Airfoil shapes: camber, chord and symmetrical sections – Ground School Basics aviation lesson
Lesson 9 of 90 in the Ground School Basics course (ages 11–16)
US version. US spelling and units (inHg, statute miles, US gallons) and the FAA. · UK version
Slice through a wing and you see its airfoil shape. Learn the names of its parts, how camber is measured, and why aerobatic airplanes often use symmetrical sections.
- Time
- 40 minutes + 10 min homework
- Course
- Ground School Basics (ages 11–16)
- You need
- Paper, a pencil and this page
- Graded
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an FAA-approved school, and nothing here counts towards a pilot certificate or replaces training with a certificated instructor and the FAA knowledge test.
For parents: how to use this lesson
GCSE/high-school level: percentages and the link between shape and lift. Theory for understanding only. Every answer is graded straight away with a worked explanation.
- Read what your child will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Why do you think airliners use cambered airfoils while aerobatic airplanes often use symmetrical ones?”
- Later: the homework, then the practice test.
Watch out for
- Thinking a symmetrical airfoil can never make lift. It makes no lift head-on, but with an angle of attack it makes lift.
- Thinking the chord line follows the curve of the wing. The chord line is straight. The curved line halfway between the surfaces is the mean camber line.
- Thinking only the front of the airfoil matters. The rear shape has a big effect on how much the flow is turned – that is why control surfaces are at the back.
Hands-on: Draw an airfoil on squared paper with a chord of 10 squares. Draw the straight chord line and the curved mean camber line. Count how many squares the camber line rises above the chord at its highest point and work out the camber as a percentage.
What your child will learn
- I can label the leading edge, trailing edge, chord line and mean camber line of an airfoil.
- I can calculate camber as a percentage of chord.
- I can explain how camber and the shape of the rear of the airfoil affect lift.
- I can explain how a symmetrical airfoil makes lift.
- I can explain why the Wrights tested shapes in a wind tunnel.
Key words
- airfoil
- The cross-section shape of a wing, propeller blade or tail surface.
- leading edge
- The rounded front edge of an airfoil, which meets the air first.
- trailing edge
- The thin back edge of an airfoil, where the air leaves.
- mean camber line
- A line drawn halfway between the upper and lower surfaces from leading to trailing edge.
- symmetrical airfoil
- An airfoil with identical shapes above and below the chord line, so it has no camber.
The big ideas
If you could slice through a wing from front to back, the shape you would see is called an airfoil. It has a rounded leading edge at the front and a thin, sharp trailing edge at the back. The chord line is a straight line joining the two, and its length is the chord. The mean camber line runs halfway between the upper and lower surfaces.
Camber is how curved the airfoil is – how far the mean camber line bulges away from the chord line. It is usually given as a percentage of the chord. A cambered airfoil turns the airflow even when it meets the air head-on, so it makes lift at zero angle of attack. NASA's Beginner's Guide shows that the shape of the rear part matters most: curving the back of the airfoil downwards gives a large amount of flow turning and lift. This is exactly what a lowered flap, aileron or elevator does.
A symmetrical airfoil has the same shape above and below its center line. Meeting the air head-on, it turns the flow equally up and down, so it makes no net lift. Give it an angle of attack and it makes lift – the same amount either way up. That is why aerobatic airplanes, tail fins and many horizontal stabilizers use symmetrical sections. The Wright brothers built a wind tunnel in 1901 to test how different shapes affected lift.
Read-through: the teaching steps
Parts of an airfoil
- Leading edge – rounded front
- Trailing edge – thin back
- Chord line – straight line from leading to trailing edge
- Mean camber line – halfway between the upper and lower surfaces
Find them on the drawing on the lesson page.
An airfoil: the chord line joins the leading and trailing edges; the angle of attack is between the chord line and the relative airflow. Measuring camber
Camber = the greatest distance between the mean camber line and the chord line, written as a percentage of the chord.
camber % = (camber height ÷ chord) × 100
Camber makes lift
A cambered airfoil turns the airflow downwards even at zero angle of attack. More camber turns more air and gives more lift – which is why flaps add camber for slow flight.
The back end matters
NASA's shape tests show that airfoils with similar fronts but a back curved downwards make much more lift. Deflecting the rear down increases lift; deflecting it up reduces lift or makes negative lift. This is how control surfaces work.
Symmetrical airfoils
Same shape above and below, so no camber. Head-on, it makes no net lift. With an angle of attack it makes lift, and it works equally well upside down – ideal for aerobatic airplanes, fins and many horizontal stabilizers.
Testing shapes
Lift depends on how much the flow is turned, which depends on shape. It is usually measured as a lift coefficient in a wind tunnel. The Wright brothers built their own wind tunnel in 1901 to test wing shapes before building the 1903 Flyer.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Graded by Classfern |
| Teaching and hands-on task | 12 min | Not assessed, self-checked |
| Worked examples and guided practice | 8 min | Graded by Classfern |
| Independent practice (three levels) | 11 min | Graded by Classfern |
| Exit ticket and talk question | 5 min | Graded by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all graded instantly.
More practice
More Physics of flight lessons · Ground School Basics course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by the FAA, any flying school, testing agency or exam board.