▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Maths, Cookery, Programming and Art are open – explore →

ADS-B: In and Out, 1090ES and UAT (US), UK adoption – Navigation and Technology aviation lesson

Lesson 21 of 90 in the Navigation and Technology course (ages 14+)

UK version. UK spelling and units (hPa, metres, litres) and the UK CAA. · US version

Instead of waiting for radar to find it, an aircraft with ADS-B tells everyone where it is, once every second. Find out what 'Out' and 'In' mean, why the US uses two different frequencies, and how the UK has taken a different path from the US.

Time
45 minutes + 10 min homework
Course
Navigation and Technology (ages 14+)
You need
Paper, a pencil and this page
Marked
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an approved training organisation, and nothing here counts towards a pilot licence or replaces a CAA-approved course and the CAA’s own exams. Rules and values on this page are given as of November 2026. Always check the current official source (the UK CAA) before relying on them.

How to use this lesson

Sources: FAA AIM chapter 4 section 5; FAA 'Equip ADS-B' frequently asked questions; UK CAA electronic conspicuity devices page (2026). Requirements are given as published and may change – check the regulator for the current position. Every answer is marked straight away with a worked explanation.

  1. Read what you will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “Should every aircraft, including gliders and microlights, have to broadcast its position? Think about safety, cost, weight and privacy.”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking ADS-B Out lets you see other aircraft. Out transmits your position. To see others in the cockpit you need ADS-B In.
  • Thinking UAT can be used anywhere. UAT is US-only and only below 18,000 ft. 1090ES is the international link.
  • Thinking ADS-B replaced radar completely. Radar is still used, partly as an independent check because ADS-B depends on GPS.

Hands-on: Play 'broadcast' in a room. Everyone walks slowly around; every 5 seconds, each person calls out their position using a grid you have chalked or taped on the floor (for example 'C4'). One person with eyes closed tries to keep track of everyone from the calls alone. Then try again with one person giving wrong positions – what goes wrong?

What you will learn

  • I can explain what ADS-B is and what 'automatic', 'dependent' and 'broadcast' mean.
  • I can explain the difference between ADS-B Out and ADS-B In.
  • I can describe the two US links, 1090ES and UAT, and where each can be used.
  • I can compare the US requirement with the UK's approach to electronic conspicuity.

Key words

ADS-B
Automatic Dependent Surveillance–Broadcast: an aircraft works out its own position (usually by GPS) and broadcasts it, with other data, about once a second.
ADS-B Out
Transmitting your own aircraft's ADS-B information.
ADS-B In
Receiving other aircraft's ADS-B information (and, in the US, ground broadcasts) and showing it in the cockpit.
1090ES
'1090 MHz extended squitter' – ADS-B sent on the same frequency used by transponder replies.
UAT
Universal Access Transceiver – a US-only ADS-B link on 978 MHz, for aircraft below 18,000 ft.

The big ideas

Radar finds aircraft by bouncing signals off them or asking their transponders to reply. ADS-B turns this round. The name explains it: Automatic (it happens without anyone pressing anything), Dependent (it depends on the aircraft's own navigation, usually GPS) and Broadcast (it is sent out to anyone listening). The FAA's Aeronautical Information Manual (AIM) says aircraft broadcast their GNSS position about once per second. An FAA guide lists what goes out: position, velocity, pressure and GPS altitude, a unique 24-bit aircraft address, a flight identification and the transponder code.

Transmitting is called ADS-B Out; receiving other aircraft's broadcasts is ADS-B In. In the United States, ADS-B Out has been required in most controlled airspace since 1 January 2020, using one of two links: 1090ES on 1090 MHz (the international standard, needed at the highest levels) or UAT on 978 MHz, a US-only system for aircraft below 18,000 ft.

The UK has taken a different path. The CAA uses the umbrella term 'electronic conspicuity' for technology that helps aircraft 'detect and be detected', alongside the basic rule of see and avoid. It sets a standard (CAP 1391) for lightweight ADS-B devices on 1090 MHz. As of the CAA's page in 2026, electronic conspicuity was not mandatory for UK general aviation, and the CAA was consulting on a possible UK-wide requirement, with the consultation closing on 22 September 2026. Check the CAA for the outcome. This lesson explains the technology for understanding.

Read-through: the teaching steps

  1. Automatic, dependent, broadcast

    • Automatic – no one has to ask; it just transmits.
    • Dependent – the position comes from the aircraft's own navigation (usually GPS).
    • Broadcast – sent to everyone in range: ground stations and other aircraft.

    About once every second.

  2. What goes out

    An FAA guide lists:

    • position and velocity;
    • pressure altitude and GPS altitude;
    • a unique 24-bit aircraft address;
    • flight identification;
    • the transponder (squawk) code.
  3. Out and In

    • ADS-B Out: your aircraft tells others where it is.
    • ADS-B In: your aircraft hears others and can show them on a display.

    The US rule requires Out in certain airspace; In is optional but useful.

  4. Two links in the US

    • 1090ES (1090 MHz) – shares the transponder reply frequency, used worldwide, required in Class A (the highest levels).
    • UAT (978 MHz) – US only, allowed below 18,000 ft. It also carries ground broadcasts of weather and information (FIS-B).

    Ground stations relay between the two (ADS-R) so everyone can see everyone.

  5. Why depend on GPS?

    Because ADS-B uses the aircraft's own GPS position, it is very precise and updates quickly – but it is only as good as that position. Jamming or spoofing GPS can affect ADS-B, which is why radar is still kept as an independent check.

  6. The UK approach

    The UK has not (as of 2026) made ADS-B compulsory for light aircraft. Instead:

    • the CAA promotes 'electronic conspicuity' – a family of devices that help aircraft detect and be detected;
    • CAP 1391 sets a standard for lightweight 1090 MHz ADS-B devices;
    • a consultation on a possible UK-wide requirement closed on 22 September 2026.

    There is no UAT in the UK – only 1090 MHz.

Try it: read the radar

A made-up traffic screen like the ones controllers use. Read the labels and answer the questions.

Try the real thing: OpenSky Network live air traffic map (run by a non-profit) (opens in a new tab).

The lesson, step by step

45 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minMarked by Classfern
Teaching and hands-on task14 minNot assessed, self-checked
Worked examples and guided practice9 minMarked by Classfern
Independent practice (three levels)13 minMarked by Classfern
Exit ticket and talk question5 minMarked by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all marked instantly.

More practice

More Air traffic & surveillance lessons · Navigation and Technology course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the CAA, any flying school, testing agency or exam board.