▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Math, Cookery, Programming and Art are open – explore →

Airframe contamination: frost, ice and snow on the ground – Private Pilot Theory aviation lesson

Lesson 39 of 228 in the Private Pilot Theory course (ages 16+)

US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version

A thin layer of frost can look harmless, yet it can stop a wing producing the lift it was designed for. Learn why the guidance in both the UK and the US is that wings must be completely clean before flight.

Time
30 minutes + 10 min homework
Course
Private Pilot Theory (ages 16+)
You need
Paper, a pencil and this page
Graded
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test. Rules and values on this page are given as of November 2026. Always check the current official source (the FAA) before relying on them.

How to use this lesson

This is adult-level theory (16+). It explains published safety guidance for understanding; it is not flight instruction. Every answer is graded straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “Why might someone be tempted to take off with 'just a bit' of frost, and how could good planning remove that temptation?”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking a light frost is too thin to matter. AC 91-74B says even a thin, rough layer on the leading edge can raise the stall speed.
  • Thinking ice is dangerous mainly because of its weight. The main danger is the changed airflow: less lift, more drag.
  • Clearing the wings but forgetting the pitot and static ports. Blocked probes give false airspeed and altitude readings.

Hands-on: Hold a piece of paper by one edge just below your lower lip and blow over the top – it rises. Now crumple a second sheet and flatten it out again so it is rough, and try the same. Does the rough sheet behave differently? Discuss how roughness affects smooth airflow.

What you will learn

  • I can explain how frost, ice and snow change the airflow over a wing.
  • I can describe the effects of contamination on maximum lift, drag and stall speed.
  • I can state the UK and US guidance on contamination before flight.
  • I can explain why other parts – pitot, static ports, propeller spinner – also matter.

Key words

contamination
Frost, ice, snow or slush stuck to the aircraft's surfaces.
frost
A thin, rough layer of ice crystals that forms on a cold surface, often overnight.
maximum lift (CLmax)
The most lift a wing can make before it stalls.
stall speed
The speed below which the wing cannot produce enough lift to support the aircraft.

The big ideas

A wing makes lift because air flows smoothly over its carefully shaped surface. Frost, ice or snow roughens that surface and can change its shape, so the airflow separates sooner. The FAA's Advisory Circular 91-74B (checked November 2026) says contamination can reduce a wing's maximum lift significantly – a 30 % reduction is not unusual – and increase drag, with a 100 % increase not unusual. It adds that even a thin, rough layer on the leading edge can increase the stall speed.

The guidance on both sides of the Atlantic is the same in spirit. The CAA's Skyway Code says: 'Always remove any frost, ice or snow from the aircraft before flight', and reminds pilots that the pitot probe and static ports must be kept clear too. The FAA's Aeronautical Information Manual (chapter 7) says lifting surfaces should be completely free of contamination before take-off.

The problem is not the weight of the ice – it is the change to the airflow. A wing that looks only slightly frosted may stall at a higher speed than the pilot expects, and the aircraft may need a much longer run to get airborne, or may not climb away at all. This lesson explains the science for understanding; it is not flight instruction.

Read-through: the teaching steps

  1. Smooth air makes lift

    Lift depends on air following the curved upper surface of the wing. Roughness makes the thin layer of air next to the surface lose energy, so the flow breaks away from the wing earlier.

    Relative airflowAngle of attackLeading edgeTrailing edgeCamber line (dashed)Chord line
    An airfoil: the chord line joins the leading and trailing edges; the angle of attack is between the chord line and the relative airflow.
  2. What contamination does

    AC 91-74B describes:

    • lower maximum lift (30 % reduction not unusual)
    • more drag (100 % increase not unusual)
    • a higher stall speed, even from a thin rough layer on the leading edge

    NASA tests found that 2 minutes of clear icing could cut maximum lift by 25–30 % and double drag.

  3. Remove it all

    The Skyway Code's message is simple: always remove frost, ice or snow before flight. The FAA's AIM says lifting surfaces should be completely free of contamination. 'Nearly clean' is not the standard.

  4. Not just the wings

    The Skyway Code reminds pilots to keep the pitot probe and static ports clear – blocked, they give false airspeed and altitude readings. The FAA's flying handbook notes that even a little ice or snow inside a propeller spinner can cause damaging vibration.

  5. Cold-weather icing range

    The Skyway Code notes that airframe icing is most severe between 0 °C and –15 °C. On the ground, frost forms on clear, cold nights when surfaces cool below freezing – even if the air temperature is a little above.

The lesson, step by step

30 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minGraded by Classfern
Teaching and hands-on task9 minNot assessed, self-checked
Worked examples and guided practice6 minGraded by Classfern
Independent practice (three levels)6 minGraded by Classfern
Exit ticket and talk question5 minGraded by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all graded instantly.

More practice

More Operational Procedures lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.