UK versus US navigation differences: units, charts and altimetry – Private Pilot Theory aviation lesson
Lesson 228 of 228 in the Private Pilot Theory course (ages 16+)
UK version. UK spelling and units (hPa, metres, litres) and the UK CAA. · US version
The same physics, different conventions: how pressure settings, transition altitudes, visibility units, chart elevation figures and even the definition of night differ between the UK and the USA.
- Time
- 40 minutes + 10 min homework
- Course
- Private Pilot Theory (ages 16+)
- You need
- Paper, a pencil and this page
- Marked
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an approved training organisation, and nothing here counts towards a pilot licence or replaces a CAA-approved course and the CAA’s own exams. Rules and values on this page are given as of November 2026. Always check the current official source (the UK CAA) before relying on them.
How to use this lesson
This is adult-level theory (16+). Values are quoted from official sources as of November 2026 to compare the two systems; they are not operating procedures. Every answer is marked straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “If you could design one worldwide system for pressure settings and visibility units, which country's choices would you keep, and why?”
- Later: the homework, then the practice test.
Watch out for
- Thinking the UK and US both switch to standard pressure at the same altitude. US: 18,000 ft everywhere. UK: often 3,000 ft outside controlled airspace, and 5,000–6,000 ft in many other places.
- Treating '1 hPa ≈ 27 ft' and '1 inHg ≈ 1,000 ft' as unrelated. They describe the same thing: 1 inHg is about 34 hPa, and 34 × 27 ≈ 920 ft.
- Reading a UK visibility of 5000 as 5,000 miles. UK METARs use metres: 5000 = 5 km. US METARs use statute miles with SM after the number.
Hands-on: Make a two-column 'conversion card' – UK on one side, USA on the other – for: pressure unit and standard value, height per pressure unit, transition altitude, visibility units, how pressure appears in a METAR, and the definition of night. Test a friend by reading out a value from one column and asking for the other.
What you will learn
- I can compare UK and US pressure units (hPa and inHg) and convert roughly between them.
- I can explain the difference between the UK transition altitude and the US 18,000 ft rule.
- I can compare how visibility is reported in UK and US weather reports.
- I can compare the UK and US maximum elevation figures on charts.
- I can state the UK and US definitions of night.
Key words
- hPa
- Hectopascal – the pressure unit used in the UK (equal to the millibar).
- inHg
- Inches of mercury – the pressure unit used for altimeter settings in the USA.
- QNH / altimeter setting
- The pressure setting that makes an altimeter read altitude above mean sea level.
- transition altitude
- The altitude at or below which altitudes are flown on a local pressure setting; above it, the standard setting is used for flight levels.
- flight level
- A pressure altitude with the standard setting, in hundreds of feet: FL180 = 18,000 ft.
The big ideas
Pilots in the UK and the USA learn the same physics – air pressure falls with height, wind pushes aircraft off course – but the conventions differ. Both use feet for altitude and knots and nautical miles for speed and distance, yet pressure, visibility and some definitions are written differently. Anyone reading both countries' materials needs to be bilingual in units.
The biggest difference is in altimetry. The CAA's Skyway Code explains that UK pilots set QNH in hectopascals to read altitude above mean sea level, and switch to the standard 1013 hPa above the transition altitude, which is 3,000 ft outside controlled airspace and normally 5,000 or 6,000 ft within or below it. The FAA's Aeronautical Information Manual explains that US pilots below 18,000 ft MSL use the current altimeter setting in inches of mercury from a station within 100 NM, and at or above 18,000 ft use 29.92 inHg.
Weather reports differ too: UK METARs give visibility in metres and pressure as Q1013, while US METARs give visibility in statute miles and the altimeter setting as A2992. Even 'night' is defined differently – the Skyway Code uses 30 minutes after sunset to 30 minutes before sunrise, while 14 CFR 1.1 uses the end of evening civil twilight to the beginning of morning civil twilight.
Read-through: the teaching steps
Pressure units
- UK: hectopascals (hPa). Standard pressure 1013 hPa (1013.2).
- USA: inches of mercury (inHg) for altimeter settings. Standard 29.92 inHg.
- The FAA handbook gives 1 inHg as roughly 34 mb (1 mb = 1 hPa).
Rough conversion: change in hPa ≈ change in inHg × 34.
How much height per unit?
- UK: 1 hPa ≈ 27 ft (Skyway Code).
- USA: 1 inHg ≈ 1,000 ft (AIM).
Check: 34 hPa × 27 ft ≈ 918 ft – close to 1,000 ft, as you would expect for roughly the same pressure change.
Transition altitude
- UK: transition altitude 3,000 ft outside controlled airspace, normally 5,000 or 6,000 ft within or below it. Above it, 1013 hPa and flight levels.
- USA: one rule nationwide – below 18,000 ft MSL use the local altimeter setting; at or above 18,000 ft use 29.92 inHg and flight levels.
So a UK pilot may be on flight levels at 4,000 ft, while a US pilot at the same height would still use the local setting.
Visibility and weather reports
- UK METAR: visibility in metres (9999 = 10 km or more); pressure Q1013 in hPa; cloud heights above aerodrome level.
- US METAR: visibility in statute miles (10SM, 3/4SM); altimeter A2992 = 29.92 inHg; cloud heights above ground level.
- CAVOK is used in the UK but not in US domestic TAFs.
- Both use the same weather codes (RA, FG, BR, TS…) and the same cloud amounts (FEW, SCT, BKN, OVC).
Chart elevation figures
- UK VFR charts: the maximum elevation figure (MEF) in each box shows the higher of the highest obstacle or the highest terrain + 300 ft (Skyway Code).
- US sectionals: the MEF shows the highest elevation, including terrain and obstacles, in a quadrant of 30 minutes of latitude by 30 minutes of longitude, rounded up (FAA chart guidance).
Both are in feet above mean sea level and both are a quick warning, not a substitute for studying the route.
Night and other definitions
- UK night (Skyway Code): from 30 minutes after sunset to 30 minutes before sunrise.
- US night (14 CFR 1.1): from the end of evening civil twilight to the beginning of morning civil twilight.
- UK pressure words: QNH (altitude above sea level), QFE (height above the aerodrome, reading zero on the ground). US pilots say 'altimeter setting' for the equivalent of QNH.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Marked by Classfern |
| Teaching and hands-on task | 12 min | Not assessed, self-checked |
| Worked examples and guided practice | 8 min | Marked by Classfern |
| Independent practice (three levels) | 11 min | Marked by Classfern |
| Exit ticket and talk question | 5 min | Marked by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all marked instantly.
More practice
More Navigation lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
- UK CAA Skyway Code
- FAA Aeronautical Information Manual
- 14 CFR 1.1 Definitions
- FAA Pilot's Handbook of Aeronautical Knowledge FAA-H-8083-25C
- UK Met Office – cloud names and classifications
Our lessons and questions are our own. They are not written or endorsed by the CAA, any flying school, testing agency or exam board.