▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Maths, Cookery, Programming and Art are open – explore →

Arrival and circuit/pattern calls – Private Pilot Theory aviation lesson

Lesson 112 of 228 in the Private Pilot Theory course (ages 16+)

UK version. UK spelling and units (hPa, metres, litres) and the UK CAA. · US version

Joining the circuit: learn which radio reports are made on the way in to land, and why each one helps other pilots know where you are.

Time
35 minutes + 10 min homework
Course
Private Pilot Theory (ages 16+)
You need
Paper, a pencil and this page
Marked
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an approved training organisation, and nothing here counts towards a pilot licence or replaces a CAA-approved course and the CAA’s own exams. Rules and values on this page are given as of November 2026. Always check the current official source (the UK CAA) before relying on them.

How to use this lesson

This is adult-level theory (16+). It is explanation for understanding, not training. Every answer is marked straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “How do position reports help pilots who cannot see each other yet?”
  4. Later: the homework, then the practice test.

Watch out for

  • Saying 'the active runway'. Give the runway number so nobody has to guess.
  • Thinking reports are only for the controller. Other pilots listen too – that is how they find you.
  • Mixing up downwind and base. Downwind runs parallel to the runway; base is the short leg across before final.

Hands-on: Make a rectangle of string or tape on the floor with a 'runway' on one side. Walk a toy plane round it and say each leg's name aloud. Then add the radio call for each leg.

What you will learn

  • I can name the legs of the circuit and the calls made on them.
  • I can explain why position reports help other pilots.
  • I can explain why the ATIS letter is quoted when calling in.
  • I can describe an overhead join in outline.

Key words

circuit
The standard rectangular path round an aerodrome for take-off and landing.
downwind
The leg flown parallel to the runway, opposite to the landing direction.
base
The short leg at right angles to the runway before turning onto final.
final
The last straight leg lined up with the runway.

The big ideas

Arriving at an aerodrome, pilots tell others where they are, so everyone can fit together safely. This lesson describes it for understanding, not as flight instruction. The UK Skyway Code advises making contact about 10 minutes before arrival, using the full call sign, and reading back the runway, circuit direction and QNH. If there is an ATIS, its letter is quoted.

The circuit has legs: upwind, crosswind, downwind, base and final. Circuits turn left unless the aerodrome says otherwise. CAP 413 shows a report on the downwind leg, and a 'long final' report between 8 and 4 miles on a straight-in approach. A common way in is the standard overhead join, which CAP 413 describes as starting at 2,000 ft above aerodrome elevation.

At an aerodrome with no radio service, the Skyway Code says pilots make blind calls on the aerodrome frequency, or on SafetyCom (135.480 MHz) where none is assigned.

Read-through: the teaching steps

  1. Call in early

    Skyway Code: about 10 minutes before arrival, full call sign, quote the ATIS letter if there is one.

  2. The legs

    Upwind → crosswind → downwind → base → final. Left-hand unless the aerodrome says otherwise.

    0927ApronTaxiwayCircuit (downwind leg)Final approach and departure along the runway
    Runway numbers are the runway's magnetic direction divided by 10. The circuit is flown around the runway.
  3. Position reports

    Reports such as 'downwind' and 'final' let others picture where you are. 'Long final' is used between 8 and 4 miles on a straight-in.

  4. Joining

    CAP 413's standard overhead join starts at 2,000 ft above aerodrome elevation. The Skyway Code advises staying 1,000 ft above circuit height when joining unless the aerodrome says otherwise.

  5. No radio service

    Blind calls on the aerodrome frequency, or SafetyCom 135.480 MHz where none is assigned.

The lesson, step by step

35 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minMarked by Classfern
Teaching and hands-on task11 minNot assessed, self-checked
Worked examples and guided practice7 minMarked by Classfern
Independent practice (three levels)8 minMarked by Classfern
Exit ticket and talk question5 minMarked by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all marked instantly.

Fly it yourself

Try this in our own First Flight trainer, with Mr Wilbur helping. It runs in your browser and is free.

Open First Flight

This is a learning tool, not flight training.

More practice

More Communications lessons · Private Pilot Theory course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the CAA, any flying school, testing agency or exam board.