▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Maths, Cookery, Programming and Art are open – explore →

The pitot-static system – Ground School Basics aviation lesson

Lesson 31 of 90 in the Ground School Basics course (ages 11–16)

UK version. UK spelling and units (hPa, metres, litres) and the UK CAA. · US version

See how two small holes – the pitot tube and the static port – feed three cockpit instruments, and what happens when one gets blocked.

Time
40 minutes + 10 min homework
Course
Ground School Basics (ages 11–16)
You need
Paper, a pencil and this page
Marked
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an approved training organisation, and nothing here counts towards a pilot licence or replaces a CAA-approved course and the CAA’s own exams.

For parents: how to use this lesson

This links GCSE / high-school pressure work to instruments. Keep any car-window activity safe and with the window only slightly open. Every answer is marked straight away with a worked explanation.

  1. Read what your child will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “Why do you think aircraft designers put the static port on the side of the fuselage rather than facing forwards?”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking the altimeter uses the pitot tube. The altimeter and VSI use static pressure only; only the ASI uses the pitot tube.
  • Thinking a blocked pitot tube always freezes the ASI. With the drain open the ASI drops to zero; with pitot and drain blocked it acts like an altimeter.
  • Thinking the VSI shows instant changes. It lags by about 6–9 seconds.

Hands-on: Hold a drinking straw facing into the breeze from a fan or out of a car window (with an adult) with your finger over the far end – feel the push (total pressure). Turn the straw sideways – the push mostly goes. Draw a pitot tube and a static port and label which pressure each senses.

What your child will learn

  • I can name the three instruments fed by the pitot-static system.
  • I can explain the difference between total, static and dynamic pressure.
  • I can explain how the airspeed indicator works out airspeed.
  • I can describe what happens to the instruments when the pitot tube or static port is blocked.

Key words

pitot tube
A forward-facing tube that measures total pressure (static plus dynamic) from the oncoming air.
static port
A small flush hole on the side of the aircraft that measures the still-air (static) pressure.
airspeed indicator (ASI)
Shows airspeed from the difference between pitot (total) and static pressure.
altimeter
Shows height using static pressure only; it is an aneroid barometer.
vertical speed indicator (VSI)
Shows rate of climb or descent in feet per minute using static pressure only.

The big ideas

The FAA's Pilot's Handbook of Aeronautical Knowledge explains that the pitot-static system feeds three instruments: the airspeed indicator (ASI), the altimeter and the vertical speed indicator (VSI). The pitot tube faces forwards and measures total pressure – the static pressure of the air plus the extra dynamic pressure from the aircraft's motion. The static port measures static pressure only.

The ASI compares the two: it subtracts static pressure from total pressure, leaving dynamic pressure, which depends on speed. The altimeter and VSI use static pressure only. The altimeter contains sealed aneroid wafers that expand as pressure falls with height; the VSI measures how fast static pressure is changing, using a diaphragm and a calibrated leak, and lags by about 6–9 seconds.

Blockages cause misleading readings. If the pitot tube is blocked but its drain hole is open, the ASI drops to zero. If the static port is blocked, the altimeter freezes, the VSI shows zero, and the ASI reads wrongly. That is why these instruments are cross-checked with each other.

Read-through: the teaching steps

  1. Two kinds of pressure

    Static pressure is the pressure of the still air around the aircraft. Dynamic pressure is the extra pressure from moving through the air. Total pressure = static + dynamic.

  2. Pitot and static

    The pitot tube faces into the airflow and senses total pressure. The static port sits flush on the side, away from the direct airflow, and senses static pressure only.

    AirspeedindicatorAttitudeindicatorAltimeterTurncoordinatorHeadingindicatorVertical speedindicator
    The “six-pack”: the six basic flight instruments in their usual layout.
  3. Airspeed indicator

    The ASI is fed by both: total pressure inside a diaphragm, static pressure around it. The difference is the dynamic pressure, so the needle shows airspeed.

  4. Altimeter and VSI

    Both use static pressure only.

    • Altimeter: sealed aneroid wafers expand as pressure falls, moving the needles to show height
    • VSI: compares static pressure now with a moment ago through a calibrated leak, showing feet per minute, with a lag of about 6–9 seconds
  5. Blocked pitot tube

    With the drain hole open, pressure leaks away and the ASI drops to zero. If both pitot and drain are blocked, the trapped pressure makes the ASI behave like an altimeter: it changes with height, not speed.

  6. Blocked static port

    The altimeter freezes at the height where the blockage happened and the VSI stays at zero. The ASI reads low above that height and high below it. The handbook also describes an alternate static source inside the cabin, where the pressure is slightly lower, so the altimeter and ASI read slightly high.

Try it: the cockpit instruments

Move the controls and watch the instruments, then try reading them.

Try the real thing: FAA Pilot’s Handbook of Aeronautical Knowledge, chapter 8: flight instruments (free PDF) (opens in a new tab). Ask a grown-up before visiting other websites.

The lesson, step by step

40 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minMarked by Classfern
Teaching and hands-on task12 minNot assessed, self-checked
Worked examples and guided practice8 minMarked by Classfern
Independent practice (three levels)11 minMarked by Classfern
Exit ticket and talk question5 minMarked by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all marked instantly.

More practice

More Instruments lessons · Ground School Basics course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the CAA, any flying school, testing agency or exam board.