▶ TrainingGet Pro
All tools & lessonsAll toolsAllGet the appApp
Learning departments Music, Maths, Cookery, Programming and Art are open – explore →

Secondary controls: flaps, slats, spoilers and trim – Ground School Basics aviation lesson

Lesson 13 of 90 in the Ground School Basics course (ages 11–16)

UK version. UK spelling and units (hPa, metres, litres) and the UK CAA. · US version

Beyond the ailerons, elevator and rudder, wings and tails carry extra devices that change lift and drag or ease the load on the controls. Learn what flaps, slats, spoilers and trim tabs do and why.

Time
45 minutes + 10 min homework
Course
Ground School Basics (ages 11–16)
You need
Paper, a pencil and this page
Marked
Instantly, with explanations

Education and interest only. Classfern teaches aviation as a school subject. It is not flight training, not an approved training organisation, and nothing here counts towards a pilot licence or replaces a CAA-approved course and the CAA’s own exams.

For parents: how to use this lesson

This is theory for understanding only. The flap example uses the lift equation from the earlier lesson on L = ½ ρ V² S CL. Every answer is marked straight away with a worked explanation.

  1. Read what your child will learn and the big ideas.
  2. Press Start the lesson below for the teaching, worked examples and practice (Getting started, On track or Challenge).
  3. Finish with the exit ticket and the talk question: “Watch a large airliner's wing on a video of a landing. What devices can you spot moving, and what do you think each one is doing?”
  4. Later: the homework, then the practice test.

Watch out for

  • Thinking flaps only add lift. Flaps add drag too. That extra drag is useful on the approach to land.
  • Thinking spoilers are the same as flaps. Flaps increase lift; spoilers decrease lift. Both add drag.
  • Thinking a trim tab moves the same way as its control surface. It moves the opposite way. The airflow on the tab pushes the surface into position.

Hands-on: Make two identical paper aeroplanes. On one, fold the back 1 cm of each wing slightly downwards to make 'flaps'. Throw both gently from the same height and compare how fast and how far they glide.

What your child will learn

  • I can explain how flaps increase lift and drag and why that helps at low speed.
  • I can describe plain, split, slotted and Fowler flaps.
  • I can explain how slats and slots lower the stall speed.
  • I can explain what spoilers do.
  • I can explain how a trim tab works and why it moves opposite to its control surface.

Key words

flap
A hinged or sliding section on the trailing edge of the wing that increases camber (and sometimes area), giving more lift and more drag.
slat
A movable section on the wing's leading edge that opens a slot so the wing can reach a higher angle of attack before stalling.
spoiler
A panel on top of the wing that rises to 'spoil' the airflow, reducing lift and increasing drag.
trim tab
A small hinged tab on a control surface that holds the surface in position so the pilot does not have to keep pushing or pulling.
Fowler flap
A flap that slides backwards and down, increasing both wing area and camber.

The big ideas

The primary controls – ailerons, elevator and rudder – rotate the aeroplane. The secondary controls change how the wing behaves or make the primary controls easier to hold.

Flaps on the trailing edge of the wing increase its camber, and some types also increase its area. Using the lift equation, a bigger lift coefficient and area mean the wing can make the same lift at a lower speed, so the aeroplane can approach and land more slowly. Flaps also add drag, which helps an aeroplane descend steeply without speeding up. There are several kinds: plain, split, slotted (the most popular) and Fowler, which slides back as well as down.

On the leading edge, slats, fixed slots and cuffs help the airflow stay attached at high angles of attack, which lowers the stall speed. Spoilers on top of the wing do the opposite of flaps: they reduce lift and increase drag, helping large aeroplanes descend and slow down, and they can also be used for roll control. Finally, trim tabs are small surfaces on the back of the elevator, rudder or ailerons. They move opposite to the surface and hold it in place, so the pilot does not have to keep a steady force on the controls.

Read-through: the teaching steps

  1. Flaps: more lift, more drag

    Lowering flaps increases camber, so the wing's lift coefficient rises. The same lift can be made at a lower speed, and extra drag lets the aeroplane descend more steeply without gaining speed. Find the flaps on the drawing on the lesson page.

    Aileron (roll)Aileron (roll)Elevator (pitch)Rudder on fin (yaw)
    Ailerons roll the aircraft, the elevator pitches it and the rudder yaws it.
  2. Four kinds of flap

    • Plain – the back of the wing hinges down; more camber and quite a lot of drag
    • Split – only the lower surface hinges down
    • Slotted – a gap lets fast air from below flow over the flap, keeping the flow attached; the most popular type
    • Fowler – slides backwards and then down, adding both area and camber
  3. Slats, slots and cuffs

    Leading-edge devices help air flow smoothly over the top of the wing at high angles of attack. The wing can reach a higher angle before stalling, which lowers the stall speed.

  4. Spoilers

    Spoilers are panels on top of the wing that rise into the airflow. They reduce lift and add drag – useful for descending and slowing down. On some aircraft spoilers are also used for roll control, and the handbook gives the elimination of adverse yaw as an advantage of this.

  5. Trim tabs

    A trim tab is a small surface on the trailing edge of a control surface. It moves opposite to the surface: tab up pushes the surface down. The airflow on the tab holds the surface in place so the pilot does not need a constant force. Some aircraft trim by moving the whole tailplane with a screw jack instead.

The lesson, step by step

45 minutes in 5 parts
PartTimeHow it is checked
Starter: warm up4 minMarked by Classfern
Teaching and hands-on task14 minNot assessed, self-checked
Worked examples and guided practice9 minMarked by Classfern
Independent practice (three levels)13 minMarked by Classfern
Exit ticket and talk question5 minMarked by Classfern, self-checked

Make my lesson plan Opens this lesson in the free Lesson Plan Maker, filled in and ready to change, print or save.

The lesson

It runs here on the page. No sign-up and no names – progress is kept only in this browser.

Homework

About 10 minutes: 6 questions and a one-line reflection, all marked instantly.

More practice

More Physics of flight lessons · Ground School Basics course · All aviation practice tests · Aviation Department

Sources and curriculum

Facts in this lesson were checked against:

Our lessons and questions are our own. They are not written or endorsed by the CAA, any flying school, testing agency or exam board.