▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Maths, Cookery, Programming and Art are open – explore →

Airport technology: ILS to GBAS, lighting and ground radar – Navigation and Technology aviation lesson

Lesson 54 of 90 in the Navigation and Technology course (ages 14+)

UK version. UK spelling and units (hPa, metres, litres) and the UK CAA. · US version

An airport is packed with technology that guides aircraft down to the runway and keeps them safe on the ground. Explore landing systems, the coded language of runway lights and the radar that watches every taxiing aircraft.

Time
40 minutes + 10 min homework
Course
Navigation and Technology (ages 14+)
You need
Paper, a pencil and this page
Marked
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an approved training organisation, and nothing here counts towards a pilot licence or replaces a CAA-approved course and the CAA’s own exams.

How to use this lesson

Sources: FAA Aeronautical Information Manual chapters 1 and 2 and the FAA ASDE-X page (as of November 2026). Links to mathematics (trigonometry, scale drawings) and physics (radio waves). Every answer is marked straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “GBAS relies on satellite signals, while ILS uses beams from the ground. Should airports keep both? Why?”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking ILS flies the aircraft by itself. ILS sends guidance beams; pilots or the autopilot follow them.
  • Thinking all runway lights are white. Colour codes show how much runway is left, where taxiways are and whether it is safe to enter.
  • Thinking controllers only need their eyes in the tower. In fog or at night, surface surveillance shows every aircraft and vehicle on the ground.

Hands-on: Draw a runway 30 cm long on paper, with 1 cm standing for 300 ft. Colour the centreline the way the FAA describes: white, then alternating red and white for the last 10 cm, with the final 3–4 cm all red. Add blue taxiway edges and green taxiway centrelines. Then explain your 'runway' to someone at home.

What you will learn

  • I can describe how an instrument landing system and GBAS guide aircraft to the runway.
  • I can explain what approach, centreline and touchdown zone lights tell pilots.
  • I can describe how surface surveillance helps controllers prevent runway incursions.
  • I can use simple geometry and distances to answer questions about approaches and lighting.

Key words

ILS
Instrument landing system – radio beams from the ground that guide an aircraft left–right (localiser) and up–down (glide slope) to the runway.
GBAS
Ground-based augmentation system – reference stations near the airport that correct satellite navigation errors and send an approach path by radio.
approach lighting system
Rows of lights leading up to the runway that help pilots change from flying by instruments to landing by sight.
runway incursion
When an aircraft, vehicle or person is wrongly on a runway being used for take-off or landing.
multilateration
Finding an aircraft's position by timing its transponder signal at several receivers in different places.

The big ideas

Landing an airliner in cloud depends on technology on the ground. The instrument landing system (ILS) has been the standard for decades. The FAA describes it as providing an approach path for exact alignment and descent to a runway: a localiser beam gives left–right guidance to the runway centreline, and a glide slope beam gives descent guidance, normally along a path 3 degrees above the horizontal. The most advanced ILS approaches, with special approval, allow landings in very poor visibility.

Satellite navigation adds a newer option. A ground-based augmentation system (GBAS) uses at least four reference receivers near the runway. Because their positions are known exactly, they can measure the errors in satellite signals and broadcast corrections, together with the approach path, by VHF radio to aircraft.

Lights do the rest. The FAA explains that approach lighting systems provide the basic means to change from instrument flight to visual flight for landing; for precision instrument runways they stretch 2,400 to 3,000 ft out from the runway. On the runway, colour-coded centreline and edge lights tell pilots how much runway is left. On the ground, surveillance systems such as the FAA's ASDE-X combine radar on the tower, multilateration sensors and ADS-B to show controllers every aircraft and vehicle on a map of the airport, and sound alarms if something may be about to enter an active runway.

Read-through: the teaching steps

  1. The ILS beams

    • Localiser: left–right guidance, lined up with the runway centreline
    • Glide slope: up–down guidance, normally along a 3° path

    In the cockpit, the beams drive needles or symbols that show whether the aircraft is left, right, high or low. The drawing on the lesson page shows the two beams.

    Localiser (seen from above)Glideslope about 3° (seen from the side)Runway
    The ILS: the localiser gives left/right guidance, the glideslope gives up/down guidance.
  2. GBAS: satellite landing guidance

    GBAS uses satellite navigation, corrected on the spot. At least four reference receivers at known positions near the runway work out how wrong the satellite signals are at that moment, and the system broadcasts corrections and the approach path by VHF radio. The aircraft's own receiver then follows a very accurate path to the runway.

  3. Approach and threshold lights

    Approach lighting systems stretch out from the end of the runway – 2,400 to 3,000 ft for precision instrument runways – so pilots can see a line of lights leading to the runway before they can see the runway itself. Runway end lights show green to aircraft landing and red to aircraft departing towards them.

  4. Reading the runway lights

    The FAA describes a colour code:

    • Centreline lights are white until the last 3,000 ft
    • Then alternate red and white for 2,000 ft
    • The last 1,000 ft are all red
    • Touchdown zone lights: steady white bars from 100 ft past the threshold
    • Edge lights white, turning yellow on the last 2,000 ft of instrument runways
    • Taxiway edge lights blue, taxiway centreline lights green
  5. Guarding the runway

    Runway incursions are a serious risk. Flashing yellow runway guard lights mark where taxiways meet runways. In low visibility, red stop bars across the taxiway show whether an aircraft may enter; the FAA says pilots should never cross a red stop bar, even if they have been cleared.

  6. Watching the ground

    Controllers can't always see the whole airfield, especially in fog or at night. The FAA's ASDE-X fuses surface radar on top of the tower, multilateration sensors around the airport and ADS-B into one colour display. Each aircraft and vehicle appears as an icon on the airport map, and the system gives visual and spoken alarms about possible runway incursions.

The lesson, step by step

40 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minMarked by Classfern
Teaching and hands-on task12 minNot assessed, self-checked
Worked examples and guided practice8 minMarked by Classfern
Independent practice (three levels)11 minMarked by Classfern
Exit ticket and talk question5 minMarked by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all marked instantly.

More practice

More Aircraft technology lessons · Navigation and Technology course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the CAA, any flying school, testing agency or exam board.