▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Maths, Cookery, Programming and Art are open – explore →

Runway length requirements and obstacle clearance – Private Pilot Theory aviation lesson

Lesson 198 of 228 in the Private Pilot Theory course (ages 16+)

UK version. UK spelling and units (hPa, metres, litres) and the UK CAA. · US version

Put take-off and landing distances, condition factors and safety factors together to judge whether a runway is long enough, and check obstacle clearance with a climb gradient.

Time
45 minutes + 10 min homework
Course
Private Pilot Theory (ages 16+)
You need
Paper, a pencil and this page
Marked
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an approved training organisation, and nothing here counts towards a pilot licence or replaces a CAA-approved course and the CAA’s own exams. Rules and values on this page are given as of November 2026. Always check the current official source (the UK CAA) before relying on them.

How to use this lesson

This is adult-level theory (16+). Read it alongside the official handbooks; it is explanation for understanding, not training. Every answer is marked straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “Why does a headwind make it easier to clear an obstacle after take-off?”
  4. Later: the homework, then the practice test.

Watch out for

  • Adding factors. Multiply all factors.
  • Using rate of climb (per minute) as if it were per mile. Convert using groundspeed: ft per NM = ROC ÷ NM per minute.
  • Ignoring a headwind's help on climb gradient. A headwind lowers groundspeed, so more height is gained per mile.

Hands-on: Build a ramp from a book and ruler. Measure its rise and length and work out the gradient as a percentage. Place a small "obstacle" along it and check whether a toy car rolling up would pass above it.

What you will learn

  • I can compare a factored distance with the runway available.
  • I can explain why factors are multiplied.
  • I can calculate the height gained over a distance from a climb gradient.
  • I can work out whether an obstacle is cleared.
  • I can explain the role of Vx for obstacles.

Key words

runway available
The length of runway that can be used, from the published aerodrome data.
factored distance
Chart distance × condition factors × safety factor.
climb gradient
Height gained per horizontal distance, often in %.
obstacle clearance
The height margin above an obstacle on the climb-out.
Vx
Best angle of climb speed – most height per distance.

The big ideas

Two questions decide whether a runway is long enough in theory: is the factored take-off (or landing) distance shorter than the runway available, and can the aircraft climb clear of obstacles beyond the end? The PHAK (chapter 11) explains how weight, wind, slope, surface and density altitude change the distances; the CAA SafetySense Leaflet 7c turns these into factors to multiply, plus safety factors of 1.33 for take-off and 1.43 for landing.

For obstacles, a climb gradient compares height with distance: a 5 % gradient gains 5 ft for every 100 ft travelled. The PHAK defines Vx as the speed giving the most altitude in a given horizontal distance – the steepest climb, the one that helps clear an obstacle. A gradient in feet per nautical mile can be found from rate of climb ÷ groundspeed in NM per minute.

These are calculations for understanding only – never a decision tool for a real runway.

Read-through: the teaching steps

  1. Factored distance

    Required = chart distance × condition factors × safety factor (multiply all).

  2. Compare with runway available

    If required ≤ available, the runway is long enough on paper; if not, it is not.

  3. Climb gradient

    Gradient (%) = height gain ÷ horizontal distance × 100. A 5 % climb over 6,000 ft horizontally gains 300 ft.

  4. Feet per nautical mile

    ft per NM = rate of climb ÷ (groundspeed ÷ 60). 500 ft/min at 75 kt = 400 ft per NM.

  5. Obstacle check

    Height at the obstacle = height gained over the distance from lift-off. Compare with the obstacle height plus a margin.

  6. Vx for obstacles

    Vx gives the most height per distance (PHAK) – the best chance of clearing a close obstacle.

The lesson, step by step

45 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minMarked by Classfern
Teaching and hands-on task14 minNot assessed, self-checked
Worked examples and guided practice9 minMarked by Classfern
Independent practice (three levels)13 minMarked by Classfern
Exit ticket and talk question5 minMarked by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all marked instantly.

More practice

More Flight Performance and Planning lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the CAA, any flying school, testing agency or exam board.