Why are windows round and why do wings flex? – Navigation and Technology aviation lesson
Lesson 81 of 90 in the Navigation and Technology course (ages 14+)
US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version
Two everyday puzzles from an airliner seat: why the windows have rounded corners, and why the wings bend up and down – and why both are signs of good engineering.
- Time
- 30 minutes + 10 min homework
- Course
- Navigation and Technology (ages 14+)
- You need
- Paper, a pencil and this page
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test.
How to use this lesson
The paper-tear test is a quick, safe demonstration of stress concentration. Every answer is graded straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Why do you think engineers test parts by breaking them on purpose?”
- Later: the homework, then the practice test.
Watch out for
- Thinking windows are round just for looks. Rounded corners spread stress and help prevent fatigue cracks.
- Thinking a bending wing is about to break. Wings are designed to flex well within their limits; flexing is normal.
- Thinking the safety factor means aircraft are regularly flown at 1.5 times their limit. The factor is a margin on top of the largest expected load, not a target.
Hands-on: Cut two paper strips. Punch a square hole in one (cut with scissors) and a round hole in the other. Pull each gently from both ends until it tears. Where does each tear start? Then hold a plastic ruler at one end and press the other: feel it flex and spring back like a wing.
What you will learn
- I can explain why sharp corners concentrate stress.
- I can describe what the Comet investigation taught about windows and metal fatigue.
- I can explain why a wing that flexes is safer than one that cannot.
- I can explain limit load, ultimate load and the 1.5 safety factor.
Key words
- stress concentration
- A place where force crowds together, such as a sharp corner, making cracks more likely.
- metal fatigue
- Cracking caused by loads applied and removed many times.
- limit load
- The largest load an aircraft is expected to meet in service.
- ultimate load
- The limit load multiplied by a safety factor (1.5 in US airliner rules) – the structure must hold it without breaking.
- flex
- To bend and spring back without damage.
The big ideas
A pressurized fuselage is like a balloon blown up and let down once every flight. Each cycle stretches the skin a little. Where there is a sharp corner, such as a square window, the stress crowds into the corner, and over many cycles a tiny crack can grow. That is metal fatigue.
Aviation learned this the hard way. The FAA's lessons-learned library describes the de Havilland Comet, the first jet airliner: after two broke up in 1954, investigators pressurized a whole fuselage again and again in a water tank. After about 3,060 cycles it split, starting at the corner of a squarish window. Later aircraft have rounded windows that spread the stress smoothly, plus 'fail-safe' structures designed so that one crack cannot bring the whole aircraft down.
Wings flex for a similar reason: they are designed to bend, not to be rigid. In flight the wings carry the whole aircraft's weight, so they curve upwards, and in turbulence they flex and spring back, soaking up the bumps. US airliner design rules say the structure must carry its limit loads without permanent deformation, and must carry ultimate loads – the limit load multiplied by a safety factor of 1.5 – for at least 3 seconds without breaking. A wing that can bend safely is a wing that is strong.
Read-through: the teaching steps
The fuselage is a pressure vessel
At cruising height the cabin air is kept at a higher pressure than the thin air outside, so the fuselage is pushed outwards like a balloon. Every flight is one cycle of stretching and relaxing.
Corners collect stress
Forces flowing round a hole crowd into sharp corners. A rounded corner lets them flow smoothly, so the peak stress is much lower.
The Comet lesson
Investigators found fatigue cracking at a squarish window corner after about 3,060 test cycles. Rounded windows, much more fatigue testing and fail-safe design followed.
Wings are springs
A wing is like a long diving board. Lift pushes it up; the aircraft's weight hangs below. It bends upwards in flight and flexes in gusts, then springs back.
Limit and ultimate loads
- Limit load: the biggest load expected in service – no permanent bending allowed
- Ultimate load: limit load × 1.5 – no breaking for at least 3 seconds
- Manufacturers test wings by bending them far beyond normal flight.
Why flexible is safe
A rigid structure would have to resist every gust with no give, concentrating stress. A flexible wing spreads and absorbs the load, which is safer and lighter.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 9 min | Not assessed, self-checked |
| Worked examples and guided practice | 6 min | Graded by Classfern |
| Independent practice (three levels) | 6 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Big questions lessons · Navigation and Technology course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
- FAA Lessons Learned from transport airplane accidents
- 14 CFR Part 25 – Airworthiness standards: transport category airplanes
Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.