▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Math, Cookery, Programming and Art are open – explore →

Wind tunnels: from the Wrights to today – Ground School Basics aviation lesson

Lesson 21 of 90 in the Ground School Basics course (ages 11–16)

US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version

See how a wooden box with a fan helped the Wright brothers fix their wings, and how today's giant wind tunnels can test a whole airliner.

Time
40 minutes + 10 min homework
Course
Ground School Basics (ages 11–16)
You need
Paper, a pencil and this page
Graded
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test.

For parents: how to use this lesson

Keep fingers well away from fan blades in the hands-on activity. This lesson is as much about scientific method – measure, change one thing, repeat – as about aircraft. Every answer is graded straight away with a worked explanation.

  1. Read what your child will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “Computers can now simulate airflow. Why do you think engineers still build wind tunnels and test real models?”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking the model has to fly through the air for a test to work. In a wind tunnel the model stays still and the air moves past it. The forces are the same as if the model moved through still air.
  • Thinking the Wrights just copied other people's numbers. They measured lift and drag themselves because their 1901 glider made only a third of the predicted lift.
  • Changing several things between models. The Wrights changed one variable at a time so they knew what caused each difference – a fair test.

Hands-on: Make a simple "tunnel" from a cardboard box with both ends cut out and a desk fan at one end (adult supervision). Hang a paper strip or a light paper wing on a thread in the middle and watch how it moves at different fan speeds. Record what you change and keep everything else the same.

What your child will learn

  • I can explain why engineers test models in wind tunnels.
  • I can describe the difference between an open-return and a closed-return wind tunnel.
  • I can describe how the Wright brothers used their 1901 wind tunnel results.
  • I can explain why a test needs the right Mach number and Reynolds number to be useful.

Key words

wind tunnel
A tube or box in which air is moved past a fixed model so the forces on it can be measured.
test section
The part of the tunnel where the model is mounted and the air flows over it.
open-return tunnel
A tunnel that draws air in from outside, passes it over the model and lets it out again.
closed-return tunnel
A tunnel in which the same air goes round and round in a loop.
balance
A measuring device that records the lift and drag forces on the model.
aspect ratio
How long and thin a wing is: a long, thin wing has a high aspect ratio.

The big ideas

NASA describes wind tunnels as the place where aerodynamicists test models of proposed aircraft. The model is mounted in a test section and a fan moves air past it. By measuring the forces on the model carefully, engineers can predict the forces on the full-size aircraft before it is built.

In 1901 the Wright brothers were disappointed: their 1901 glider made only about a third of the lift that published data had predicted. So they built their own wind tunnel – a simple single-speed, open-return wooden box, with a fan at the entrance driven through a belt by a small piston engine from their workshop. They made one to two hundred small model wings from steel strip, tested about 30 of the best in detail, changing one thing at a time, and ended up with what NASA calls the most detailed wing data in the world. Their 1902 glider flew much better and led to the 1903 Flyer.

Today's tunnels are built for particular speeds and jobs: subsonic, supersonic, hypersonic, icing and full-scale testing. The 80-by-120-foot test section at NASA Ames in California, run by the US Air Force, is described as the world's largest wind tunnel and can test a full-size Boeing 737 at up to 100 knots.

Read-through: the teaching steps

  1. Why use a wind tunnel?

    It is cheaper and safer to test a model than to build and fly a full airplane. Engineers control the airflow and measure the forces precisely. For safety, nobody stays in the test section while the tunnel runs – engineers watch from a control room.

  2. Open or closed?

    An open-return tunnel draws air from outside, sends it through the test section and lets it out again. A closed-return tunnel recirculates the same air round a loop. The Wrights' tunnel was open-return: the air came out into their workshop.

  3. The Wrights' problem

    Their 1900 and 1901 gliders flew glides of up to 300 feet but performed worse than predicted; the 1901 glider made only one third of the predicted lift. Instead of guessing, they decided to measure lift and drag themselves.

  4. The Wrights' tunnel and method

    • A fan at the entrance pushed air through a long wooden box
    • Flow straighteners after the fan smoothed the swirling air – they spent nearly a month on these
    • Two balances measured lift and drag; an observer read them through a window on top
    • About 30 models were studied in detail, changing only one design feature at a time
  5. What they found

    Long, thin wings (high aspect ratio) did better than short, wide ones. Curved (cambered) surfaces gave more lift but more drag; they chose a camber of 1/20. Their 1902 glider kept about the same wing area but had twice the aspect ratio of the 1901 glider – and flew much better. They also used the data to design their propellers.

  6. Wind tunnels today

    The world's largest wind tunnel test section, 80 by 120 feet at NASA Ames, is driven by six fans, each 40 feet across and turned by a 22,500-horsepower electric motor. Its 40-by-80-foot section, first built in 1944, reaches 300 knots. For results to match real flight, NASA notes that the Mach number and Reynolds number in the tunnel must match the flight conditions.

The lesson, step by step

40 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minGraded by Classfern
Teaching and hands-on task12 minNot assessed, self-checked
Worked examples and guided practice8 minGraded by Classfern
Independent practice (three levels)11 minGraded by Classfern
Exit ticket and talk question5 minGraded by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all graded instantly.

More practice

More Physics of flight lessons · Ground School Basics course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.