▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Math, Cookery, Programming and Art are open – explore →

Turbofan design: bypass ratio and efficiency – Navigation and Technology aviation lesson

Lesson 31 of 90 in the Navigation and Technology course (ages 14+)

US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version

Look at the front of an airliner's jet engine and you see a huge fan, not a small hole. Find out why most of the air goes round the hot core instead of through it, what 'bypass ratio' means, and how engineers measure fuel efficiency.

Time
45 minutes + 10 min homework
Course
Navigation and Technology (ages 14+)
You need
Paper, a pencil and this page
Graded
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test.

How to use this lesson

Sources: NASA Glenn Beginner's Guide to Aeronautics (turbofan and thrust specific fuel consumption pages); US Centennial of Flight Commission essay on jet engines. Good practice for GCSE or high-school ratio and rate calculations. Every answer is graded straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “Airliners use high-bypass turbofans but fighters use low-bypass ones. What does that tell you about how designers balance speed against fuel use?”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking the bypass air is wasted because it is not burned. In a high-bypass turbofan the fan air makes most of the thrust. The Centennial of Flight Commission gives 85 % for one late-1960s transport.
  • Thinking bypass ratio compares fuel with air. It compares two airflows: bypass air ÷ core air.
  • Thinking a bigger TSFC number means a better jet engine. TSFC is fuel per unit of thrust, so lower is better.

Hands-on: Use a hand-held fan or hairdryer on its cool setting. Feel the narrow, fast stream close to the nozzle, then move your hand further away where the air has spread out and slowed. Which one moves more air? Discuss which you would rather use to push a toy boat a long way on the same battery – that trade-off is the turbofan idea.

What you will learn

  • I can describe how a turbofan differs from a turbojet.
  • I can define bypass ratio and calculate it from airflow figures.
  • I can explain why a high bypass ratio saves fuel.
  • I can use thrust specific fuel consumption to estimate fuel burned.

Key words

turbofan
A jet engine with a large fan at the front, driven by an extra turbine; much of the air goes round the core.
core
The hot middle of a turbofan: compressor, burner and turbines, where fuel is burned.
bypass ratio
The mass of air that goes round the core divided by the mass that goes through it.
spool
A shaft with its own compressor and turbine; a two-spool turbofan has one for the fan and one for the core.
TSFC
Thrust specific fuel consumption: the mass of fuel burned each hour for each unit of thrust. Lower is better.

The big ideas

A turbojet pushes all its air through the hot core and throws it out very fast. That works, but it is thirsty. A turbofan adds a big fan at the front, driven by an extra turbine. NASA Glenn's guide explains that part of the incoming air goes through the core, while the rest is pushed round it by the fan, speeded up only a little. The bypass ratio is simply the fan airflow divided by the core airflow.

Why bother? NASA explains that adding the fan hardly changes how much fuel the core burns, yet it adds a lot of thrust. So a turbofan gets more push from almost the same fuel. High-bypass turbofans come close to the fuel efficiency of turboprops, but the fan's casing lets it work well at the higher speeds airliners fly. The US Centennial of Flight Commission says turbofans more than doubled the thrust of earlier jet engines, improved fuel economy and were quieter, and they were built for airliners from the second half of the 1960s.

The ratios kept growing. The Commission describes a large military transport of the late 1960s whose fan gave 85 percent of the thrust, and a 1990s airliner turbofan with a 9:1 bypass ratio and a fan 123 inches across. Fighters still use low-bypass turbofans, because their thin, fast exhaust and afterburners give the extra speed they need.

Read-through: the teaching steps

  1. Start with a turbojet

    All the air goes through compressor, burner and turbine, then out of the nozzle at high speed. It is simple, but it uses a lot of fuel for the thrust it makes.

  2. Add a fan

    • A large fan at the front is driven by an extra turbine at the back.
    • Some air goes through the core (the hot part).
    • The rest is pushed round the outside of the core – it 'bypasses' it.

    NASA notes that in a two-spool design the fan's shaft runs inside the core's shaft, so each can spin at its own best speed.

  3. Bypass ratio

    Bypass ratio = fan (bypass) airflow ÷ core airflow.

    • Ratio 1: equal amounts round and through.
    • Ratio 9: nine kilograms round the core for every kilogram through it – the figure the Centennial of Flight Commission gives for a big 1990s airliner turbofan.
  4. Why more air, moving slower, saves fuel

    Thrust comes from speeding up air. You can speed up a little air a lot, or a lot of air a little. Speeding up a big mass of air gently wastes less energy in a fast, hot exhaust jet. That is why NASA says the fan adds a lot of thrust for only a slight change in core fuel flow.

  5. Measuring efficiency: TSFC

    NASA defines thrust specific fuel consumption (TSFC) as the mass of fuel burned in one hour divided by the thrust. Typical sea-level values in its guide:

    • Turbojet: about 1.0 lb of fuel per hour per lb of thrust.
    • Turbofan: about 0.5.
    • Turbojet with afterburner: about 1.5.

    Fuel burned = thrust × TSFC × time.

  6. Different jobs, different ratios

    Airliners use high-bypass turbofans for economy. NASA notes that many fighters use low-bypass turbofans with afterburners: efficient enough to cruise, with lots of extra thrust when needed. Very slow transports often use propellers instead, because an open propeller is most efficient at lower speeds.

The lesson, step by step

45 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minGraded by Classfern
Teaching and hands-on task14 minNot assessed, self-checked
Worked examples and guided practice9 minGraded by Classfern
Independent practice (three levels)13 minGraded by Classfern
Exit ticket and talk question5 minGraded by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all graded instantly.

More practice

More Aircraft technology lessons · Navigation and Technology course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.