Performance-based navigation: RNAV and RNP – Navigation and Technology aviation lesson
Lesson 16 of 90 in the Navigation and Technology course (ages 14+)
UK version. UK spelling and units (hPa, metres, litres) and the UK CAA. · US version
Aircraft once had to zig-zag from one radio beacon to the next. Today many fly any path they like, as long as they can prove how accurately they are flying it. Find out what RNAV and RNP mean, what the numbers like 'RNP 1' stand for, and why this saves time, fuel and noise.
- Time
- 40 minutes + 10 min homework
- Course
- Navigation and Technology (ages 14+)
- You need
- Paper, a pencil and this page
- Marked
- Instantly, with explanations
Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an approved training organisation, and nothing here counts towards a pilot licence or replaces a CAA-approved course and the CAA’s own exams.
How to use this lesson
Sources: FAA AIM chapter 1 section 2 (Performance-Based Navigation and Area Navigation); for the UK, CAA CAP 1781 on RNAV substitution and beacon rationalisation. The percentage work is good practice for GCSE or high-school maths. Every answer is marked straight away with a worked explanation.
- Read what you will learn and the big ideas.
- Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
- Finish with the exit ticket and the talk question: “PBN lets designers put routes almost anywhere – including over places that never had aircraft before, or concentrating traffic over the same streets. How should the quiet of people on the ground be balanced with saving fuel?”
- Later: the homework, then the practice test.
Watch out for
- Thinking RNAV means 'GPS only'. RNAV can use GPS, ground beacons (such as DME) or inertial sensors. It describes the method, not one piece of equipment.
- Thinking the RNP number is a speed or a height. It is a lateral accuracy in nautical miles, held for at least 95 % of the flight time.
- Thinking RNAV and RNP are identical. RNP adds on-board monitoring and alerting; plain RNAV does not have to warn the crew.
Hands-on: On a map of your area, mark four 'beacons' (for example a church, a school, a park and a shop). Draw a route from home to a friend's house that must go from beacon to beacon. Then draw a straight 'RNAV' route with two waypoints of your own. Measure both routes with string. How much shorter is the RNAV route?
What you will learn
- I can explain area navigation (RNAV) and how it differs from flying beacon to beacon.
- I can explain what RNP adds to RNAV: on-board monitoring and alerting.
- I can interpret a navigation specification such as RNP 1 (1 NM, 95 % of the time).
- I can describe fly-by and fly-over waypoints and the benefits of PBN.
Key words
- RNAV (area navigation)
- Navigation that lets an aircraft fly any chosen path between points, not just straight towards or away from beacons.
- RNP (required navigation performance)
- RNAV plus on-board monitoring that warns the crew if the required accuracy is not being met.
- PBN (performance-based navigation)
- A way of designing routes by stating how accurately aircraft must navigate, rather than which equipment they must carry.
- waypoint
- A named point defined by its position (latitude and longitude), not by a beacon on the ground.
- navigation specification
- The set of accuracy and equipment requirements for a route or procedure, such as RNAV 1 or RNP APCH.
The big ideas
For most of the 20th century, airways ran from one radio beacon to the next. An aircraft flew towards a beacon, turned, and flew to the next one, so routes zig-zagged across the map. Area navigation – RNAV – changed that. The FAA's Aeronautical Information Manual (AIM) describes RNAV as a method that permits aircraft to fly 'on any desired flight path' within the coverage of navigation aids or the limits of self-contained systems. Routes are built from waypoints: named points defined by latitude and longitude rather than by a beacon.
Performance-based navigation (PBN) goes one step further. Instead of saying which box of equipment an aircraft must carry, a route states how accurately it must be flown. The AIM explains that in 'RNAV 1' or 'RNP 1' the number is the lateral accuracy in nautical miles that must be achieved at least 95 % of the flight time. RNP adds on-board performance monitoring and alerting: the aircraft checks its own accuracy and tells the crew if it is not good enough.
The AIM lists the benefits as time and fuel savings, less need for controllers to give radar headings, fewer radio transmissions and more efficient use of airspace. In the UK, CAA guidance (CAP 1781) describes PBN as a key enabler of airspace modernisation, and some older ground beacons are being retired as a result. This lesson explains the ideas for understanding only.
Read-through: the teaching steps
Beacon to beacon
Old airways joined ground beacons such as VORs. Every route had to pass over or along a line from a beacon, as the drawing on the lesson page shows, so routes were often longer than a straight line.
A VOR radial is a magnetic bearing FROM the beacon. The 090 radial runs east from the beacon. RNAV: any path you like
An RNAV system works out the aircraft's position from satellites, ground beacons or inertial sensors. It can then guide the aircraft along a line between any two waypoints.
- Waypoints are just positions with names.
- Routes can be straighter and shorter.
- Approaches and departures can avoid towns or high ground.
What the number means
In RNAV 1 or RNP 1, the '1' means 1 nautical mile.
- The aircraft must stay within 1 NM of the intended track …
- … for at least 95 % of the flight time.
Smaller numbers mean tighter accuracy: RNP 0.3 means within 0.3 NM.
RNP: knowing your own accuracy
RNP = RNAV + on-board performance monitoring and alerting.
The aircraft continually estimates how accurate its own position is. If that drops below what the route requires, it warns the crew. This self-checking is what allows tighter routes close to terrain or other traffic.
Different phases, different numbers
The AIM gives typical values:
- oceanic and remote areas – RNP 4 or RNP 10;
- en route – RNP 2 (RNAV 2 for T- and Q-routes in the US);
- arrivals and departures – RNP 1;
- final approach – about RNP 0.3.
Fly-by and fly-over
- Fly-by waypoint: the aircraft starts turning before it reaches the point, cutting the corner smoothly ('turn anticipation').
- Fly-over waypoint: the aircraft must pass over the point before turning.
Some procedures even include curved paths of fixed radius, called RF legs.
The lesson, step by step
| Part | Time | How it is checked |
|---|---|---|
| Starter: warm up | 4 min | Marked by Classfern |
| Teaching and hands-on task | 12 min | Not assessed, self-checked |
| Worked examples and guided practice | 8 min | Marked by Classfern |
| Independent practice (three levels) | 11 min | Marked by Classfern |
| Exit ticket and talk question | 5 min | Marked by Classfern, self-checked |
Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.
The lesson
It runs here on the page. No sign-up and no names – progress is kept only in this browser.
Homework
About 10 minutes: 6 questions and a one-line reflection, all marked instantly.
More practice
More Navigation and weather technology lessons · Navigation and Technology course · All aviation practice tests · Aviation Department
Sources and curriculum
Facts in this lesson were checked against:
Our lessons and questions are our own. They are not written or endorsed by the CAA, any flying school, testing agency or exam board.