio contact established before entry.
- Speed (both): at or below 2,500 ft above the surface within 4 NM of the primary airport, no more than 200 kt IAS unless ATC authorizes otherwise.
Class E and Class G
Class E is controlled airspace not designated A–D. Over the 48 contiguous states it runs from 14,500 ft MSL to below 18,000 ft MSL, but often comes much lower: transition areas start at 700 ft AGL (magenta vignette) or 1,200 ft AGL (blue vignette). Class G is uncontrolled airspace underneath – no ATC clearance or contact is needed.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 12 min | Not assessed, self-checked |
| Worked examples and guided practice | 8 min | Graded by Classfern |
| Independent practice (three levels) | 11 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Air Law lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
- FAA Aeronautical Information Manual
- 14 CFR Part 91 General operating and flight rules
- UK CAA Skyway Code
Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.