Noise reduction: chevrons and high bypass ratios – Navigation and Technology aviation lesson
Lesson 43 of 90 in the Navigation and Technology course (ages 14+)
US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version
Early jet airliners were famously loud. Today far fewer people live with serious aircraft noise. Find out where jet noise comes from, how big fans and sawtooth 'chevron' nozzles make jet engines quieter, and how the decibel scale works.
- Time
- 40 minutes + 10 min homework
- Course
- Navigation and Technology (ages 14+)
- You need
- Paper, a pencil and this page
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test. Rules and values on this page are given as of November 2026. Always check the current official source (the FAA) before relying on them.
How to use this lesson
Sources: NASA Glenn 'NASA's chevron technology quiets the skies'; FAA 'Aircraft noise' and 'Noise levels, stages and phaseouts'; NASA Glenn Beginner's Guide (turbofans); US Centennial of Flight Commission (jet engines). The noise standards are as published by the FAA (see the 'as of' date). Every answer is graded straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Airports bring jobs and travel, but noise affects people living nearby. How should we balance the needs of passengers with the needs of people under the flight path?”
- Later: the homework, then the practice test.
Watch out for
- Thinking 6 dB is twice as loud as 3 dB in energy terms. Each 3 dB doubles the energy, so 6 dB more is about four times the energy.
- Thinking chevrons are just for decoration. The sawtooth edge mixes the hot and cool streams more gently, cutting noise by about 3 dB.
- Thinking quieter jet engines must burn more fuel. High-bypass turbofans are both quieter and more economical.
Hands-on: Blow through a drinking straw onto the back of your hand: you feel a narrow, fast jet and hear a hiss. Now blow the same breath through a wide cardboard tube: the air is slower and quieter. Next, cut small triangular notches round the end of a paper tube (a 'chevron' edge) and compare the sound with a plain tube. Can you hear a difference?
What you will learn
- I can explain why the fast exhaust jet is a major source of jet engine noise.
- I can explain how high-bypass turbofans and chevron nozzles reduce noise.
- I can use the rule that 3 decibels means double (or half) the sound energy.
- I can describe how noise standards (stages) push aircraft to become quieter.
Key words
- decibel (dB)
- The unit for sound level. Each 3 dB step is roughly a doubling (or halving) of the sound energy.
- chevron
- A sawtooth edge on the back of a jet engine nozzle that helps the hot and cool air streams mix more gently.
- shear layer
- The zone where a fast air stream rubs against slower air around it, creating turbulence and noise.
- noise stage
- A level in the US noise standards for aircraft: higher stages are quieter.
- bypass ratio
- The air going round a turbofan's core divided by the air going through it.
The big ideas
Much of a jet engine's noise comes from its exhaust. Where a very fast jet of gas meets the slower air around it, the two streams rub and churn, making turbulence – and roar. The faster the jet compared with the air around it, the louder it is. The first turbojet airliners threw all their air out of the back very fast, so they were very noisy.
Turbofans changed that. As NASA Glenn's guide explains, a turbofan moves a large mass of air more slowly round its core. The US Centennial of Flight Commission notes that turbofans improved fuel economy and were quieter too. The higher the bypass ratio, the slower and gentler the overall exhaust. The FAA says the number of people in the US exposed to significant aircraft noise fell by about 90 percent between 1975 and 2000, largely because of newer, quieter aircraft.
Chevrons are a more recent trick. NASA Glenn describes them as a serrated, sawtooth shape on the back edge of the nozzle that helps mix the hot core air with the cooler fan air more gently. After wind tunnel tests in the late 1990s and a first flight test in 2001, they reduced noise by about 3 decibels – which NASA compares to running one lawnmower instead of two – for a thrust loss of only about 0.25 percent. Chevrons are now found on many newer airliner turbofans. Meanwhile, US noise standards, called stages, have tightened over the decades, so each new design must be quieter than the last.
Read-through: the teaching steps
Where jet noise comes from
- Exhaust (jet) noise: the fast jet churns the still air around it.
- Spinning fan and compressor blades add their own sound.
The exhaust jet is the part that high bypass ratios and chevrons tackle.
Slower jets are quieter
The roar comes from the speed difference between the jet and the air around it. A turbojet throws a small amount of air out very fast – loud. A high-bypass turbofan throws a lot of air out more slowly – quieter, and more economical too.
The decibel scale
Decibels are not an ordinary scale. Every 3 dB is about double the sound energy:
- +3 dB: twice the energy (two lawnmowers instead of one).
- +6 dB: four times.
So NASA's 3 dB from chevrons halves the sound energy.
Chevrons
NASA Glenn's story:
- 1990s: sawtooth chevrons look more promising than earlier tabs.
- 1997: extensive tests in Glenn's acoustic laboratory.
- 1998: 14 designs tested on a real jet engine; thrust loss only 0.25 %.
- 2001: first flight test.
- Just over a year later: the first airline jet engine with chevrons is certified.
The teeth gently stir the hot core air and cool fan air together, so they mix with less turbulence.
Rules that keep getting tighter
The FAA describes noise 'stages' for jets, with higher stages quieter. Stage 3 was required at US civil airports by 2000. Stage 4 matches the international (ICAO) standard used for new designs, and an even stricter international standard (Stage 5 in the US) took effect for new designs from 2014 internationally and from 2017–2020 in the US.
The result
The FAA says the number of people in the US exposed to significant aircraft noise fell by about 90 % between 1975 and 2000. Its research program now aims for technology 32 dB (cumulative) quieter than the ICAO standards.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 12 min | Not assessed, self-checked |
| Worked examples and guided practice | 8 min | Graded by Classfern |
| Independent practice (three levels) | 11 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Aircraft technology lessons · Navigation and Technology course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
- NASA Glenn – NASA's chevron technology quiets the skies
- FAA – Aircraft noise, and noise levels, stages and phaseouts
- NASA Glenn Beginner's Guide to Aeronautics
- U.S. Centennial of Flight Commission – essays on aviation history
Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.