Composites: the 787 and A350 – Navigation and Technology aviation lesson
Lesson 40 of 90 in the Navigation and Technology course (ages 14+)
US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version
For most of the jet age, airliners were built from aluminum. The newest long-haul jets are about half carbon fiber composite. Find out what a composite is, why it saves weight and maintenance, and what new problems it brings – from hidden damage to lightning strikes.
- Time
- 40 minutes + 10 min homework
- Course
- Navigation and Technology (ages 14+)
- You need
- Paper, a pencil and this page
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test.
How to use this lesson
Sources: FAA Pilot's Handbook of Aeronautical Knowledge, chapter 3 (composite construction); SME Media article on composites in airliners (2017). The aircraft named are in the lesson title; this is a materials lesson, not promotion. Every answer is graded straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Composites save fuel and maintenance, but damage can be hidden and they are hard to recycle. If you were choosing materials for a new airliner, what would you weigh up?”
- Later: the homework, then the practice test.
Watch out for
- Thinking composites are always lighter than metal. The Handbook says weight saving is not automatic – it depends on the design and the material.
- Thinking that if a composite surface looks fine, it is fine. Low-energy impacts can cause hidden delamination with no visible mark.
- Thinking a composite aircraft is unprotected against lightning. A fine metal mesh in the outer skin carries the current safely away.
Hands-on: Make your own composite. Lay three sheets of paper on top of each other and try to bend them – easy. Now glue them together with PVA glue, with a few lengths of thread laid between the layers in different directions, and let it dry flat overnight. Compare how stiff the glued 'composite' is. Then tap one spot hard with a spoon handle: can you see any damage on the surface? Bend it gently – is it weaker there?
What you will learn
- I can explain what a composite material is: fibers held in a matrix.
- I can compare glass fiber, carbon fiber and aluminum for aircraft use.
- I can describe the advantages and disadvantages of composites, including hidden damage and lightning protection.
- I can calculate weight savings and compare the share of composites in different airliners.
Key words
- composite
- A material made of strong fibers held together in a 'glue' called the matrix, such as carbon fiber in epoxy resin.
- matrix
- The resin that holds the fibers together and gives the part its shape when it sets (cures).
- carbon fiber
- Very thin, strong, stiff threads of carbon. In resin they make light, stiff structures.
- delamination
- Layers of a composite separating inside, often after an impact – sometimes with no mark on the surface.
- corrosion
- Chemical damage such as rust, which attacks metals like aluminum but not carbon fiber composite.
The big ideas
A composite is two materials working together. The FAA's Pilot's Handbook explains that aircraft composites are fibers held in a matrix: the fibers – glass, carbon or aramid – carry most of the load, while the matrix, usually epoxy resin, is the 'glue' that holds them in shape once it has cured. Composites are not new in aviation. The Handbook says European sailplane makers used glass fiber for their main structure from the late 1950s, and by 2005 over 35 percent of new aircraft were built of composite materials.
Carbon fiber is the star. The Handbook says it is stronger, much stiffer and lighter than glass fiber, and a well-designed carbon structure can be about 30 percent lighter than the same structure in aluminum. It does not corrode and does not suffer metal fatigue. The Handbook notes that an all-composite airliner can therefore be designed for a higher cabin pressure and more humid cabin air. SME Media reports that about 50 percent of the 787's structure, including the wing and fuselage, is composite, and that 53 percent of the A350's advanced materials are composites – compared with about 10 percent on the A320 family.
Composites have their own problems. The Handbook's biggest warning is that damage may not show: a dropped tool can leave no mark but cause a hidden, cone-shaped area of delamination underneath. Many epoxies weaken above about 150 °F (66 °C), so makers set which paint colors can be used. And because carbon fiber conducts electricity less well than aluminum, a fine copper mesh is built into the skin to carry lightning strikes safely away.
Read-through: the teaching steps
Fibers plus glue
Think of reinforced concrete: steel bars carry the pull, concrete holds them in place. In an aircraft composite, fibers carry the load and the matrix (usually epoxy resin) holds them in position. Layers of fiber cloth are laid in different directions so the part is strong in every direction it needs to be.
Glass, carbon and aluminum
The Pilot's Handbook compares them:
- Glass fiber: tough, easy to work with, cheap – but somewhat heavy.
- Carbon fiber: stronger, much stiffer and lighter – but brittle under sharp impact and more expensive.
- Aluminum: the traditional airliner metal; light and easy to repair, but it corrodes and suffers fatigue.
A well-designed carbon structure can be about 30 percent lighter than its aluminum equivalent.
Why airliners switched
- Less weight means less fuel.
- No corrosion and no metal fatigue – SME Media reports that on the A350 the six-year intermediate check is dropped and the first heavy check is not needed until year 12.
- Smooth, curved shapes are easy to make, reducing drag.
- The Handbook notes a composite fuselage can take higher cabin pressure and humidity, which is more comfortable for passengers.
How the share has grown
SME Media gives the composite share in one maker's airliners:
- Early 1980s wide-body twin: 5 percent.
- A320 family: 10 percent.
- A very large double-deck airliner: 25 percent.
- A350: 53 percent of its advanced materials.
It reports about 50 percent for the 787, including the wing and fuselage.
Hidden damage
The Handbook warns that composite damage may not be visible. A low-energy bump can cause a cone-shaped area of delamination below an unmarked surface. Medium impacts crush the surface, but the damage spreads further than it looks. That is why composite aircraft need careful inspection methods.
Heat and paint
Many epoxies begin to weaken above 150 °F (about 66 °C). The Handbook gives an example: a black-painted wing over black tarmac on a hot day can reach 220 °F, while a white one rarely goes above 140 °F. So manufacturers specify which paint colors are allowed.
Lightning
Aluminum skin carries lightning current away easily. Glass fiber is an insulator, and carbon fiber conducts less well than aluminum. So a fine metal mesh – copper on carbon fiber – is bonded into the outer layer to spread the energy and keep it away from fuel and electronics. Radio aerials inside need 'windows' in the mesh.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 12 min | Not assessed, self-checked |
| Worked examples and guided practice | 8 min | Graded by Classfern |
| Independent practice (three levels) | 11 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Aircraft technology lessons · Navigation and Technology course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
- FAA Pilot's Handbook of Aeronautical Knowledge FAA-H-8083-25C
- SME Media – Airbus, Boeing, Lockheed singing praises of composites
Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.