▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Math, Cookery, Programming and Art are open – explore →

Autopilots: what they do and do not do – Ground School Basics aviation lesson

Lesson 35 of 90 in the Ground School Basics course (ages 11–16)

US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version

Find out what a light-aircraft autopilot can fly for the pilot, what it cannot do, and why the pilot always stays in charge.

Time
35 minutes + 10 min homework
Course
Ground School Basics (ages 11–16)
You need
Paper, a pencil and this page
Graded
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test.

For parents: how to use this lesson

This topic is about understanding automation, not operating it. The idea of "monitoring the machine" applies widely – cars, factories, even sat-navs. Every answer is graded straight away with a worked explanation.

  1. Read what your child will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “Cars now have systems that can steer and brake. What lessons from aircraft autopilots might car drivers need to learn?”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking the autopilot flies the whole aircraft, including the throttle. Most light-aircraft autopilots cannot manage power; the pilot controls airspeed with the throttle.
  • Thinking NAV mode keeps the aircraft at the right height. NAV gives lateral guidance only; another mode handles the vertical path.
  • Thinking the pilot can relax completely once it is engaged. Pilots must monitor the modes and flight path; over-reliance is a known hazard.

Hands-on: Make a "mode annunciator" card with boxes for HDG, ALT, VS and NAV. Act out a short flight with a partner: one person calls the modes they select, the other checks the card and says out loud what is armed and engaged. Notice how easy it is to forget to arm altitude capture.

What your child will learn

  • I can describe what a two-axis autopilot controls.
  • I can name common autopilot modes such as heading, altitude hold, vertical speed and NAV.
  • I can explain things a typical light-aircraft autopilot does not do, such as managing power.
  • I can explain why pilots monitor the autopilot and keep their hand-flying skills.

Key words

autopilot
A system of computers and servo motors that moves the control surfaces to hold a chosen flight path.
two-axis autopilot
An autopilot that controls pitch and roll – the type in most general aviation aircraft.
flight director
Command bars on the display that show the pitch and roll needed; described as the brain of the autopilot system.
mode annunciator
The display that shows which autopilot modes are armed or engaged.
automation complacency
Relying on automation so much that the pilot stops monitoring it properly.

The big ideas

The FAA's Advanced Avionics Handbook describes the two-axis autopilot installed in most general aviation aircraft: it controls pitch and roll. The flight director – the "brain" of the system – works out the pitch and roll needed, and servo motors move the controls. An autopilot can hold an altitude, climb or descend to a chosen altitude, turn to and hold a heading, follow a course or a route of waypoints, and fly approaches.

There are important things it does not do. The handbook says most autopilots cannot manage power: the pilot must set the throttle to control airspeed. The autopilot can control pitch for altitude or for airspeed, but not both at once, and it is only certified for use above a minimum height set in the flight manual. The FAA's Pilot's Handbook adds that automated displays can capture a pilot's attention for long periods.

So the pilot always stays in command. The Advanced Avionics Handbook states that the first priority for a pilot is always to fly the aircraft. Pilots are taught to check the mode annunciator to see what the autopilot is really doing, to watch that it follows the intended path, to keep their manual flying skills, and to disconnect it if it behaves unexpectedly.

Read-through: the teaching steps

  1. What an autopilot is

    Control circuits and servo motors move the control surfaces. The flight director calculates the commands and shows them as command bars. Most light-aircraft autopilots are two-axis: they control pitch and roll.

  2. Common modes

    • Heading: flies a selected heading
    • Altitude hold: keeps the altitude when it was engaged
    • Vertical speed: a constant climb or descent rate
    • Altitude select/capture: climbs or descends and levels at a chosen altitude
    • NAV: follows a GPS, VOR or route course – sideways guidance only
  3. What it does NOT do

    • Most cannot manage power – the pilot controls airspeed with the throttle
    • It controls pitch for altitude or airspeed, not both at once
    • NAV mode does not control the vertical path
    • It is only certified above a minimum height in the flight manual
  4. Traps

    The handbook warns that if vertical speed mode asks for more climb than the power can support, the aircraft can slow down and stall. Pushing on the controls with altitude hold engaged makes the autopilot trim against the pilot. Leveling off without restoring power can lead to a stall.

  5. Watching the modes

    Pilots check the mode annunciator to confirm each mode is armed or engaged, include it in their scan, and confirm the autopilot is tracking the intended course and altitude. The handbook calls failing to arm the altitude mode the most common error in climbs and descents.

  6. Staying in command

    The first priority is always to fly the aircraft. If in doubt, reduce automation. The usual disconnect is a switch on the control wheel, often a red button, and most systems can be overpowered by hand. Over-reliance and loss of hand-flying skill are listed as disadvantages of automation.

The lesson, step by step

35 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minGraded by Classfern
Teaching and hands-on task11 minNot assessed, self-checked
Worked examples and guided practice7 minGraded by Classfern
Independent practice (three levels)8 minGraded by Classfern
Exit ticket and talk question5 minGraded by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all graded instantly.

More practice

More Instruments lessons · Ground School Basics course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.