Radio failure procedures: 7600 and light signals – Private Pilot Theory aviation lesson
Lesson 114 of 228 in the Private Pilot Theory course (ages 16+)
UK version. UK spelling and units (hPa, metres, litres) and the UK CAA. · US version
What happens if the radio stops working? Learn the radio-failure transponder code and how a control tower can 'talk' with coloured lights.
- Time
- 35 minutes + 10 min homework
- Course
- Private Pilot Theory (ages 16+)
- You need
- Paper, a pencil and this page
- Marked
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an approved training organisation, and nothing here counts towards a pilot licence or replaces a CAA-approved course and the CAA’s own exams. Rules and values on this page are given as of November 2026. Always check the current official source (the UK CAA) before relying on them.
How to use this lesson
This is adult-level theory (16+). It is explanation for understanding, not training. Every answer is marked straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “Why is it useful for a tower to have a way of signalling that does not need a radio at all?”
- Later: the homework, then the practice test.
Watch out for
- Mixing up 7600 and 7700. 7600 = radio failure; 7700 = emergency.
- Forgetting that light meanings depend on air or ground. Learn each colour twice: in flight and on the ground.
- Thinking a radio failure always means an emergency. A radio failure on its own is handled calmly with set procedures.
Hands-on: Make a set of coloured cards (red, green, white). One person holds up a card, steady or flashing (waving), and says 'air' or 'ground'. The other says what it means. Score a point for each correct answer.
What you will learn
- I can give the transponder code for radio failure.
- I can explain what a VFR pilot is expected to do after a radio failure, in outline.
- I can interpret the main aerodrome light signals.
- I can explain how a controller can tell if an aircraft is receiving but not transmitting.
Key words
- 7600
- The transponder code that shows radio (communications) failure.
- light gun
- A lamp in the control tower that shines coloured signals at an aircraft.
- steady green
- Light signal: in the air, cleared to land; on the ground, cleared for take-off.
- steady red
- Light signal: in the air, give way and keep circling; on the ground, stop.
The big ideas
Radios can fail – a flat battery, a broken switch or a wiring fault. Pilots are taught what to expect, and the system has back-ups. This lesson explains them for understanding only. CAP 413 says a pilot with a radio failure is expected to select the appropriate transponder code; the UK Skyway Code lists 7600 as the radio-failure code. If the controller suspects the aircraft can hear but not transmit, they can ask the pilot to change code or 'squawk ident' to confirm messages are received.
At an aerodrome, the tower can use light signals. The Skyway Code lists them: steady green in flight means cleared to land, and on the ground cleared for take-off; steady red in flight means give way to other aircraft and continue circling, and on the ground stop; red flashes mean do not land (in flight) or move clear of the landing area (on the ground); green flashes mean return for landing (in flight) or cleared to taxi (on the ground); white flashes mean land and proceed to the apron (in flight) or return to the starting point (on the ground).
Read-through: the teaching steps
Why radios fail
Electrical faults, flat batteries, broken switches or a jammed microphone. The pilot may lose transmit, receive, or both.
The code
Select the radio-failure code 7600 (Skyway Code), with altitude reporting, so radar screens show the problem.
What the pilot does (VFR)
Pilots are taught to keep flying safely in good weather and follow the published radio-failure procedures in the UK AIP. A controller may check whether messages are being received by asking for an ident or a code change.
Light signals in the air
Steady green: cleared to land. Steady red: give way, continue circling. Red flashes: do not land. Green flashes: return for landing. White flashes: land and proceed to apron.
Light signals on the ground
Steady green: cleared for take-off. Steady red: stop. Red flashes: move clear of the landing area. Green flashes: cleared to taxi. White flashes: return to starting point.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Marked by Classfern |
| Teaching and hands-on task | 11 min | Not assessed, self-checked |
| Worked examples and guided practice | 7 min | Marked by Classfern |
| Independent practice (three levels) | 8 min | Marked by Classfern |
| Exit ticket and talk question | 5 min | Marked by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all marked instantly.
More practice
More Communications lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by the CAA, any flying school, testing agency or exam board.