▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Math, Cookery, Programming and Art are open – explore →

Fly-by-wire: from Concorde's analog system to the digital A320 – Navigation and Technology aviation lesson

Lesson 35 of 90 in the Navigation and Technology course (ages 14+)

US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version

In most older aircraft, the pilot's controls pull on cables and rods. In a fly-by-wire aircraft they send electrical signals instead. Follow the idea from Concorde's electrical controls through a NASA test aircraft flying on a spacecraft computer to the airliner that put digital fly-by-wire into everyday airline service.

Time
45 minutes + 10 min homework
Course
Navigation and Technology (ages 14+)
You need
Paper, a pencil and this page
Graded
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test.

How to use this lesson

Sources: NASA Armstrong fact sheet on the F-8 digital fly-by-wire program; Heritage Concorde (Concorde flying controls); AOPA 'A fly-by-wire future' (2020); Aviation Pros 'Fly-by-wire primer'; Flight International on modern cockpit history. The aircraft named are in the lesson title; this is history, not promotion. Every answer is graded straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “A fly-by-wire computer can refuse to do something the pilot asks if it is unsafe. Should a machine ever be allowed to overrule a human? When would that be a good idea, and when not?”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking fly-by-wire means a computer flies the aircraft and the pilot just watches. The pilot still flies it; fly-by-wire changes how the commands travel and adds safety limits.
  • Thinking Concorde's system was digital. Concorde's signals were electrical and amplified, but the first fully digital system was tested by NASA in 1972.
  • Thinking that with no cables, one fault could make the aircraft uncontrollable. Systems are built with several computers, actuators, sensors and power sources so one failure is covered.

Hands-on: Make a 'mechanical' control: tie a string to a paper flap on a cardboard wing, run it through a few loops and pull it. Then make a 'by-wire' version: one person calls out numbers from 0 to 10 and a partner at the other side of the room moves the flap to match. Which feels more direct? What could go wrong with each – and how would adding a second and third partner make the 'wire' version safer?

What you will learn

  • I can explain the difference between mechanical flight controls and fly-by-wire.
  • I can describe how Concorde's electrical flight controls and mechanical backup worked.
  • I can explain why digital fly-by-wire needs several computers (redundancy).
  • I can list benefits of fly-by-wire and calculate simple reliability figures.

Key words

fly-by-wire
A flight control system in which the pilot's inputs travel as electrical signals, not through cables and rods, to the units that move the control surfaces.
analog signal
An electrical signal that varies smoothly in step with the control movement, rather than being turned into numbers by a computer.
digital
Turned into numbers that a computer can process, check and combine before sending a command.
redundancy
Having more than one of a vital part, so that if one fails another takes over.
sidestick
A small control stick at the side of the pilot's seat that replaces the traditional control column on many fly-by-wire airliners.

The big ideas

In a traditional aircraft, moving the control column pulls on cables, pulleys and push rods that move the control surfaces. On a big, fast aircraft those links are long and heavy, and powered units are needed to move the surfaces. Fly-by-wire replaces the mechanical links with wires carrying electrical signals.

Concorde, which first flew in 1969, was the first passenger aircraft fitted with this kind of electrical flight control, according to the heritage group Heritage Concorde. Sensors at the control column and rudder pedals turned the pilot's movements into electrical signals, which were amplified and sent to powered units at the control surfaces. There were two electrical channels – main and standby – and a third, mechanical channel kept as a backup. The group notes that the mechanical backup never had to be used in Concorde's service life.

The next step was to put a digital computer in the loop. On May 25, 1972, NASA flew a modified fighter that was the first aircraft to depend completely on an electronic flight-control system. Its first computer was a spare from the Apollo Moon program. Later NASA used three computers checking each other. In the early 1980s, AOPA reports, the designers of a new short-haul airliner, the A320, decided it too would use fly-by-wire. Flight International records that it brought digital fly-by-wire into airline service in 1988. Pilots fly it with a sidestick, and the computers turn their inputs into commands – and also keep the aircraft inside safe limits, as the next lesson explains.

Read-through: the teaching steps

  1. Cables, rods and muscles

    In a light aircraft the controls connect to the surfaces through cables, pulleys, bellcranks and push rods. The pilot feels the air pushing back on the surfaces. On large, fast aircraft the forces are too big, so hydraulic units do the moving – but the signal to them still traveled by cables.

  2. Swap the cables for wires

    Fly-by-wire sends the pilot's input as an electrical signal instead. Because there is no direct link, the 'feel' of the controls is made artificially, with springs, cams and dampers.

  3. Concorde's system

    • Sensors at the control column and pedals produce electrical signals.
    • Signals are amplified and combined with feedback, then sent to a powered flying control unit for each surface.
    • Main and standby electrical channels, plus a mechanical backup channel.
    • Autostabilization smoothed out turbulence and applied rudder if a jet engine failed.

    Heritage Concorde says the mechanical backup was never needed in service.

  4. Going digital

    NASA's fact sheet records that on May 25, 1972, a modified fighter at its California flight research center became the first aircraft to fly fully dependent on an electronic flight-control system. Phase 1 used a spare Apollo spacecraft computer; Phase 2 used three computers. Over 13 years and 210 flights, the program proved digital fly-by-wire for later fighters, the Space Shuttle and airliners.

  5. The A320 and the sidestick

    AOPA reports that in the early 1980s the designers of the A320 chose fly-by-wire. Its pilots use sidesticks with no mechanical link to the surfaces. If both pilots move their sticks, the inputs are added together, and a pushbutton lets one pilot take priority. Computers hold the aircraft steady when the stick is let go.

  6. Redundancy keeps it safe

    With no cables to fall back on, the electronics must not fail. AOPA describes at least two actuators for each major control surface, at least two air data probes, two or more attitude systems and a wind-driven ram air turbine for emergency power. Manufacturers claim failure rates around one in a billion.

  7. Why bother?

    NASA lists the benefits: lighter and smaller than mechanical and hydraulic controls (saving fuel or carrying more), less maintenance, a smoother ride, and computers that can make corrections far more often than a pilot can.

The lesson, step by step

45 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minGraded by Classfern
Teaching and hands-on task14 minNot assessed, self-checked
Worked examples and guided practice9 minGraded by Classfern
Independent practice (three levels)13 minGraded by Classfern
Exit ticket and talk question5 minGraded by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all graded instantly.

More practice

More Aircraft technology lessons · Navigation and Technology course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.