How do pilots find the runway in fog? – Navigation and Technology aviation lesson
Lesson 75 of 90 in the Navigation and Technology course (ages 14+)
US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version
When fog hides everything, an airliner can still come down a precise invisible path to the runway – and, at well-equipped airports, even land itself. Find out how radio beams, bright lights, special training and autoland make it possible.
- Time
- 40 minutes + 10 min homework
- Course
- Navigation and Technology (ages 14+)
- You need
- Paper, a pencil and this page
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test.
How to use this lesson
Source: FAA Aeronautical Information Manual chapter 1 section 1 (ILS and approach categories). This is explanation for understanding, not flight instruction. The 300 ft per NM rule links to slope and angles in math. Every answer is graded straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Would you trust an autopilot to land a plane in thick fog? What would make you trust it more?”
- Later: the homework, then the practice test.
Watch out for
- Thinking pilots just 'guess' where the runway is in fog. Radio beams guide them precisely, and strict limits say how much they must see, and by what height.
- Thinking a go-around means something has gone badly wrong. Go-arounds are planned, practiced and normal – they are the safe choice whenever conditions are not right.
- Thinking any aircraft can land in any fog. The lowest categories need special equipment on the aircraft and at the airport, trained crews and special approval.
Hands-on: Make a 3° slope: lay a ruler flat and lift one end about 5 mm for every 10 cm of length (that is roughly 3°). Notice how shallow it is. Roll a marble down it and imagine an airliner sliding down that gentle path towards the runway.
What you will learn
- I can explain how the instrument landing system (ILS) guides an aircraft sideways and downwards.
- I can explain what decision height and runway visual range mean.
- I can describe the approach categories and why the lowest ones need special aircraft, crews and airports.
- I can explain what autoland does and why approach lights matter.
Key words
- ILS
- Instrument landing system: radio beams from the airport that guide an aircraft to the runway centerline and down a slope to the touchdown point.
- localizer
- The ILS beam that shows whether the aircraft is left or right of the runway centerline.
- glide slope
- The ILS beam that shows whether the aircraft is above or below the correct descent path – normally 3°.
- decision height
- The height above the runway by which the pilots must see enough of the runway or lights to continue; if not, they go around.
- runway visual range (RVR)
- How far along the runway a pilot can see the runway lights or markings, measured by instruments beside the runway.
The big ideas
Fog is just cloud lying on the ground, and it can cut visibility to a few hundred feet. To land safely, an aircraft needs to be lined up with the runway and coming down at the right angle long before the pilots can see anything. The main tool is the instrument landing system (ILS). The FAA's Aeronautical Information Manual (AIM) says the ILS provides an approach path for exact alignment and descent on final approach. The localizer gives course guidance to the runway centerline, and the glide slope gives descent information along a path normally set at 3° above horizontal.
The aircraft follows the beams down to a decision height. By then the pilots must see enough of the approach lights or runway to carry on. If they cannot, they go around and climb away – a normal, safe choice. Approach lights, touchdown zone lights and centerline lights help pilots spot the runway as early as possible.
The AIM lists approach categories. Category I has a decision height of 200 ft and a runway visual range (RVR) of 2,400 ft (1,800 ft with extra lighting or equipment). Category II goes down to 100 ft and 1,200 ft RVR. Category III goes lower still, and Category IIIc has no decision height and no RVR limit at all. Categories II and III need special authorization, extra-reliable equipment and specially trained crews – and the lowest often use autoland, where the autopilot flies the aircraft right down to the runway.
Read-through: the teaching steps
Two invisible beams
The ILS sends two radio beams up the approach:
- the localizer – left or right of the runway centerline
- the glide slope – above or below a descent path that is normally 3°
In the cockpit, two needles or bars show the pilots how far off each beam they are. The drawing on the lesson page shows the shape of the beams.
The ILS: the localizer gives left/right guidance, the glideslope gives up/down guidance. Decision height
The aircraft follows the beams down to a decision height. At that point the pilots must be able to see enough of the runway or its lights. If they can, they land. If not, they go around – climb away and either try again or go somewhere with better weather. A go-around is a normal, planned safety choice.
Measuring how far you can see
Instruments beside the runway measure runway visual range (RVR) – how far along the runway the lights can be seen, reported in feet. Controllers pass this to the pilots, who compare it with the lowest value allowed for their approach. Fog can be patchy, so RVR may be measured at several points along the runway.
Categories: lower and lower
The AIM lists the lowest ILS minimums:
- Category I – DH 200 ft, RVR 2,400 ft (1,800 ft with extra lighting or equipment).
- Category II – DH 100 ft, RVR 1,200 ft.
- Category IIIa – no DH or below 100 ft, RVR at least 700 ft.
- Category IIIb – no DH or below 50 ft, RVR at least 150 ft.
- Category IIIc – no DH and no RVR limit.
Categories II and III need special authorization.
Lights that cut through fog
Approach lights stretch out from the runway end in a long, bright pattern, often with flashing lights that seem to race towards the runway. Lights set into the runway's centerline and touchdown zone help the pilots line up and judge height in the last few seconds. In fog, these lights are often the first thing pilots see.
Autoland
In the lowest categories, the autopilot can fly the whole approach, flare (raise the nose just before touchdown), land and keep the aircraft straight on the runway as it slows. The pilots monitor every stage, ready to go around if anything is wrong. Autoland needs extra-reliable systems in the aircraft and protected radio beams on the ground.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 12 min | Not assessed, self-checked |
| Worked examples and guided practice | 8 min | Graded by Classfern |
| Independent practice (three levels) | 11 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Big questions lessons · Navigation and Technology course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.